Manual - TPC Advanced Technology
Contents
1. TPC H6000 6005 amp 6025 Handpiece Cleaning and Lubrication System User Manual TPC Advanced Technology 851 S Lawson St City Of Industry CA 91748 www tpcdental com REV 1 1 13 TPC Installation instruction Place the H6000 in a location where you have an air line Generally this location will be located near your sterilization area You will also need an electrical outlet Connect your air line and electrical Fill lubrication reservoir with the supplied lubrication fluid Make sure not to over fill the reservoir or spillage will occur After filling be sure to tighten the oil reservoir cap 3 Place absorbent pads into place These pads will absorb any excess lubrication that is released in the chamber The pads need to be replaced every tank cycle TPC Operation Instructions Open the door and attach up to 3 handpieces to the unit e When attaching high speed handpieces be sure to tighten the handpiece securely to the nut e When attaching straight noise cone and contra angles make sure that the latch attach is secure Notice how all the latches are almost Notice the latch is not flush with flush with the connector the stem of the E type connector Correct NOT CORRECT TPC After attaching handpieces close the door The unit will not operate if the door is not properly closed 6 Select the S Short 35 second cycle L Long 45 second cycle or E Extra long 50 second cycl2. e for each individual handpiece If no light for 1 2 or 3 is illuminated the position is turned off e SHORT CYCLE For high speed handpieces LONG CYCLE For low speed handpieces amp air motors EXTRA LONG CYCLE For speed reduction handpieces NO LIGHT ILLUMINATED Hand Piece position is in the off position 7 Press the start button In less than 3 minutes all handpieces are correctly cleaned and lubricated 3 minutes for 3 handpieces Press the air button if you wish to run a cycle of only air through your handpieces This process removes any excess lubrication fluid from the turbine Remove your handpieces from the unit Lubrication and cleaning is now complete To remove the handpiece turn the HP nut counter clockwise to un screw it For E type attachments press the button release to unlock and remove the straight noise cone or contra angle You may proceed to sterilization if necessary You may adjust the pressure in the reservoir to adjust the amount of air pressure that is supplied to the hand piece Pull the knob outward to unlock it Turn the knob counter clockwise to lower the pressure Turn the knob clockwise to increase the pressure Reference the air pressure gauge on the side of the unit to verify the set pressure The silver knob located next to the air pressure adjustment knob is used to regulate the amount of oil that is dispensed in a cycle If you wish to increase the amount of oil turn t
3. he valve counter clockwise If you wish to decrease the amount turn the valve clockwise This must be adjusted prior to starting a cycle TPC Overview of Controls Air button only runs Lubrication reservoir Error light will air through the hand illuminate when the N fill cap pieces No door is opened or there lubrication is being is a malfunction in the discharged system Start button Starts the cycle of the H6000 when pressed Door switch When the door is not closed the unit will not operate Three handpiece locations Absorbent Door Strips Re order 6135 Mist Filter Re order H6130 Lubrication chamber level indicator Door Keeps lubrication in the chamber when in operation
Download Pdf Manuals
Related Search