1404-UM001F-EN-P, Bulletin 1404 Powermonitor 3000 User Manual
Contents
1. aaa bbb ccc ddd decimal each Va byte Gateway IP Gateway IP address in 0 255 128 1 1 1 Address format aaa bbb ccc ddd decimal each Bytes 1 4 byte Optional ControlNet Communication Powermonitor 3000 units with a catalog number ending in CNT are equipped with an optional redundant ControlNet port and a native RS 485 port in a dual port configuration that allows simultaneous operation of the ports You must configure the communication parameters before you connect the power monitor to a ControlNet network The only configuration parameter is the ControlNet node number also called MAC ID The range of this parameter is 1 99 with a default of 99 A node number of 0 is typically used as the address of a ControlNet scanner Publication 1404 UM001F EN P November 2009 792. Bulletin 1404 Powermonitor 3000 Allen Bradley Catalog Numbers 1404 M4 1404 Mb5 1404 M6 1404 M8 User Manual a Fi E n 9 uit ut m N E _ is Rockwell Allen Bradley Rockwell Software Automation Chapter 4 78 Communication Optional Ethernet Communication Powermonitor 3000 units with a catalog number ending in ENT are equipped with an optional Ethernet 10 100BaseT communication port and a native RS 485 port in a dual port configuration that allows simultaneous operation of the ports You must configure the communication parameters before you connect your power monitor to an Ethernet network See your network administrator for assistance in setting the communication options Configuration parameters include the following e IP Internet Protocol address e Subnet Mask e Gateway IP address The IP Address uniquely identifies your Powermonitor 3000 unit on the network You configure the unit s IP address the way it is most commonly expressed as four decimal numbers connected by decimal points aaa bbb ccc ddd You may set each number also called byte or octet within the range of 0 255 decimal The default IP address is 192 168 254x where x is the factory assigned Unit ID number An IP address of 255 255 255 255 is not permitted IMPORTANT The IP address for your power monitor must not conflict with the IP address of any other device on the network Contact your network administrato
3. r to obtain a unique IP address for your unit The IP address is a 32 bit binary number which consists of the network address NetID and the machine address HostID The Subnet Mask defines the boundary between the NetID and HostID in the IP address Each 1 bit in the subnet mask represents the NetID and each 0 represents the HostID Here is an example IP Address decimal 192 1 207 binary 11000000 00000001 00000001 11001111 Subnet decimal 255 255 255 0 Mask binary 11111111 AFTECH 11111111 00000000 ae Net ID eer Host ID Publication 1404 UM001F EN P November 2009 Communication Chapter 4 In this example the NetID is 192 1 1 0 and the HostID is 0 0 0 207 The relationship between NetID and HostID depends on the IP address class the discussion of which is beyond the scope of this document the example uses a Class C IP address Devices on the same subnet can communicate directly devices on different subnets may communication with each other only through a gateway or router The Gateway IP Address defines the address of the gateway or router on the unit s subnet that is used to route messages to other subnets for wide area networking Default 128 1 1 1 Optional Ethernet Communication Parameter Description Range User Setting IP Address Unit IP address in format 0 255 192 168 254 UnitID Bytes 1 4 aaa bbb ccc ddd decimal each byte Subnet Subnet mask in format 0 255 255 255 255 0 Mask Bytes
Download Pdf Manuals
Related Search