FP-2100W/FP-2400W User`s Manual
Contents
1. stoppers 2 Position the stoppers to the tab of the panel protector and install them on the cabinet of the monitor Removing Release the stoppers from the cabinet Put the lever on the tabs of panel protector and move it toward the cabinet to remove Cleaning e Please be sure to keep the panel protector immobilized while cleaning it Otherwise it may scratch the surface of the LCD panel To hold the panel protector by hand use a soft cloth to avoid dust or finger prints e Never use thinner benzene alcohol ethanol methanol or isopropyl alcohol abrasive cleaners or other strong solvents as these may cause damage to the cabinet or panel e It is recommended to use EIZO cleaning kit ScreenCleaner option to clean the panel The panel surface can be cleaned with a soft cloth such as cotton or lens paper If necessary stubborn stains can be removed by moistening part of the cloth with water to enhance its cleaning power Specification Surface treatment Non glare side non glare hard coating Glossy side hard coating Coating strength 2H Light transmission More than 90 Dimension Weight FP 2100W 456 5 mm W x 286 6 mm H x 1 0 mm D approx 158 g FP 2400W 521 1 mm W x 327 3 mm H x 1 0 mm D approx 210 g Accessories Lever for Panel Protector Stoppers x 4 User s Manual Copyright 2006 2013 EIZO Corporation All rights reserved OONOL252B12. User s Manual EIZO EP 2100W FP 2400W Panel Protector for EIZO 53 cm 21 1 inch 61 cm 24 1 inch class LCD Monitors e Please be careful not to scratch the LCD panel or the cabinet with the panel protector during installation Also please do not remove the panel protector often It may scratch or result in damage to the LCD panel e The panel protector has a non glare treatment side and a glossy side Use preferable side e When using LCD monitor with optional panel protector it is preferable to avoid using downwards In this condition the panel protector might become bend or slip out from the monitor Installation Before installation please remove dust and stains from the LCD panel 1 2 3 Stopper N Lever 1 Set the panel protector into the grooves of the panel frame the lower first 1 then the upper 2 2 With the enclosed tool Lever set the tabs of the panel protector into the side grooves 4 tabs Put the lever on the tabs of the panel protector and move it toward the LCD panel to install Position the protector into the LCD panel tightly without leaving an opening For the recommendation please use the stoppers to prevent the panel protector from bending or slipping out from the monitor 3 Before installation the stoppers please remove dust and stains from the cabinet of the monitor Follow these steps to install the stoppers 1 Remove the protection paper from the
Download Pdf Manuals
Related Search