- Citygrow Energy Systems
Contents
1. STEP 1 IMPORTANT Turn off main power at the main switch board STEP 2 Loosen the screws of the original wall switch Remove the switch and disassemble the wiring STEP 3 Connect the main power cable to the Live and Neutral terminals of the CG101AD Mini Power Supply and then connect the DC output wires of the CG101AD to the DC input of CG100H Series Case 1 For CG100H CG100HTH CG100HTHV1 CG101AD DC 6V Mini Power lt Bracket Supply gt Input AC 220V Output DC 6V wallbox Connect to Live and Neutral wires from the wallbox Case 2 For CG100HHB also connect the doorbell according to the following CG101AD DC 6V Mini Power i Bracket Supply Input AC 220V Output DC 6V wallbox Connect to Live and Neutral wires from the gt wallbox a Dry connect output to bell Max 1A 24Vdc ac gt 6V DC 6V input from CG101AD 6V TECHNICAL INFORMATION AND PICTURE SUBJECTED TO CHANGE WITHOUT PRIOR NOTICE Copyright 2012 Citygrow Energy Systems Ltd All Rights Reserved Case 3 For CG100H8 MD wallbox Metal mounting adaptor Bracket Connect to Live and Neutral wires from the wallbox CG101AD DC 6V Mini Power Supply Input AC 220V Output DC 6V Screw x 2 pcs STEP 4 Fasten the screws of all terminals and check that the wires are properly secured Retrofit the bracket of CG100H series into the standard switch box and mount it on the wall by fastening the two screw2. CityGrow 9 Systems CG100H4 MD CG100HTH CG100HTHV1 CG100H8 MD CG100H Series Installation guide CG100HHB Ratings Main unit Operation Voltage DC 6V Current consumption 300mA Power supply Citygrow CG101AD Mini Power Supply CG101AD Mini Power Supply Input AC 100 to 277V 50 60HZ Output DC 6V 6 00mA Before getting started WARNING The product must be installed by a qualified electrician in accordance with all applicable regulations and building codes Improper wiring can result in personal injury or damage to control units or other equipment Always turn off circuit breaker or remove main fuse from power line before doing any work To avoid overheating and possible damage to equipment WARNING Do not operate control units with any lamps removed or burned out replace any burned out lamps immediately use only transformers that incorporate thermal protection or fused primary windings The product is designed for residential and commercial use for indoor use only electrical codes IMPORTANT Citygrow is not liable for any damage incurred with the misuse of this product IMPORTANT Pre setup can only be done by a professional worker or manufacturer agent A WARNING Install in accordance with all national and local Installation instruction Wiring diagram CG101AD DC 6V Mini Power Distribution panel wall box Dry contact output to door bell For CG100HHB Only
3. n warranty or guarantee in connection with this publication and hereby expressly disclaims any liability or responsibility for loss or damage resulting from its use or from the use of any product or methodology described herein for any violation of any federal state or municipal regulation with which this publication may conflict or for the infringement of any patent from the use of this publication Nothing contained in this publication should be viewed as an endorsement by Citygrow Energy Systems Limited of any particular manufacturer s products Copyright 2012 Citygrow Energy Systems Limited All Rights Reserved
4. s in the wall box Frame Button panel CG101AD DC 6V Mini Power Supply Input AC 220V Output DC 6V wallbox Screw x 4 pes en Min Screw x 2 pes Connect to Live and Neutral wires from the wallbox STEP 5 Power up the main switch board the LED indicators on CG100H series will be lighted up Since the CG100H is not programmed and setup by HomeNET planner software at this moment the product buttons will not function at this stage Notes Use standard UK wall box BS4662 minimum 35mm deep During installation of the wall box it is recommended to embed the wall box deeper inside the wall in order to give more room to install the product The room inside is recommended to have 50mm deep Details 1 For detail operation and specification please refer to user manual and product specification 2 For detail programming of the product please refer to HomeNET Planner Software user manual www Citygrowsys com CityGrow 9 Systems Disclaimers and Copyright Nothing contained in this publication is to be construed as granting any right by implication or otherwise for the manufacture sale or use in connection with any method apparatus or product covered by letters patent or as insuring anyone against liability for infringement of letters patent Efforts have been made to ensure the accuracy and reliability of the data contained in this publication however Citygrow Energy Systems Limited makes no representatio
Download Pdf Manuals
Related Search