MIT USER`S MANUAL Ver. 2.0
Contents
1. MIT USER S MANUAL Ver 2 0 Module ontact Insertion Extraction Section 1 2 0 TAC Receiver Module Installation Removal P N 510 130 117 380 pos Signal Module 510 130 121 220 24 pos Signal Coaxial Module 510 130 173 46 pos Coaxial or Power Module 510 130 180 180 10 pos Signal Coaxial 75 OHM Module To install a module into the Receiver place two 2 Socket Head Cap Screws 50 in length in the TAC Receiver Module Place the Module in the front of the Receiver aligning the locating pins on the module with the appropriate holes in the Receiver Frame so that the upper and lower module screws touch the mating holes the Receiver Frame install modules such that the numbers can be read from top to bottom making them right side up Using a 5 64 Allen Hex Wrench tighten the top screw 1 to 2 full revolutions while lightly applying pressure against the face of the module Maintain this pressure while tightening the bottom screw 1 to 2 full revolutions Repeat this sequence in order until the module is seated As the module is being seated watch to ensure that it does not become cocked at any time as a result of the guide pins not being properly aligned with the receiver or binding of the pins due to one screw being advanced ahead of the other more than 1 to 2 turns If this should occur back the screws off until the module is level and repeat the tightening process Torque the screw until it is 4 to 5 inch pounds Place the Prote2. ctive Module Cover on the front of the Receiver with the counter sunk holes facing upward and verify alignment of the clearance holes with the contacts in the TAC Receiver Module Using the 2 Flat Head Phillips screws secure the cap in place COVER PLATE TAC RECEIVER x m MODULE until screws are firmly seated Prior to Module removal the pra Protective Module Cover must be olo removed To remove unfasten p the two 2 Flat Head Phillips PROTECTIVE d screws and remove the cover MODULE COVER pet Eeng ETE ae rv 1 ATTACHES TO iris gt FACE OF RECEIVER D as 7 el oD qn P INSERT TAC MODULE SUCH eo E THAT THE RETAINING PLATE FACES BACK OF RECEIVER TAC Module P N 510 130 121 shown in place SCREENED SIDE UP screened side up Protective Module Cover has not been secured to the face of the Receiver 4 P N VMMIT100
Download Pdf Manuals
Related Search