Home
1PXL Strip/Cove Light XR CW/WW/DW user manual
Contents
1. 1PXL STRIP CW WW DW Cold White Warm White Dynamic White eee CAUTION AVOID LOOKING DIRECTLY INTO THE LED LIGHT SOURCE AT CLOSE 12 24 Ultra Bright White SMD LEDs i 2 RANGE FOR YOUR OWN SAFETY TX Connect System 288 00 11 34 D 1 60 0 06 SMART CHIP Technology far erra IDE Cate T ANY PERSONS INSTALLING THIS PRODUCT SHOULD COMPLY WITH LOCAL Auto Addressing ON OFF MSR 149 50 6 6 STANDARDS AND REGULATIONS AND MUST BE QUALIFIED FOR THE e Indoor Applications TEM Eni HANDLING OF ELECTRICAL EQUIPMENT E An ambient operating temperature range of 0 C to 40 C 32 F to 104 F must be adhered to at all times If the fixture has been subjected to drastic temperature variances e g following transportation do not connect the fixture until it has reached room temperature as internal condensation build up may damage the fixtures electronics When installing the fixtures and system power supplies in the chosen locations please ensure that they will not be exposed to moisture extreme heat or direct sunlight and that it is in a dirt and dust free environment keeping the fixtures and system power supplies within their operating boundaries Please study all functions in this User Manual throughly and check the latest Technical Specifications Sheets available from our website www tr
2. 1PXL STRIP CW WW DW Color Temperature 7000 K CW 3500 K WW 3500 7000 K DW Light Source 12 CW WW or 24 DW Ultra Bright White SMD LED Source Life 50 000 hours under normal operating conditions Beam Angle 120 Power Input 24V DC Power Consumption 5W max CW WW 10W max DW Operating Temperature 0 C 40 C 32 F to 104 F As with all electronic devices LED output degrades over time a term called lumen depreciation This also explains why it is nearly impossible to expect photometric performances of two LED products with different service life soans to be the same The rate of LED degradation is a complex function of many factors such as operating efficiency duration of continuous operation and operating conditions e g ambient temperature Because LEDs are semiconductor devices their performances are subject to inherent variability commonly found in semiconductor industry To improve consistency in performance across the same product LED manufacturers sort LEDs into bins according to different preset parameters such as forward driving voltage illumination etc Whereas binning is a sorting function it is not a correction process Inherent variability in the manufacturing process results always in different binning distributions according to different production lots Traxon uses automatically binned LEDs on its products thereby minimizing output variations within the model range 8 WARRANTY STAT
3. Ww ecg PESER act AA 8 DMX CHANNEL ALLOCATION FOR LED CONTROL Be CHANNEL 1 CHANNEL 2 CHANNEL 3 P Reserved 8 L CW FIXTURE 0 255 ls WW FIXTURE 0 255 1 DW FIXTURE 0 255 0 255 i 1 WHERE 0 MIN INTENSITY 255 MAX INTENSITY fe E E 5 5 SYSTEM CONNECTION The fixtures are wired together in a daisy chain using the TX Connect Smart system FIG 14 shows a wiring example LJ fie ess 6 CARE AND MAINTENANCE Traxon products are of superior design and quality and should be treated with recommendations below will help fulfill warranty obligations gain good use and longevity from the products Do not attempt or use the product s until you read and understand the installation instructions Failure to adhere to these instructions could result in serious injury or property damage Do not use product s if cables are damaged S Do not product s when wet or in wet area Moisture can cause electric shock and damage to product s s Do not use product s in dirty and dusty environment Do not use product s in extreme heat environment Ensure there is sufficient airflow and use cool air circulation if required Do not drop kno
4. casing FIG 2 PUSH UNIT ONTO THE BASE MOUNT BASE USING SCREWS AND FIG 3 FIG 4 ADJUST TO DESIRED ANGLE LOCK UNIT USING THE PROVIDED HEX KEY DO NOT OVER TIGHTEN FIG 5 4001 id al 40 15 0635 035 PUSH THE UNIT ONTO THE ROD FIG 6 FIG 7 ADJUST TO DESIRED ANGLE LOCK UNIT USING THE PROVIDED HEX KEY DO NOT OVER TIGHTEN 4 2 STRIP FIG 8 To mount the Strip affix the nylon spacers into the mounting holes on the bottom side of the Strip then use the screws to mount to a flat surface Select the desired position and fasten the screws in place FIG 8 Multiple strips can be mounted in line as shown in FIG 9 FIG 9 142 50 5 61 151 50 5 96 _ 14250661 _ 151 50 5 96 6 00 0 24 T T T T i s Bison o a o a sin 1 ws B a a alle B woo 5 SYSTEM CONFIGURATION 5 1 SETTING AUTO ADDRESSING DEFAULT OFF By default the factory setting for the auto addressing feature is OFF The DIP switch on the back of the fixture sets the auto addressing feature see FIG 10 and FIG 11 Auto addressing sets the DMX channel for the next fixture in the chain FIG 10 AUTO ADDRESSING OFF COVE LIGHT XR AUTO ADDRESSING OFF STRIP T OFF JBE gt OUT
5. 0100 1PXL STRIP WW MB ST 5070000 p Ce 1PXL COVE LIGHT XR DW MB CL 5080100 1PXL STRIP SW MB ST 5080000 NN 1 x 1PXL Cove Light XR 1x TX Connect Smart Interconnection Cable 8cm 3 15 2 x Mounting Screws The Traxon 1PXL Cove Light XR CW WW DW and 1PXL Strip CW WW DW features 12 or 24 ultra bright white SMD LEDs on a 24 5mm 0 96 pitch The low profile Cove Light XR with a 180 1PXL STRIP adjustable base mount is an ideal solution as self housed unit for alcoves recesses TRE Strip is an ideal option for full flexibility on mounting on any surfaces The Cove Strip is controlled by 3 channel DMX and can be daisy chained with the Traxon TX Connect system DD 2 x Nylon Spacers 1PXL COVE LIGHT XR CW WW DW Cold White Warm White Dynamic White said eee b 9 1x 1PXL Strip 1 x TX Connect Smart Interconnection Cable 8cm 3 15 2 x Mounting Screws TX Connect System R gt SMART CHIP Technology 172 80 6 80 16 80 0 66 cu 360 Rotation on Free Mount B DMX Control Auto Addressing ON OFF 54 80 2 16 I E 33 65 1 32 27 A0 1 08 4470 1 76 3 SAFETY AND OPERATION 180 Rotation on Base mount 35 00 1 38 CAUTION UNPLUG THE POWER SUPPLY FROM THE MAINS POWER BEFORE CONNECTING ANY CABLES AS THIS CAN DAMAGE THE PRODUCTS Indoor Applications
6. Cove Light XR CWAWW DW 1PXL Strip XR CW WW DW System Connection Example Use the TX Connect Smart Interconnection Cable to connect between fixtures For B onger distances either use a longer Interconnection Cable use the existing z g az Interconnection Cable with a TX Connect Smart Extension Cable FIG 13 esjs ej 5 BIZ on NEXT FIXTURE 5 8 s 9 eee zuj ese 9 IND TX CONNECT SMART INTERCONNECTION CABLE gia 8 LE a 5 71 21 0000 100 5 4 LED CONTROL The LEDs on the Cove Light XR CW WW DW and Strip CW WW DW are controlled by DMX Each fixture is allocated with 3 DMX channels that control the brightness for CW WW cold white warm white fixtures and the brightness and color temperature for DW dynamic white fixtures Refer to the table below B umn az E ES o 2 o e 2 Lu az e e 9 a lt w m a lt es lt a EIE z E 223 a uot zi oz 595 2 EO E c TEGS BOS TE Fon w OF 050 2223 262 D ue rr lt lt 0 go E ft 0 22r
7. EMENT Traxon warrants its Products against material or workmanship defects for a period of two 2 years from date of purchase provided that the purchased items are used under the conditions stated in this user manual Please refer to the Product Warranty section under www traxontechnologies com terms for warranty terms and conditions 10
8. ON i AUTO ADDRESSING ON AUTO ADDRESSING ON BOTTOM VIEW BOTTOM VIEW e Auto addressing OFF Next fixture uses the same DMX data as the existing fixture e Auto addressing ON Next fixture uses data from the next 3 DMX channels 5 2 TX CONNECT SYSTEM The Traxon TX Connect System is a interconnection system that combines power and DMX data on a single connector cable so that only one connection is required between light fixtures The Cove Light XR and Strip use the TX Connect System for all interconnections FIG 12 shows some components for the TX Connect System FIG 12 TX Connect System Components TX Connect Data Cable Part No DI IC 0020000 0 2m DI IC 0100000 1m DghEDrivs Jogi DLIC 0300000 3m Part No DI IC 0500000 5m SC JD 5080000 black DI IC 1000000 10m SC JD 5080100 white DI IC 2000000 20m 5 5 TX Connect Smart Interconnection Cable d Part No TLIC 0008000 0 08m LED Engine Smart 100W Indoor TI IC 0030000 0 3m Part No PS IA 0010000 TI IC 0060000 0 6m TX Connect Smart Extension Cable Part No 0050000 0 5m TI EC 0100000 1m TX Connect Smart TX Connect Smart TL EC 0300000 3m Power Data Injector Box Data Extractor Box Part No 1 21 0000100 Part No TI DO 0000100 TI EC 0500000 5m TLEC 1000000 10m 5 8 CONNECTING BETWEEN FIXTURES FIG 14 1PXL
9. axontechnologies com before setup 4 MOUNTING Plan your installation before mounting the Cove Light XR or Strip The following should be considered for a successful installation Installation distances and choose appropriate cable lengths The number of fixtures and choose appropriate power sources DMX controller to be used to control the fixtures Auto addressing ON or OFF on each fixture Refer to 5 SYSTEM CONFIGURATION FIG 1 4 1 COVE LIGHT XR 15600 6 14 The Cove Light XR can be mounted 8 140 00 using the provided baseplate dimensions shown in FIG 1 or Qo mounted in straight runs a round T stainless steel rod not supplied 07 00 0 28 3 50 0 14 40 00 1 57 Baseplate dimensions in mm in Bottom view e USING BASEPLATE MOUNT Use the screws provided to mount the baseplate firmly toa flat surface and then push the fixture onto the baseplate FIG 1 Rotate the fixture to the desired position and lock using the hex key FIG 2 amp 3 Do not over tighten as this can damage the fixture casing FREE MOUNTING Mounting multiple Cove Lights in a straight run can be achieved using a round stainless steel rod not provided Push the fixture onto the rod rotate the fixture to the desired position and lock using the hex key FIG 5 6 amp 7 Do not over tighten as this can damage the fixture
10. ck or shake product s Rough handling can damage the electronics and void the warranty Do not use harsh chemicals cleaning solvents or strong detergents to clean products Wipe with a damp cloth on housings and a dry cloth on electronics to remove dirt or dust Donotuse product s outdoors Do notattempt to service or repair the product s unless done by an authorized service personnel Contact your he local Traxon office or distributor for details CAUTION To reduce the risk electric shock or injury to persons Use only insulated staples or plastic ties to secure cords Route and secure cords so that they will not be pinched or damaged when the cabinet is pushed to the wall Not intended for recessed installation in ceilings or soffits Not intended for surface installation inside built in furnishings such as kitchen cabinets china cabinets or trophy cases The National Electrical Code NEC does not permit cords to be concealed where damage to insulation may go unnoticed To prevent fire danger do not run cord behind walls ceilings soffits or cabinets where it may be inaccessible for examination Cords should be visually examined periodically and immediately replaced when any damage is noted If the product is not working correctly please contact your nearest authorized service centre or Traxon Technologies office for assistance 7 TECHNICAL SPECIFICATION 1PXL COVE LIGHT XR CW WW DW
11. cra gt Please check for the latest updates and changes on the TRAXON website 2008 TRAXON TECHNOLOGIES ALL RIGHTS RESERVED WWW TRAXONTECHNOLOGIES COM HONG KONG NEW YORK PARIS TOKYO FRANKFURT BIRMINGHAM ROTTERDAM Version 1 1 USER MANUAL 1PXL COVE LIGHT XR CW WW DW 1PXL STRIP CW WW DW CONTENTS INTRODUCTION terit en ee 1 PACKING CONTENTS pret eis 2 SAFETY AND OPERATION reta ter teet 3 MOUNTING 3 4 1 COVE BIGEIT XB tid enne tio n cr to ios caen 3 Lcd 5 SYSTEM CONFIGURATION eese 5 5 1 SETTING AUTO ADDRESSING 5 5 2 TXOONNEGCT SYSTEM ettet ttn 6 5 4 CONNECTING BETWEEN FIXTURES _ 7 5 020 GONTRO L 7 5 0 SYSTEM CONNEQTION 7 CARE AND MAINTENANCE 9 TECHNICAL SPECIFICATION 9 WARRANTY STATEMENT 10 2 PACKING CONTENTS FOR YOUR OWN SAFETY AND THAT OF THE PRODUCT PLEASE READ THIS USER MANUAL CAREFULLY BEFORE BEGINNING SETUP AND INSTALLATION 1PXL COVE LIGHT XR 1 INTRODUCTION 1PXL COVE LIGHT XR CW MB CL 5060100 1PXL STRIP CW MB ST 5060000 Tx Hex Key 1PXL COVE LIGHT XR WW MB CL 507
Download Pdf Manuals
Related Search
Related Contents
EBS 37070 Manual de usuario SVERKER 900 Foundation 1.2 / 1.3 Quick Start Guide Philips DW4S4J05F 4.7GB / 120min 4x DVD+RW PM 500 Télécharger ce fichier Copyright © All rights reserved.
Failed to retrieve file