Hardware User`s Manual
Contents
1. Eve ns n 11 Isolation Box Panlab teers 6 INTRODUCTION The LE 26 Soundproof cage is designed to contain any of several of Panlab s experimentation cages such as the skinner cage passive avoidance cage shuttle box or startle and reflex cage Depending on the needs of the experiment it can feature additional sound insulation with an internal foam coating CABLE HOLE SPYHOLE Figure 1 Front and lateral views of the sound proof cage The cage is provided with a spyhole to observe the evolution of the experiment Isolation Box Panlab towers 7 SYSTEM DESCRIPTION There is a fan on the left wall to provide ventilation There is a LED lamp on the upper part of the rear inner wall with adjustable intensity through the control box Figure 2 Inner view of the sound proof cage There is a small box with a power switch a power LED an intensity regulator and a connector INTENSITY CONNECTOR POWER LED POWER Figure 3 Control box e POWER main switch that turns on fan and light e POWER LED 3mm red led that comes on when power switch is on e INTENSITY knob used to regulate led light intensity e CONNECTOR this male jack on the panel is used to connect the external power supply The power supply output must give 12V DC 1A Isolation Box Panlab H 8 SYSTEM CONNECTION The equipment has a control box that is connected to the external AC DC adapt2. SS 2 GOOD LABORATORY PRACTICE Check all units periodically and after periods of storage to ensure they are still fit for purpose Investigate all failures which may indicate a need for service or repair Good laboratory practice recommends that the unit be periodically serviced to ensure the unit is suitable for purpose You must follow preventive maintenance instructions In case equipment has to be serviced you can arrange this through your distributor Prior to Inspection Servicing Repair or Return of Laboratory Equipment the unit must be cleaned and decontaminated Decontamination prior to equipment disposal In use this product may have been in contact with bio hazardous materials and might therefore carry infectious material Before disposal the unit and accessories should all be thoroughly decontaminated according to your local environmental safety laws Isolation Box Panlab H de 3 UNPACKING AND EQUIPMENT INSTALATION WARNING Failure to follow the instructions in this section may cause equipment faults or injury to the user A For handling the sound proof box as it is heavy enough and the weight is not concentrated two persons are needed Not following this advice can cause backache B Inspect the instrument for any signs of damage caused during transit If any damage is discovered do not use the instrument and report the problem to your supplier C Ensure all transport locks are removed before u
3. Barcelona SPAIN Declara bajo su responsabilidad que el producto SOUND PROOF CAGE Declares under his responsibility that the product D clare sous sa responsabilit que le produit Marca Brand Marque PANLAB Modelo Model Modele LE 26 Cumple los requisitos esenciales establecidos por la Uni n Europea en las directivas siguientes Fulfils the essential requirements established by The European Union in the following directives Remplit les exigences essentielles tablies pour l Union Europ enne selon les directives suivantes 2006 95 EC Directiva de baja tensi n Low Voltage Basse tensi n 2004 108 EC Directiva EMC EMC Directive Directive CEM 2012 19 EU La Directiva de Residuos de Aparatos El ctricos y Electr nicos WEEE The Waste Electrical and Electronic Equipment Directive WEEE Les d chets d quipements lectriques et lectroniques WEEE 2011 65 EU Restricci n de ciertas Sustancias Peligrosas en aparatos el ctricos y electr nicos ROHS Restriction of the use of certain Hazardous Substances in electrical and electronic equipment ROHS Restriction de l utilisation de certaines substances dangereuses dans les quipements lectriques et lectroniques ROHS 2006 42 EC Directiva mecanica Machinery directive Directive m canique Para su evaluacion se han aplicado las normas armonizadas siguientes For its evaluation the following harmonized standards were applied Pour son valuation nous
4. avons appliqu les normes harmonis es suivantes Seguridad Safety S curit EN61010 1 2011 EMC EN61326 1 2012 Class B FCC FCCA47CFR 158 Class Safety of machinery EN ISO 12100 2010 En consecuencia este producto puede incorporar el marcado CE y FCC Consequently this product can incorporate the CE marking and FCC C C En cons quence ce produit peut incorporer le marquage CE et FCC En representaci n del fabricante Manufacturer s representative En repr sentation du fabricant Carme Canalis 4 p Panlab s l u a division of Harvard BioScience Cornell de Llobregat Spain 25 06 2014 solation Box 12 Panlab 6 Note on environmental protection After the implementation of the European Directive 2002 96 EU in the national legal system the following applies Electrical and electronic devices may not be disposed of with domestic waste Consumers are obliged by law to return electrical and electronic devices at the end of their service lives to the public collecting points set up for this purpose or point of sale Details to this are defined by the national law of the respective country This symbol on the product the instruction manual or the package indicates that a product is subject to these regulations By recycling reusing the materials or other forms of utilising old devices you are making an important contribution to protecting our envir
5. le remettre un revendeur En permettant enfin le recyclage des produits le consommateur contribuera la protection de notre environnement C est un acte cologique Hinweis zum Umweltschutz Ab dem Zeitpunkt der Umsetzung der europ ischen Richtlinie 2002 96 EU in nationales Recht gilt folgendes Elektrische und elektronische Ger te d rfen nicht mit dem Hausm ll entsorgt werden Der Verbraucher ist gesetzlich verpflichtet elektrische und elektronische Ger te am Ende ihrer Lebensdauer an den daf r eingerichteten ffentlichen Sammelstellen oder an die Verkaufstelle zur ckzugeben Einzelheiten dazu regelt das jeweilige Landesrecht Das Symbol auf dem Produkt der Gebrauchsanleitung oder der Verpackung weist auf diese Bestimmungen hin Mit der Wiederverwertung der stofflichen Verwertung oder anderer Formen der Verwertung von Altger ten leisten Sie einen wichtigen Beitrag zum Schutz unserer Umwelt Informazioni per protezione ambientale Dopo l implementazione della Direttiva Europea 2002 96 EU nel sistema legale nazionale ci sono le seguenti applicazioni dispositivi elettrici ed elettronici non devono essere considerati rifiuti domestici consumatori sono obbligati dalla legge a restituire dispositivi elettrici ed elettronici alla fine della loro vita utile ai punti di raccolta collerici preposti per questo scopo o nei punti vendita Dettagli di quanto riportato sono definiti dalle leggi nazionali di ogni sta
6. the connection between the external adapter and the control unit Check that the luminosity selector is not at the minimum level The fan does not work The lamp does not work Isolation Box Panlab H 11 PREVENTIVE MAINTENANCE EXPERIMENT BOX CLEANING Isolation Box 10 12 SPECIFICATIONS Panlab H Harvard Apparatus POWER SUPPLY Input voltage Frequency Maximum power Conducted noise Universal 100 240 VAC 50 60 Hz 2 EN55022 CISPR22 CISPR16 class ENVIRONMENTAL CONDITIONS Operating temperature Operating relative humidity Storage temperature 10 C to 40 C 0 to 85 RH non condensing o C to 50 C non condensing FAN Model 3412 NGLE Width x Height x Depth 92 mm x 92 mm x 25 mm Power 1 1 W Power supply 12 VDC Maximum current LAMP Technology White LED Quantity 14 LEDs Power supply 12V DC Power 1 12 W Luminosity regulation Yes DIMENSIONS Width x Height x Depth 660 mm x 550 mm 500 mm An external adapter from 100 240 V AC to 12 V DC is used Isolation Box 11 Panlab H DECLARACION DE CONFORMIDAD DECLARATION OF CONFORMITY DECLARATION DE CONFORMITE Nombre del fabricante Panlab s l u Manufacturer s name www panlab com Nom du fabricant info panlab com Direccion del fabricante Energia 112 Manufacturer s address 08940 Cornell de Llobregat Adresse du fabricant
7. Hardware User s Manual Isolation box Behavioral chambers References L E26 76 0157 Version 1 0 Apparatus s l u C Energia 112 08940 Cornella de LI Barcelona Spain www panlab com International Calls 34 934 750 697 Domestic Call 934 190 709 Fax 34 934 750 699 Info panlab com Limitation of Liability PANLAB does not accept responsibility under any circumstances for any harm or damage caused directly or indirectly by the incorrect interpretation of what is expressed in the pages of this manual Some symbols may have more than one interpretation by professionals unaccustomed to their usage PANLAB reserves the right to modify in part or in total the contents of this document without notice Panlab H 1 SYMBOLS TABLE Recognising the symbols used in the manual will help to understand their meaning DESCRIPTION SYMBOL Warning about operations that must not be done because they can A damage the equipment Warning about operations that must be done otherwise the user can be A exposed to a hazard Protection terminal ground connection Warning about a hot surface which temperature may exceed 65 C Warning about a metal surface that can supply electrical shock when it s A touched Decontamination of equipments prior to disposal at the end of their operative life Waste Electrical and Electronic Equipment Directive WEEE
8. er and from there to the power cord Figure 4 Equipment connections E FROM CABLE External AC DC adapter External AC DC adapter Female Jack Isolation Box Panlab H de 9 WORKING WITH THE EQUIPMENT 9 1 CONDUCTING AN EXPERIMENT 1 Connect the AC DC adapter to mains 2 Connect the AC DC adapter to the control box 3 Turn the switch on 4 Observe then that the power LED is on 5 Aspyhole is provided to observe the evolution of the experiment 6 Set the intensity regulator to the desired position 7 Once the experiment has ended you should clean the sound proof box 9 2 CLEANING THE SOUND PROOF BOX To clean the walls you can use a lightly wet cloth and then dry them with a dry cloth If they re too dirty you can wet the cloth with a soapy solution to clean them then remove foam with a wet cloth and finally dry them with a dry cloth Isolation Box Panlab ae 10 TROUBLESHOOTING This table features instructions to solve the most frequent problems PROBLEM SOLUTION Ensure that the power cord connection to the external adapter and the connection between the external adapter and the control Unit are correct The equipment does not start up Check that the power switch is in the ON position and that the power LED Is on Check the connection between the external adapter and the control unit Check that the power switch is in the ON position and that the power LED is on Check
9. he instructions in this section may cause equipment fault e PRESS KEYS SOFTLY Lightly pressing the keys is sufficient to activate them e Equipments do not require being disinfected but cleaned for removing urine faeces and odour To do so we recommend using a wet cloth or paper with soap which has no strong odour NEVER USE ABRASIVE PRODUCTS OR DISSOLVENTS e NEVER pour water or liquids on the equipment e Once you have finished using the equipment turn it off with the main switch Clean and check the equipment so that it is in optimal condition for its next use Isolation Box Panlab H ae 5 TABLE OF CONTENTS j SYMBOLS TABLE wes arent Un wen se neem ence 1 2 GOOD LABORATORY PRACTICE MUNERE 1 3 UNPACKING AND EQUIPMENT 2 EM VV EB2 Uu rIg2cM DC EE 3 5 TABLE OF CONTENTS rod 4 INTRODUCHFION cursan 5 7 SYSTEM DESCRIP RON pascal 6 8 SYSTEM CONNECTION 7 9 WORKING WITH THE Hmm 8 9 1 CONDUCTING AN EXPERIMENT 2 8 9 2 CLEANING THE SOUND PROOF BOX 8 10 TROUBLESHOOTING uuu a diss 9 11 PREVENTIVE MAINTENANCE u 10 12 SPECIFICATIONS
10. onment gt lt Nota sobre protecci n medioambiental Despu s de la puesta en marcha de la directiva Europea 2002 96 EU en el sistema legislativo nacional Se aplicara lo siguiente Los aparatos el ctricos y electr nicos as como pilas bater as no se deben tiar ala basura dom stica El usuario est legalmente obligado a llevar los aparatos el ctricos y electr nicos as como pilas y bater as al final de su vida til a los puntos de recogida municipales o devolverlos al lugar donde los adquiri Los detalles quedaran definidos por la ley de cada pa s El s mbolo en el producto en las instrucciones de uso o en el embalaje hace referencia a ello Gracias al reciclaje a la reutilizaci n de materiales i a otras formas de reciclaje de ue usados usted contribuir de forma importante a la protecci n de nuestro medio ambiente y Remarques concernant la protection de l environnement Conform ment la directive europ enne 2002 96 CE et afin d atteindre un certain nombre d objectifs en mati re de protection de l environnement les r gles suivantes doivent tre appliqu es Elles concernent les d chets d quipement lectriques et lectroniques Le pictogramme pr sent sur le produit son manuel d utilisation ou son emballage indique que le produit est soumis cette r glementation Le consommateur doit retourner le produit usager aux points de collecte pr vus cet effet peut aussi
11. se The original packing has been especially designed to protect the instrument during transportation It is therefore recommended to keep the original carton with its foam parts and accessories box for re use in case of future shipments Warranty claims are void if improper packing results in damage during transport D Place the equipment on a flat surface and leave at least 10 cm of free space between the rear panel of the device and the wall Never place the equipment in zones with vibration or direct sunlight E Once the equipment is installed in the final place the main power switch must be easily accessible F Only use power cords that have been supplied with the equipment In case that you have to replace them the spare ones must have the same specs that the Original ones G A Make sure that the AC voltage in the electrical network is the same as the voltage selected in the equipment Never connect the equipment to a power outlet with voltage outside these limits For electrical safety reasons you only can connect equipment to power outlets provided with earth connections This equipment can be used in installations with category voltage according to the General Safety Rules WARNING The manufacturer accepts no responsibility for improper use of the equipment or the consequences of use other than that for which it has been designed Isolation Box Panlab H ae 4 MAINTENANCE WARNING Failure to follow t
12. to Questo simbolo sul prodotto sul manuale d istruzioni o sull imballo indicano che questo prodotto soggetto a queste regole Dal riciclo e re utilizzo del material o altre forme di utilizzo di dispositivi obsoleti voi renderete un importante contributo alla protezione dell ambiente y Nota em Protecc o Ambiental Ap s a implementac o da directiva comunit ria 2002 96 EU no sistema legal nacional o seguinte aplica se Todos os aparelhos el ctricos e electr nicos n o podem ser despejados juntamente com o lixo dom stico Consumidores est o obrigados por lei a colocar os aparelhos el ctricos e electr nicos sem uso em locais p blicos especficos para este efeito ou no ponto de venda Os detalhes para este processo s o definidos por lei pelos respectivos pa ses Este s mbolo no produto o manual de instru es ou embalagem indicam que o produto esta sujeito a estes regulamentos Reciclando reutilizando os materiais dos seus velhos aparelhos esta a fazer uma enorme contribuig o para a protecc o do ambiente Isolation Box 13
Download Pdf Manuals
Related Search