Walker Platform Attachment L• WARNING L
Contents
1. 1 Loosen the arm tube adjustment knob located just below the arm pad 2 Slide the arm tube into the slot underneath the Arm Tube arm pad 3 Slide arm tube in or out to the desired position 4 Securely tighten the arm tube adjustment 4 Ar Tube knob S Adjustment Knob FIGURE 2 Securely tighten the adjustment knobs after any adjustment Adjusting the Angle or Tilt of the Walker Platform Attachment A WARNING DO NOT apply full weight while adjusting the angle injury may result NOTE For this procedure refer to FIGURE 3 Arm Pad Adjusting the Angle 23 NOTE This adjustment changes the inward or outward angle of the user s arm to their torso on the horizontal plane Tilt 1 Loosen the adjustment knobs that secure the support tube to the U clamps Support Tube 2 Turn the support tube until the desired angle is obtained 3 Securely tighten the adjustment knobs Adjustment U Clamps Knobs Adjusting the Tilt NOTE This adjustment changes the tilt of the user s arm to the floor on the vertical plane 1 Loosen the tilt adjustment knob NOTE The tilt adjustment knob is located where the support tube connects to the arm support 2 Liftup or push down arm tube to obtain the desired tilt FIGURE 3 Adjusting the Angle or Tilt of the 3 Securely tighten the tilt adjustment knob Walker Platform Attachment Part No 1064716 3 Walker Platform Attachment Us2. 036 2125 800 333 6900 Canada 570 Matheson Blvd E Unit 8 Mississauga Ontario L4Z 4G4 Canada 800 668 5324 All rights reserved Trademarks are identified by the symbols and All trademarks are owned by or licensed to Invacare Corporation unless otherwise noted 2008 Invacare Corporation Part No 1064716 Rev D 08 08
3. TY SHALL NOT APPLY TO SERIAL NUMBERED PRODUCTS IF THE SERIAL NUMBER HAS BEEN REMOVED OR DEFACED PRODUCTS SUBJECTED TO NEGLIGENCE ACCIDENT IMPROPER OPERATION MAINTENANCE OR STORAGE OR PRODUCTS MODIFIED WITHOUT INVACARE S EXPRESS WRITTEN CONSENT INCLUDING BUT NOT LIMITED TO MODIFICATION THROUGH THE USE OF UNAUTHORIZED PARTS OR ATTACHMENTS PRODUCTS DAMAGED BY REASON OF REPAIRS MADE TO ANY COMPONENT WITHOUT THE SPECIFIC CONSENT OF INVACARE PRODUCTS DAMAGED BY CIRCUMSTANCES BEYOND INVACARE S CONTROL PRODUCTS REPAIRED BY ANYONE OTHER THAN AN INVACARE DEALER SUCH EVALUATION SHALL BE SOLELY DETERMINED BY INVACARE THE FOREGOING EXPRESS WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS WARRANTIES WHATSOEVER WHETHER EXPRESS OR IMPLIED INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE AND THE SOLE REMEDY FOR VIOLATIONS OF ANY WARRANTY WHATSOEVER SHALL BE LIMITED TO REPAIR OR REPLACEMENT OF THE DEFECTIVE PRODUCT PURSUANT TO THE TERMS CONTAINED HEREIN THE APPLICATION OF ANY IMPLIED WARRANTY WHATSOEVER SHALL NOT EXTEND BEYOND THE DURATION OF THE EXPRESS WARRANTY PROVIDED HEREIN INVACARE SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES WHATSOEVER THIS WARRANTY SHALL BE EXTENDED TO COMPLY WITH STATE PROVINCIAL LAWS AND REQUIREMENTS Part No 1064716 7 Walker Platform Attachment Yes you Invacare Corporation www invacare com USA One Invacare Way Elyria Ohio USA 44
4. Walker Platform Attachment INVACARE Assembly Installation and Operating Instructions Model No G6027 Yes you can SAVE THESE INSTRUCTIONS NOTE Check ALL parts for shipping damage If shipping damage is noted DO NOT use Contact carrier dealer for further instruction A WARNING DO NOT use this product or any available optional equipment without first completely reading and understanding these instructions and any additional instructional material such as owner s manuals service manuals or instruction sheets supplied with this product or optional equipment if you are unable to understand the warnings cautions or instructions contact a healthcare professional dealer or technical personnel before attempting to use this equipment otherwise injury or damage may occur DO NOT use the walker platform attachment with any other walker accessories unless prescribed by a health care professional Doctor Therapist Ensure that the walker is securely locked into the open position before installing the walker platform attachment otherwise injury may occur The walker MUST be level to the ground ALL four legs of the walker MUST be in contact with the floor when exerting weight onto the walker with the walker platform attachment DO NOT lean too far forward or to the side with the walker platform attachment as the walker may become unbalanced and injury may occur The walker platform attachment does not fall under an
5. ate Invacare warrants its product to be free from defects in materials and workmanship for five years for the original purchaser If within such warranty period any such product shall be proven to be defective such product shall be repaired or replaced at Invacare s option This warranty does not include any labor or shipping charges incurred in replacement part installation or repair of any such product Invacare s sole obligation and your exclusive remedy under this warranty shall be limited to such repair and or replacement For warranty service please contact the dealer from whom you purchased your Invacare product In the event you do not receive satisfactory warranty service please write directly to Invacare at the address on the back cover Provide dealer s name address model number and the date of purchase indicate nature of the defect and if the product is serialized indicate the serial number Invacare Corporation will issue a return authorization The defective unit or parts must be returned for warranty inspection using the serial number when applicable as identification within thirty 30 days of return authorization date DO NOT return products to our factory without our prior consent C O D shipments will be refused please prepay shipping charges LIMITATIONS AND EXCLUSIONS THE WARRANTY SHALL NOT APPLY TO PROBLEMS ARISING FROM NORMAL WEAR OR FAILURE TO ADHERE TO THE ENCLOSED INSTRUCTIONS IN ADDITION THE FOREGOING WARRAN
6. b and carriage bolt from the U clamp and half clamp Detail A 4 Position the half clamp over the walker frame with the hinge placed on the inside of the walker 5 Align the mounting holes of the U clamp and the half clamp 6 From the inside of the walker place the carriage bolt through the half clamp U clamp and into the adjustment knob 7 Securely tighten the adjustment knob Attaching the Lower Hardware NOTE Position the slides just below the walker crossbace 1 Loosen the adjustment knobs and place the slides onto the walker frame Detail B 2 Adjust the slides in or out until the slides are tight in place Adjusting the Walker Platform Height 1 Loosen the adjustment knobs that secure the U clamps to the clamp assemblies Detail and slide the support tube up or down through the U clamps until the desired position is obtained 2 Securely tighten the adjustment knobs after any adjustment Walker Platform Attachment DETAIL Front of Walker Half Walker Clamp Frame SL Carriage Bolt U cl Adjustment Knob DETAIL Front of Walker ge Se Crossbrace Slide Be Walker Frame Adjustment 4 Knob Slide Adjustment Knob DETAIL C Support Knob FIGURE Attaching Adjusting the Walker Platform Attachment Part No 1064716 Attaching Adjusting the Arm Tube NOTE For this procedure refer to FIGURE 2
7. ing the Arm Strap NOTE For this procedure refer to FIGURE 4 1 Unfasten the arm strap by pulling up on the hook and loop fastening strap 2 Loosen arm strap by pulling it through the ring 3 Slide the user s arm into position 4 Pull the fastening strap until a snug fit is obtained around the user s arm 5 Fold the hook and loop fastening strap over ring and secure it to the arm strap Replacing the Arm Pad NOTE For this procedure refer to FIGURE 5 NOTE Note the position of the existing arm pad 1 Slide the existing arm pad off of the arm support 2 Slide anew arm pad onto the arm support NOTE The sides of the cover are on the outside of the arm support while the ends are tucked in Replacing the Fastening Strap NOTE For this procedure refer to FIGURE 6 1 Remove the arm pad Refer to Replacing the Arm Pad NOTE Note the orientation of the existing arm strap 2 While pulling on the ring slide the fastening strap through the slots in the arm support 3 Thread the end without the ring of the new arm strap through the slots in the arm support NOTE Make sure the hook end is facing down 4 Replace the arm pad Refer to Replacing the Arm Pad Walker Platform Attachment Hook and Loop Arm Strap Fastening Strap L Fastening Strap Ring FIGURE 6 Replacing the Fastening Strap Part No 1064716 Storing the Walker NOTE The walker can be folded without rem
8. oving the walker platform attachment 1 Fold the walker according to the instructions provided with the product 2 Lower the height of the walker platform attachment if necessary Refer to Attaching Adjusting the Walker Platform Attachment on page 2 Care and Maintenance of the Walker Platform Attachment 1 Use a mild soap or detergent to clean the arm pads and dry thoroughly 2 A light oil may be applied to the hardware to lubricate and aid in preventing rust Part No 1064716 5 Walker Platform Attachment FIGURE 7 Parts List Item No Part No Description Qty 1141041 Support Tube 2 1062843 Non Skid Pad 2 3 1069135 Arm Support 2 4 1013903 Carriage Bolt 2 5 1061131 Knob 6 6 60275x000 Locknut 7 10123 006 Mounting Bolt 8 1056286 Arm Tube 9 1016298 Handle Push Grip 10 1027096 Universal Gray Plug 2 11 1071284 Arm Padding 12 1068603 Multi Grip Rivet 3 13 1068808 Clamp 2 14 1141031 Clamp Assembly 15 1069015 Carriage Bolt 2 16 1141039 Non Skid Pad 4 17 1141034 Clamp Assembly 18 1057287 1 Universal Plug Button Walker Platform Attachment Part No 1064716 LIMITED WARRANTY PLEASE NOTE THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLICABLE TO PRODUCTS MANUFACTURED AFTER JULY 4 1975 This warranty is extended only to the original purchaser user of our products This warranty gives you specific legal rights and you may also have other legal rights which vary from state to st
9. y separate weight limitation beyond that of the walker that it attaches to up to a maximum walker weight limitation of 300 pounds Learn how to use the walker platform attachment in the presence of a health care professional Doctor Therapist If the walker platform attachment is exposed to extreme temperature above 00 F or below 32 F high humidity and or becomes wet prior to use ensure handgrips DO NOT twist on the walker platform attachment handle otherwise damage or injury may occur A ACCESSORIES WARNING Invacare products are specifically designed and manufactured for use in conjunction with Invacare accessories Accessories designed by other manufacturers have not been tested by Invacare and are not recommended for use with Invacare products A INSTALLATION WARNING After ANY adjustments repair or service and BEFORE use make sure that all attaching compo nent parts are secure Part No 1064716 Walker Platform Attachment Attaching Adjusting the Walker Platform Attachment A WARNING Ensure that the walker is securely locked in the open position before installing the walker plat form attachment otherwise injury may occur NOTE For this procedure refer to FIGURE 1 NOTE Reverse this procedure to remove the platform attachment Attaching the Upper Mounting Hardware 1 Open the walker 2 Determine which side of the walker the platform attachment will be used 3 Remove the adjustment kno
Download Pdf Manuals
Related Search