OPTICAL DISTRIBUTION FRAME [Wall Mount Type]
Contents
1. OPTICAL DISTRIBUTION FRAME Wall Mount Tynel User Manual Rev 0 OTB Manual Component List Items Unit Protection Tube Cord Protection Tube Cable tie Key Wall mounted Dowel Wall mounted Bolt Unit EA EA EA SET EA EA 1 Marking a Cutting Point 2 Sheath Removing Mark a sheath removing point on the cable Remove the cable sheath from the marked with a piece of tape at a 100cm point from the point by using a sheath stripper cable cut end Remove all plastic tape Q ty 2 4 X Splice Tray Oi a S 4 3 Cutting Tension Member 4 Removing Loose Tubes Leave 6cm from the cable and cut off the Leave about 4cm from the cable sheath 2 tension member end and remove the rest of the loose tube Clean the cut area by using jelly cleaner 4 Note Be sure not to damage the fiber 4 optics y Unit Protection Tube 5 Inserting Unit Protection Tube Insert fibers into the unit protection tubes carefully all the way up to the point where loose tubes end 6 Cutting Gasket 7 Inserting Fiber Optic Cable Wrap the tape around the end point of Cut off the inlet port gasket Check the outer diameter of the cable and protection tube at cable side cut off the sheath gasket according to the cable diameter marked on it 8 Install Ground terminal Secure the cable to the FDF body If the cable has metallic sheath and Tension Member In2. nection Connect the distribution Cable to the adapters on the opposite side After inserting a plastic plug anchor to 4 hole drive in a plastic plug anchor with a hammer The OTB has been made under strict quality control and tests Our products passed several inspection criteria specifications and other certification standards The technical facts of the products are based upon reliable information but the user should consider the usage and applicability of the product before operation Sellers do not assume any liability resulting from improper use The contents of this manual are made in lieu of all warranties but sellers do not take the responsibility for any damage caused by users or any statements unrelated to this manual OTB Manual
3. sert the Tension Member into the Ground Terminal for earthing OTB Manual 9 Fixing Fiber Optic Cable 10 Routing Protection Tube Insert the tension member into the T M fixing Secure the cable to the center of the Susband Route protection tubes to the splice tray bracket and tighten them together by using a Bracket by using a susband inlet and secure the protection tubes on the screwdriver splice tray inlet by using cable tie OPTICAL DISTRIBUTION FRAME Wall Mount Tynel User Manual Rev 0 11 Pigtail Connection Connect the pigtails to the adapters by turns on the adapter panel 14 Recording Splice fibers in accordance with splicing method to be approved Tie up patch cords with cable tie Fasten with a bolt to 4hole by using a drill 12 Routing Pigtail Route cord and guide them into stacked Splice tray Also insert pigtail into the cord protection tubes carefully FIBER DISTRIBUTION FRMAE 18 Finishing the Termination Box After close cover and fasten it by using a key to be provided Attach the OTB to the surface of wall Insert cord protection tube into splice tray inlet and tie together by using cable ties 16 Inserting Patch Cord Inset patch cord and in the outlet port gasket 19 Mounting on the wall Drill a 4 hole in the wall by using a drill 13 Splicing Splice fibers in accordance with splicing method to be approved 17 Distribution Cable Con
Download Pdf Manuals
Related Search