INSTALL INSTRUCTIONS
Contents
1. 0101 001 EE ie Tabu 1 888 472 6100 Part No 191529 Rev 4 Approved By R Mitchell 11 30 06 www ditekcorp com2. INSTALL INSTRUCTIONS DTK MRJ45C5e DTK MRJPOE BIER aoran This Surge Protection Device SPD is a high performance device designed to provide protection Largo PLOSTI for sensitive electronic loads connected to service panels fire panels or where the SPD is directly connected to the electronic device Maximum protection will only be achieved if the SPD is properly installed Please read and follow the installation instructions carefully NOTICE This SPD should be installed by a qualified electrician in accordance with the National and Local Electrical Codes and the following instructions APPLICATION Surge suppression for circuits using CAT 5e cable and RJ45 connectors INSTRUCTIONS Caution Measure all voltages to insure applied voltage does not exceed the voltage rating of the unit Improper installation voids the warranty This unit must be connected in series with the equipment to be protected 1 Connect the incoming wires to the IN connector 2 Connect a CAT 5e patch cable from the OUT to the equipment to be protected 3 Use one common ground per system to eliminate the possibility of a differential in ground potentials Ground Resistance Rule Max ground resistance is 25 ohms 5 ohms or less is optimum This cannot be an assumed value and must be measured to assure proper grounding 4 For mounting use double sided tape or two 2 8 screws DITEK Technical Support Available 24 7 Doc INT 10
Download Pdf Manuals
Related Search