User Manual - Audio Authority
Contents
1. all indicators on the Hub will return to normal operation 1 on 1 systems may be upgraded by temporarily connecting a Hub If you have questions or require assistance with this product in areas not covered by this manual please contact Audio Authority using the information below Audio DAuthority 2048 Mercer Road Lexington Kentucky 40511 1071 USA Phone 859 233 4599 Fax 859 233 4510 Customer Toll Free USA amp Canada 800 322 8346 www audioauthority com support audioauthority com 752 489 Rev 201408072. is disabled inactive Counter Stations see only the wideview camera if installed Adjustment for level of background audio rejected by Counter Station microphone 0 no rejection The period between disengagement of blower and microphone audio un mute Adjusts in 5 second increments for up to 3 seconds of delay This menu allows the firmware of system components to be upgraded Inbound handset volume level adjustment Outbound handset volume level adjustment Enables push to talk operation Inbound volume level adjustment This menu enables lane selection keys to be redefined in any configuration desired First select the lane number to be assigned using the VOLUME keys Then touch the key to be assigned to that lane If the desired key is already assigned touch it twice For 20 lane systems use Page Mode Page Mode allows the user to flip between two pages of keys The first page contains lanes 1 10 the second 11 20 To enter or exit Page Mode touch the HOLD key while in KEY ASSIGNMENT OFF Idle Lane Stations display their own camera output ON Idle Lane Stations DO NOT display their own camera output Enables one Counter Station to monitor conversations conducted on all other Counter Stations Outbound volume level adjustment 6 OPEN LOOP GAIN PGM AUDIO ABATE PHARMACY SETTINGS POWER SAVE DELAY READ FROM MEM CARD RELAY OPERATION RINGTONE OVERRIDE SINGLE LANE SUPE
3. that it is installed correctly All rights are reserved No parts of this manual may be reproduced or transmitted by any form or means electronic or mechanical including photocopying recording or by any information storage or retrieval system without the written consent of the publisher Audio Authority reserves the right to revise any of its hardware and software following its policy to modify and or improve its products where necessary or desirable Audio Authority and the Double A Symbol are registered trademarks of Audio Authority Corp Copyright June 2014 All third party trademarks and copyrights are recognized See www audioauthority com page service_policy for full warranty disclosure 1500 SETUP MENU MAP WITH DEFAULT VALUES Firmware Version 4 07 May 31 2013 See 1533 or 1580 manuals for system menu maps Root Menu 1 System Parameters 2 Lane Parameters 3 Teller Parameters 4 Set Defaults 5 Memory Card 6 Exit First Menu Subset Second Menu Subset 1 Blower Motor Delay 2 Power Save Delay 3 Supervisor Teller 4 Lane Mirror Disable 5 Traffic Sensor Tone 6 Background Threshold 7 Allow Video Scroll 8 Master Teller 1 Single Lane 1 Inbound Volume Level 2 Auto Select Lane 2 Outbound Volume Level 3 Group of Lanes 3 Open Loop Gain 4 All Lanes 4 Handset Mic Level 5 Cancel 5 Handset Speaker Level 6 Ringtone Override 7 Half Duplex Only 8 Program Audio Abate 9 Relay Opera
4. Lane Station Ringtone Override setting System settings are saved to Hub memory card FIRMWARE UPGRADE INSTRUCTIONS These instructions are applicable to Series 1500 Intercom systems with v4 0 or higher firmware If your system is not SD card compatible or has v1 9 or earlier firmware call Audio Authority technical support Download the latest firmware version from www audioauthority com page series1500firmware follow the instructions to copy the necessary files onto an SD card Note Older Series 1500 equipment with firmware prior to version 1 5 may not be upgraded to version 4 07 using older Hubs To upgrade to version 4 07 these systems must have a new 1509SD Hub or a new 1517SD System card This upgrade may take several minutes The system cannot be used during this time so plan for adequate down time to complete and verify the upgrade e Insert the SD memory card into the Hub card slot 1509SD or 1517SD Connect a 1550A Installer Setup Tool to the underside of a Model 1500A Counter Station that has firmware v4 0 or higher Press Setup for 2 seconds e Press Key 5 1st button on second row e Press Key 4 last button on top row e Press the Mirror key e Press the Setup key twice After a successful upgrade Firmware upgrade complete is displayed on the 1550A screen The menu on the 1550A now shows several new selection options that apply only to the new 1500A 1500AH and 1533 Once the upgrade is complete
5. Model 1550A ole O lt 2 USING THE KEYPAD FOR NAVIGATION CAMERA Select next or previous Lane or Counter Station after selecting a single Lane or Counter Station 9 ahs o A NW VOLUME Move menu lv 3 SEE v gt cursor up and down 9 0 NU PRIVACY Go Back to SETUP Enter gt Re lt previous menu or Confirm o POWER USER TIPS e For faster menu navigation submenus may be selected by touching the key that is lit RED corresponding to the menu item see the numbered keys above For instance to enter BLOWER MOTOR DELAY press 1 and then 1 e To Exit Setup Mode from any menu hold SETUP for one second and follow the prompts on the 1550A e After adjusting a Lane Station or Counter Station you can use the CAMERA UP or CAMERA DOWN keys to select other stations for adjustment without leaving the submenu WARNINGS Read these instructions before using this product This product must be installed by qualified personnel Do not expose this unit to excessive heat e Clean the unit only with a dry or slightly dampened soft cloth LIABILITY STATEMENT Every effort has been made to ensure that this product is free of defects Audio Authority amp cannot be held liable for the use of this hardware or any direct or indirect conseguential damages arising from its use It is the responsibility of the user of the hardware to check that it is suitable for his her requirements and
6. RVISOR TELLER SWAP CAMERA UP DOWN TRAFFIC SENSOR TONE WRITE TO MEM CARD Adjustment for adapting to different acoustic environments Lower this setting for Lane Station acoustical environments with too much audio feedback Increase this setting to hear more of the customer while operator is talking ON Program Audio heard ONLY when lane is on hold OFF Program Audio heard when lane is idle OR on hold See the Model 1533 Telephone Intercom Interface Manual for details If enabled the length of time the system must be idle before entering Power Save LCD sleep System settings are restored from Hub memory card Allows configuration of Lane Station relay contacts Model 1520 terminal block position 9 amp 10 The contacts can be set to close using the HOLD key or while the lane is selected See Operator Card 1 in the Series 1500 Intercom Systems manual for HOLD key operation details Press a key to select a unique ringtone for the selected Lane Station s 1 no override plays the ringtone set by each Counter Station All other keys represent unique ring tones which override any Counter Station settings Allows installer to configure lane audio settings without using live audio from the lane If enabled allows one Counter Station to monitor others Swaps functions of the camera up and down buttons Press a key to select a unique ringtone for all traffic sensor events O no ringtone 1 use
7. User Manual Model 1550A Intercom Setup Tool Audio JD Authority Series 1500 Intercom Systems 1500A CALIBRATION AND SETUP The Model 1550A is a programming tool that shows the menus and settings for Series 1500 and 1580 Intercom Systems The entire system can be calibrated from one Counter Station except for Model 1533 Connect the 1550A Setup Tool to the recessed RJ45 jack on the underside of any live Counter Station Upon connection the 1550A displays Series 1500 EQUIPMENT CALIBRATION PLATFORM e Hold the SETUP key on the Counter Station for one second to enter Setup Mode The 1550A displays the top level of the menu shown on page 4 To navigate the menus use the VOLUME UP and VOLUME DOWN keys to move the cursor e Use SETUP to enter a submenu or confirm a selection and PRIVACY to go back Any changes you make are recorded as you exit each menu When you exit Setup Mode you must choose to either save all changes and exit or exit without saving e If you need to re enter Setup Mode simply press SETUP for 1 second Model 1533 Intercom Telephone Interface reguires separate programming using the 1550A After setting up the intercom system connect the 1550A to each 1533 in the system and perform setup tasks as outlined in the 1533 manual RECESSED JACK ANGLED A F 1500A COUNTER STATION CAT 5E 6 UNDERSIDE Audio Authority Intercom Setup Tool
8. tion 10 Swap Camera Up Down 11 Suppress Video 1 This Teller 1 Key Assignment 2 Single Teller 2 Allow Hands Free 3 Group of Tellers 4 All Tellers 5 Cancel 1 Cancel 2 Financial Defaults N a DUN Pharmacy Defaults Cancel Write To Memory Card Read From Memory Card Firmware Upgrade Cancel Exit and Save Exit Without Saving Financial Default Value 3 0 seconds 90 seconds None Off Use Lane Ringtone 4 On None None Off Off Selection Activates Off Off On Pharmacy Default Value 3 0 seconds 90 seconds None Off Use Lane Ringtone 4 Off 1 None Off Off Selection Activates Off Off Off Not Available with 1 on 1 configurations Not available with 1509SD mini hub configurations Note See the 1533 or 1580 manual for definitions and setup instructions MENU SELECTIONS AUTO SELECT 1 LANE ALLOW HANDSFREE ALLOW VIDEO SCROLL BACKGRND THRESHOLD BLOWER MOTOR DELAY FIRMWARE UPGRADE HANDSET MIC LVL HANDSET SPKR LVL HALF DUPLEX ONLY INBOUND VOLUME LVL KEY ASSIGNMENT LANE MIRROR DISABLE MASTER TELLER OUTBOUND VOLUME LVL DEFINITIONS Allows installer to configure lane audio settings using live audio from the lane Useful for adjusting inbound and outbound audio levels Allow communication using speaker and gooseneck microphone Inactive Counter Stations view all available cameras in sequence when video scroll
Download Pdf Manuals
Related Search