Home
GAP-II - VISION
Contents
1. VISION SCIBORG Install Parts USER GUIDE GAP II Ground Booster Thank you for purchasing this product Please be sure you read this manual in its entirety before connecting the product After installation please store this manual in a safe location so you can refer to it again in the future PRECAUTIONS PLEASE READ THOROUGHLY BEFORE USE A DANGER Mishandling may cause bodily harm This product is not waterproof splash proof or dust proof Take care to prevent water dirt oil and other impurities from entering the product otherwise malfunction to the product could occur as well as vehicle damage and possible bodily harm A NOTE Productor vehicle failure could result from ignoring the following e This product is 12Vdc only Never connect to a 24V vehicle e Never mount or store in locations where water moisture intense heat or dust could potentially affect the product and cause a fire when connected e Never mount this product in the engine compartment e NEVER install this or other vehicle electronics unless you have experience and know what you are doing You could cause harm to your car and yourself e Never mount this device in a way that it interferes with the safe operation of your car Never mount to or near foot pedals etc e Always use tape or a wire tie to securely mount this device so it is not loose e We have no responsibility or liability in the event of improper installation e We are not responsible f
2. or traffic accidents regardless of the presence or absence of this product Which pretty much goes without saying e This product was designed for use in Japan e Specifications subject to change without notice Manufacturer KIRAMEK Inc 9 183 1 Itayama cho Handa shi Aichi Ken 475 0936 JAPAN Ver 01152015 Contact TEL 81 569 20 5585 sow Noon 1 O0PM AOO USE 1 Boost the GWA alarm output 12V GROUND e g Metal frame of car Connect to alarm s GWA output EL Connect this to the device you would normally connect the GWA output to LED scanners etc To Ignition wire ACC wire car stereo fuse etc 12V GROUND e g Metal frame of car Connect to car s Door Courtesy wire Connect to alarm s Door Input wire Other Uses ELECTRICAL SPECIFICATIONS If you have a problematic wiring case where Product Dimensions 17 x 29 x4 mm your GND point is not quite Ov or a case Operating Voltage 12Vde Avg Current Consumption 4 2mA GRN WHT GND where you re using too much current the GAP II can resolve it Max Output Current 500mA
Download Pdf Manuals
Related Search
Related Contents
Tali® Image-Based Cytometer These General Terms (these “General Terms”) IG-700User Menu_KIKI4 Alarma XT-21 TempTrend Magazine - Mandelieu La Napoule SERVICE MANUAL 7 - Apex Power Tools Copyright © All rights reserved.
Failed to retrieve file