User manual
Contents
1. guide and let it dry in a well ventilated room The laser guide switches off automatically after 3min You did not assemble the trimming head correctly Push down the trimming head to make sure it is assembled correctly2. to the laser guide put the laser guide in off position before you remove the trimming head 14 ENGLISH Clean the trimming head connector with the cleaning brush supplied Clean the inside of the trimming head with the cleaning brush supplied After cleaning put the trimming head back onto the appliance Ordering accessories buy accessories or spare parts visit www shop philips com service or go to your Philips dealer You can also contact the Philips Consumer Care Centre in your country see the worldwide guarantee leaflet for contact details Guarantee and support If you need information or support please visit the Philips website at www philips com support or read the worldwide guarantee leaflet Environment Do not throw away the appliance with the normal household waste at the end of its life but hand it in at an official collection point for recycling By doing this you help to preserve the environment The built in rechargeable battery contains substances that may pollute the environment Always remove the battery before you discard and hand in the appliance at an official collection point Dispose of the battery at an official collection point for batteries If you have trouble removing the battery you can also take the appliance to a Philips service centre The staff of this centre will remove the battery for you and will dispose of it in an environmentally safe way ENGLISH 15 Fre
3. trimming head while the laser guide is still popped up 10 ENGLISH Start trimming where you want to define the edges of your beard and use the laser guide to guide you during trimming Tip Hold the appliance so that the laser light shines exactly on the edge you want to trim and then place the trimming head on your skin When you are finished press the on off button to switch off the appliance Tip When the motor of the appliance is not operating the laser guide switches off automatically within 3 minutes In the 3 minutes before the automatic switch off of the laser guide you can use the laser guide to check ifthe contours of your beard are symmetrical or straight Push down the top of the laser guide to lock it in off position click Trimming without comb If you trim without comb your hair is cut off close to the skin The trimming head has a 32mm 1 25in side and a 15mm 0 6in side The 15mm 0 6in side of the trimming head allows more precise styling and contouring than the 32mm 1 25in side If one of the combs is still on the trimming head pull it off Never pull at the flexible top of the comb Always pull at the sides Turn the trimming head until the side you want to use points to the front of the appliance ENGLISH 11 Press the on off button to switch on the appliance Hold the appliance in the position that is most convenient for the area you want to trim an
4. Always here to help you Register your product and get support at www philips com welcome Contact Philips BT9295 BT9290 BT9280 User manual PHILIPS 9295 9290 9280 ENGLISH 6 DANSK 17 DEUTSCH 28 39 5 51 SUOMI 62 FRANCAIS 72 ITALIANO 83 NEDERLANDS 94 NORSK 105 PORTUGUES 115 SVENSKA 126 T RKCE 136 6 ENGLISH Introduction Congratulations on your purchase and welcome to Philips To fully benefit from the support that Philips offers register your product at www philips com welcome General description Fig 1 1 2 3 4 5 6 7 8 9 Precision trimming comb Standard trimming comb Turnable trimming head Laser guide Guiding groove for trimming comb Length setting display Zoom wheel for length setting On off button Battery ligh Socket for small plug Adapter Small plug Cleaning brush Storage pouch BT925 BT9290 only wn Important Read this user manual carefully before you use the appliance and save it for future reference Danger Warning Keep the adapter dry Check if the voltage indicated on the adapter corresponds to the local mains voltage before you connect the appliance The adapter contains a transformer Do not cut off the adapter to replace it with another plug as this causes a hazardous situation This appliance is not intended for use by persons including children with reduced physical sensory or mental c
5. andard comb is most suitable for trimming your beard to an even areas for instance The laser guide is in off p top of the laser guide You switched off the appli After 3 minutes the laser the laser guide by You are using the app Move to a lance in room or area where the light is less bright length The precision comb is especially suitable for trimming hard to reach beneath your nose osition Switch on the laser guide by pressing the ance with the laser guide still popped up guide switches off automatically Switch on pressing the top of the laser guide a room or area where the light is very bright You are probably using the appliance in a room or area that is too dark Switch on he more light he light in This appliance has a quick charge func charging the bottom light room or go to a room or area where there is ion When the appliance starts flashes orange and white alternately After 3 minutes the bottom light stops flashing orange and only flashes white At this point the battery contains enough energy for one trimming session 16 ENGLISH Question Answer Why don t see a The laser light from the laser guide may be interrupted because straight uninterrupted laser line The laser window of the laser guide is dirty Pop up the laser guide and wipe the laser window clean with a cloth There is condensation behind the laser window Pop up the laser
6. apabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Keep the appliance and its cord out of the reach of children Do not use the appliance in the bath or in the shower Caution Always check the appliance before you use it Do not use the appliance if any of its parts is damaged or broken as this may cause injury Only use this appliance for its intended purpose as shown in the user manual Use charge and store the appliance at a temperature between 5 C and 35 C Only use the adapter supplied to charge the appliance Make sure the appliance is switched off and disconnected from the mains before you clean it under the tap If the appliance is subjected to a major change in temperature pressure or humidity let the appliance acclimatise for 30 minutes before you use it ENGLISH 7 If the adapter is damaged always have it replaced with one of the original type in order to avoid a hazard ever use compressed air scouring pads abrasivecleaning agents or aggressive liquids such as petrol or acetone to clean the appliance INN oise level Lc 65dB A Compliance with standards appliance complies with the internationally approved IEC safety regulations and can be safely cleaned under the tap This Philips appliance complies with all applicable standards and regulations regarding exposur
7. d make strokes in the desired direction Tip For a comfortable trim close to your skin place the flat side of the trimming head against your skin and make strokes in the desired direction When you are finished press the on off button to switch off the appliance Trimming with comb appliance comes with two combs a standard comb and a precision comb These combs keep the trimming head at a certain distance from your skin This distance determines the remaining hair length and can be adjusted by turning the zoom wheel Use the standard comb to trim your beard Use the precision comb to trim hard to reach areas for instance under your nose Slide the comb into the guiding grooves on both sides of the appliance click Note The comb does not fit on the trimming head when the 15mm 0 6in side is pointing towards the front of the appliance If this is the case turn the trimming head before you slide the comb onto the trimming head Turn the zoom wheel to select a length setting length setting selected lights up on the front of the appliance You can select a length from 0 4mm to 7mm see table in section Length settings below 12 ENGLISH Press the on off button to switch on the appliance To trim your beard move the trimming comb through the hair slowly When you are finished press the on off button to switch off the appliance Tips Always make sure that the tips of the trim
8. e to electromagnetic fields Class 1 laser product product contains a class 1 laser guide which complies with EC60825 1 avoid all risks point the laser beam away from your eyes and do not stare directly into the laser beam Preparing for use Charging Charge the appliance fully before you use it for the first time and after a long period of disuse Charging takes about 60 minutes if the appliance is completely empty Make sure the appliance is switched off and the laser guide is in off position Insert the small plug into the appliance and put the adapter in the wall socket D First the bottom battery light flashes orange and white alternately 8 ENGLISH D u gt After about 3 minutes the bottom battery light flashes white only At this point the battery contains enough energy for one cordless trimming session When the charging process continues more lights start flashing to show that the charge level of the battery increases When the appliance is fully charged all battery lights light up solid white If the appliance is still connected to the mains when it is fully charged the battery lights go out after 30 minutes Battery low and battery empty signals When the battery is almost empty the bottom battery light starts flashing orange When you switch off the appliance the bottom battery light continues to flash orange for a few seconds The battery light a
9. ming comb point in the direction in which you move the appliance Make sure that the flat part of the trimming comb is always in full contact with the skin to obtain an even hair length result Since hair grows in different directions you need to move the appliance in different directions upward downward or across Trimming is easier when skin and hair dry Length settings 04 0 6 0 8 1 0 12 14 1 6 1 8 2 0 215 30 35 40 45 5 0 60 70 Cleaning and maintenance Clean the appliance after every use Never use compressed air scouring pads abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance Note The trimming head does not need any lubrication ENGLISH 13 Cleaning the appliance and the combs Switch off the appliance Pull the comb off the trimming head Clean the trimming head under the tap with lukewarm water or clean with the cleaning brush supplied Clean the trimming combs under the tap or clean them with the cleaning brush supplied Tip To make sure that the appliance is dry before you store it in the pouch let it dry in a well ventilated room with the laser popped up Cleaning the trimming head connector Note Make sure you clean the trimming head connector at least once every three months Switch off the appliance Pull the comb off the trimming head Pull the trimming head off the appliance Note To prevent damage
10. quently asked questions Question Answer Is the laser light harmful to my eyes cannot turn the trimming head Why Can clean this appliance under a running tap Why doesn t the comb fit on the trimming head What is the difference between the combs Why can t see the laser light Why can t see the hairs when use the laser guide How long does it take to charge the appliance for just one trimming session he light directly into your rimming head ukewarm water Tip To prevent condensation on the laser window of advise you not to rinse the appliance under the tap o it is not The appliance has been thoroughly tested for home use evertheless we advise you not to stare into the ligh and to avoid shining eyes ou have to push the laser guide to off position before you can turn the The appliance is watertight and you can clean it under a running tap with he laser guide we The combs can only be used when the wide side of the trimming head points towards the front of the appliance If the comb does not fit 1 you may have tried to side of the trimming head trimming head to normal 2 The laser guide is still o fit it onto the trimming head when the narrow points towards the front of the appliance Turn the trimming position and then slide the comb onto it n To trim with one of the combs you first have to push the laser guide to off position The st
11. t the bottom of the appliance flashes orange at a higher frequency when the battery is empty and if you press the on off button turn the zoom wheel activate the laser guide Corded trimming You can also operate the appliance from the mains Insert the small plug into the socket of the appliance Put the adapter in a wall socket Press the on off button to switch on the appliance ENGLISH 9 Using appliance You can use the appliance to trim facial hair beard moustache and sideburns This appliance is not intended for trimming lower body parts or scalp hair Trimming with the laser guide You can use the laser guide to define the edges of your beard sideburns and moustache The laser guide can be used with the 32mm 1 25in side as well as the 15mm 0 6in side of the trimming head Note The laser guide can only be used when you trim without comb Note Although the light from the laser guide is not harmful to the eyes we advise you not to stare into the light and to avoid shining the light into your eyes Press the on off button to switch on the appliance To trim with the laser guide press the top of the laser guide to switch it on D The laser guide pops up and its light shines over the top of the trimming head Note If you trim with the laser guide make sure you push the laser guide to off position before you turn the trimming head You may damage the laser guide if you try to turn the
Download Pdf Manuals
Related Search