Manual
Contents
1. deep 1 7 high 6 5 wide 2 7 pounds 19 rack adapter available Five years on defects in manufacturing Output device is not warranted against abuse2. DMX input Setting the address switch to 601 closes relay 1 Setting the address switch to 602 closes relay 2 Indicators Power Indicator The red power indicator should illuminate whenever power is applied If it fails to light first check that your outlet is good If the unit is receiving power the internal fuse may be blown To check the fuse unplug the unit remove the top cover The line fuse is a 1 2 Amp fast blow Signal Indicator The green signal indicator will illuminate when a DMX512 signal is received The indicator will flash when the unit is in test mode address switch settings of 600 696 Relay 1 Indicator The green relay 1 indicator will illuminate when the first relay is closed Specifications Input signal Input circuit Input connector 250 Kilobaud 0 2 volts minimum 12 volts maximum EIA 485 receiver with two 100 ohm PTC self resetting fuses four low capacitance transient suppression diodes Gold plated 5 pin male XLR Neutrik D 1 series 3 pin optional Input pass through Gold plated 5 pin female Neutrik D 1 series Power Input Output Connection Output Rating Color Size and weight Warranty All pins are wired through 120 volts 50 60 hertz 2 watts 240 Volt Optional 2 Gold Plated 3 pin male XLR Neutrik D 1 series pin 1 common pin 2 normally open pin 3 normally closed 5A 30VDC Top bottom and sides Silver hammer tone Front and back Black 6 5
3. DOUG FLEENOR DESIGN 805 481 9599 TWO CHANNEL DMX512 RELAY PACK model DMX2REL5A Description This DMX512 Relay Pack receives DMX512 and uses the dimmer levels to open or close dry contact relays The relay is closed when the level exceeds 60 The relay is opened when the level falls below 40 Connections Line Cord The line cord is fitted with a parallel blade with ground PBG plug Ifa different plug is required cut off the parallel blade connector and wire on the desired plug using the following color code Green Ground Black Hot White Neutral DMX Input The DMX signal is applied to the male five pin XLR connector DMX Output The DMX signal is looped through to the female XLR connector to continue the signal run to other devices All five pins are looped through Relay Outputs One relay is connected to each male 3 pin XLR style connector The outside connector carries the contacts for the first relay The inside connector carries the contacts for the second relay The pin outs are Outside Connector Inside Connector Pins 1 Relay 1 common Relay 2 common Pins 2 Relay 1 normally open Relay 2 normally open Pins 3 Relay 1 normally closed Relay 2 normally closed Controls Starting Address The starting address the dimmer number that will control the first relay is set using the three switches on the front panel Set the number to the starting address A test mode is provided that closes the relays regardless of the
Download Pdf Manuals
Related Search