User Manual - American Impact Media
Contents
1. excessive dust moisture or rain mechanical vibration or shock unleveled surface e When the unit is used with an AC power adapter do not wrap the unit in a cloth blanket etc If you do so the temperature inside and outside the unit may rise considerably resulting in malfunctioning of the unit or serious accidents e If the unit is brought directly from a cold to a warm location or is placed in a very damp room moisture may condense on the lens inside the unit Should this occur the unit will not operate In this case remove the disc and leave the unit in a warm place for several hours until the moisture evaporates e For the unit to operate at its best it should not be subjected to temperatures below 5 C 41 F or above 35 C 95 F gt Warnings e Before operating the unit please read this manual thoroughly and retain it for future reference e To prevent fire or shock hazard do not expose the unit to rain or moisture To avoid electrical shock do not open the cabinet Refer servicing to qualified personnel only The use of optical instruments with this product will increase eye hazard gt Care amp Maintenance Cleaning Do not use volatile chemicals on this unit Clean by lightly wiping with a soft cloth Cleaning the CD If the CD skips or will not play the disc may need to be cleaned Before playing wipe the disc from the center out with a cleaning cloth After recording CD into memory store2. Single track CD Autoload On Hold Audio System User Manual Single track CD Autoload On Hold Audio System Before using this unit please read these operating instructions carefully Afterwards keep them handy for future reference Single track CD Autoload On Hold Audio System User Manual Supplied Accessories Connector Cable AC Adapter Player Features Digital flash memory design retains music message content even during power loss unit ships with preloaded audio Integrated CD mechanism quickly and easily record high quality audio CD media is easy and inexpensive to duplicate and distribute CD Autoload drop in a CD with a single track close the lid and the unit automatically records the content Built In Monitor Speaker allows user to monitor sound with the flip of a switch Wall Mountable unit can be mounted played and recorded in a vertical position Single track CD Autoload On Hold Audio System User Manual Set up gt Connection to PBX or KEY phone systems music on hold input m E Plug AC adapter into wall outlet A Plug AC adapter cable into jack marked DC12V Eq Plug Connector Cable to AUDIO OUT jack E Plug other end of Connector Cable into phone system s music on hold moh input jack NOTE If the jack cannot be located contact phone vendor for information p Connection to Standard Analog o
3. h the receiver is connected Consult the dealer or an experienced radio TV technician for help You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment gt Precautions Safety As the laser beam used in this compact disc player is harmful to the eyes do not attempt to disassemble the casing Refer servicing to qualified personnel only Do not put any foreign objects in the safety slot inside the disc compartment If you do so the laser beam may come out when the lid is opened Do not put any foreign objects in the DC IN 6V external power input jack Should any solid objects or liquid fall into the unit disconnect the power supply and have the unit checked by qualified personnel before operating it any further Operation Since the CD system offers a wide dynamic range the peaks of the high level inputs are recorded with high fidelity and the noise level is very low Do not turn up the volume while listening to a part of the disc with no audio signals or very low level inputs If you do so the speakers may be damaged when the peak level of the sound is played The lens on the disc table should be kept clean Do not touch the lens or poke at it If you do so the lens may be damaged and the unit will not operate properly Installation Never install the unit where it would be subjected to heat sources such as radiators or air ducts direct sunlight
4. it the red REC LED will flash for a few seconds then stop No audio will be recorded to memory Single track CD Autoload On Hold Audio System User Manual Settings gt Audio Output Impedance Location rear panel RCA jacks Operation Most telephone systems prefer an 8 ohm output If you are working with an older phone system the 600 ohm output may be preferable gt Speaker Switch Location rear panel Operation turn to ON position to listen to program playing from digital memory Audio being recorded plays through speaker regardless of speaker switch position Speaker switch position has no effect on AUDIO OUT playback gt Volume Control Location rear panel Operation controls output level of AUDIO OUT jack To adjust turn control knob clockwise to increase volume Set proper volume level by calling in from a phone close to the unit or cell phone and having your call placed on hold gt Power Switch Location rear panel Operation turns power on or off When power is on the green LED on the front of the player is illuminated Single track CD Autoload On Hold Audio System User Manual Adding Additional Memory gt Configuration The digital player comes standard with 8 minutes of flash memory Memory can be expanded to 16 24 or 32 minutes by adding memory modules in 8 minute increments Memory modules can be placed into 3 available memory expansion slots located under the memory expa
5. nsion access panel door gt Installation 1 Turn power switch to OFF position 2 Open player lid 3 Remove memory expansion access panel door located left of the CD drive 4 Carefully insert the 24 pin memory module chip in an open expansion slot beginning at the top of the unit 5 Turn power switch to ON position LCD will display the additional memory in the MEM AVAIL counter Single track CD Autoload On Hold Audio System User Manual Information gt FCC Information This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to whic
6. r KSU less Phones For connection to standard analog or KSU less phones an analog adapter module card is required The analog adapter module card connects internally to the digital player and provides music on hold capability to standard analog and KSU less phones The analog adapter interconnection cables are accessed by removing the steel plate on the rear panel For specific connection information please see instructions included with the analog adapter module For more information on the analog adapter please ask your dealer 2 Single track CD Autoload On Hold Audio System User Manual Operation gt Playback Playing Audio Stored in Memory By default the unit is always in playback mode Playback After Power Loss If power to the unit is lost the unit will resume playback as soon as power is reapplied The unit retains its recorded content after power loss gt Recording Recording Single Track CDs 1 Open cover 2 Insert CD 3 Close cover OPERATION Once cover is closed the unit will automatically begin recording the content of the track into the unit s digital memory During the recording process the contents of what is being recorded to memory will be heard through the speaker and the red LED on the front of the unit flashes The unit automatically switches over to playback mode when recording is complete NOTE This unit will not record a multi track CD If a multi track CD is placed in the un
7. the CD in its sleeve Handling the Disc Only touch the CD on the edges to avoid fingerprints on its surface CD Player Lens Do not touch the CD lens with your finger or any other material If there is dust on the lens blow lightly or use a camera lens blower brush
Download Pdf Manuals
Related Search