USER MANUAL LED SPARKLER 151.570
Contents
1. 230V 50HZ Power Consumption 15 W Fuse 1A Fast Blow LED Type 1W X 3PCS 1Red 1Geen 1Blue Temperature 5 C 45C Humidity lt 45 C Ambient Temp Weight 2 8Kgs Meas 26 x 30 x 12 cm 14 Disposal Please disposal of the unserviceable device according to the current statutory requirements V08 07 02 qtxlight i2. 5 Caution to prevent Mortal Electrical Risk and Long Life Operation For your safety please kindly pay attention to all the warnings as listed below E Always plug in the power plug last and disconnect from the mains when the device is not in use or before cleaning a Do not install and operate the device in rain or extreme heat moisture or dust location Bi For indoor use only E Do not switch on immediately but wait until it reaches to room temperature like the device has been exposed to drastic temperature fluctuation E Do not shake the device and avoid brute force when installing or operating E Do not spread the smoke or bubble of effect machine directly to the device qtxlight 2 User Manual 151 570 Do not use the device during thunderstorms and please disconnect the power Do not use solvents or aggressive detergent to clean the device Use a soft and clean cloth Do not modification the device or the connected power cord without authorized Use appropriate safety rope for safety Do not stare to the light The symbol o m determines the minimum distance from lighted objects The minimum distance between light output and the illuminated surface must be more than 0 1meter 6 Connect with power supply The ground wire must be connected Use the plug to connect to the main power supply as following 7 Quick Trouble Shooting 7 1 if the unit not functional Check if mains power is on and the fuse is OK 7 2
3. if the unit is not react to music check the sensitivity control at rear of the device 8 Replacing Fuse Disconnect from the main power supply first then unscrew the fuse holder cover to reveal the fuse Replace the correct fuse rating as stated on lighting or user s guide Then replace the fuse holder cover 9 General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequency Usage and environment are contributing factors in determining frequency As a general rule fixtures should be cleaned at least twice a month Dust build up reduces light output performance and can cause overheating This can lead to reduced lamp life and increased mechanical wear Be sure to power off fixture before conducting maintenance Unplug fixture from power Use a vacuum or air compressor and a soft brush to remove dust collected on external vents and internal components Clean all glass with fixture is cold with a mild solution to the cloth or tissue and drag dirt and grime to the outside of the lens Gently polish optical surface until they free of haze and lint The cleaning of internal and external optical lenses and or mirrors must be carried out periodically to optimize light output Cleaning frequency depends on the environment in which the fixtures operates damp smoky or particularly dirty surrounding can cleaning fluid Always dry the parts carefully Clean the external optics at least every 20 days Clean
4. the internal optics at least every 30 60 days 10 Mounting instruction qtxlight i User Manual 151 570 The fixture may be mounted in any position provide there is adequate room for ventilation It is important never to obstruct the fan or vents pathway Mount the fixture using clamp Adjust angle of the fixture loosening both knobs and tilting the fixture After finding desired position retighten both knobs When selecting installation location take into consideration lamp replacement access and routine maintenance Safety cables must always be used Never mount in places where the fixture will be exposed to rain high humidity extreme temperature changer or restricted ventilation 11 Dip Switch Setting amp Function 11 12 1 2 3 4 5 6 7 8 9 10 Auto Color Changing 1 2 3 4 5 6 7 8 9 10 11 Auto Color Changing with Strobe 1 20Hz 1 2 3 4 5 6 7 8 9 10 Sound Activated with Auto Color Changing 12 Master Slave Setting Sound Activated Master Slave mode Master Dip switch 10 dip on Slave Dip switch 1 dip on Auto Master Slave model Master Dip switch as above table 9 Slave Dip switch 1 dip on 13 DMX Controlling 0 100 dimming 0 100 dimming 0 100 dimming all channel full on all channel full off Strobe Slow gt Fast 20Hz Sec Stop clock wise rotation fast gt slow Stop anti clockwise rotation slow gt fast qtxlight i User Manual 151 570 13 Technical Feature Voltage AC 90V 60HZ
5. qtxlight USER MANUAL LED SPARKLER 151 570 User Manual 151 570 151 570 LED Sparkler Indoor use onl Caution Please read this manual carefully before operating Damage caused by misuse is not covered by the warranty 1 General Introduction The light is designed to create special lighting effects for Family Party Disco Bar Night Club Ballroom and any other location 2 Features a LED Effect with DMX Control Lovely Moon Flower Beam Projection RGB Mixing color effect or monochrome effect Superior amp Bright 1W LED Clockwise amp anticlockwise whirling Multi controlling DMX Master Slave Auto and Sound Activated Strobe Effect 3 Package Contents Please check the contents to ensure that the content has been received in good condition Light x 1unit User s Guide x 1pcs If you find any accessory is missing or the lighting is arrive with any problem please contact with your local dealer at once Do not try to fix yourself or you will loss the warranty Please keep the Original package and invoice for any possible replacement or returned demand 4 Installation Every person involved with the installation operation and maintenance of this device shall be qualified and follow the instruction of this User s Guide When you connect the main power and switch on then the device will illuminate and change the light effect to music Please adjust the sensitivity control to match your music
Download Pdf Manuals
Related Search