WindScribe Instructions, English
Contents
1. Velcro strap Fits bars 3 4 to 11 2 in diameter 19 to 38 mm 3 Attach Wrist Lanyard Feed one end of lanyard through mounting hole to form a small loop Feed opposite end through loop and pull tight Slide bead to adjust fit Tripod Mounting Attach tripod to tripod thread 1 4 x 20 Telltale Tie a piece of yarn or string not included to telltale slot on front of unit to help determine wind direction Operation Power On Block both ends of wind barrel to ensure correct zero speed setting then press ON CAL indi cates unit is calibrating Measure Wind Speed Point front of wind barrel into wind to measure positive wind sped or headwind Point rear of wind barrel into wind to measure negative wind speed or tailwind Power Off Clear Readings Escape When you press and hold ON the display cycles through three modes OFF CLr clear and ESC e To power off release when OFF is displayed Also turns off after 5 minutes of no button activity and zero wind speed e To clear max min and avg readings release when CLr is displayed e To return to operation without clearing readings release when ESC is displayed Hold Current Reading Press HOLD to capture cur rent reading in upper display LCD indicates hold in progress Press again to release Turn Light ON Press TEMP and WIND at the same time Light turns off after 10 seconds Functions Change Temperature Display Mode Pre2. DAVISE with no moving parts Provides wind sped temperature wind chill Uses ultrasound technology to read current wind speed from 0 4 to 150 mph highest positive speed headwind low est negative speed tailwind 5 second average and running average Select from mph km h fom m s f s or knots Choose temperature and wind chill in F or C in tenths of a degree Includes 3 volt lithium battery adjustable wrist lanyard mount ing bracket with 6 15 cm Velcro strap Use three ways e Handheld e Tripod mount e Mounting bracket Ultrasonic wind barrel with ultrasonic sensors and advanced micro processor circuitry Tripod thread 1 4 x 20 Also used for mounting bracket and removable Getting Started 1 Install Battery Use coin to open battery door Install battery positive side up Replace battery when low battery indicator is displayed WindScribe INSTRUCTIONS Davis WindScribe ultrasonic wind meter is portable rugged 276 Ultrasonic Wind Meter Metric and U S units of measure CE Telltale slot so you ll know when the unit is pointed directly into the wind Tie a piece of yarn Fd or string not included to telltale slot Quick Reference Guide Replaceable battery Up to 600 hours of use with auto off and low battery indicator 2 Attach Mounting Bracket Attach mounting bracket to tripod thread Secure to handlebar or strut using
3. ss TEMP to cycle through temp max temp min temp wind chill and min wind chill Change Temperature Units of Measure Press and hold TEMP until you see desired unit Change Wind Display Mode Press WIND to cycle through wind speed modes speed 5 sec avg speed running avg speed max speed and min speed Change Wind Speed Units of Measure Press and hold WIND until you see desired unit mph knots f s fpm x10 m s or km h Wind Speed Display Modes Speed Current speed 5 Sec Avg Speed 5 second average speed Running Avg Speed Average speed since last clear up to 45 hrs Max Speed Highest positive speed since last clear headwind Min Speed Lowest negative speed since last clear tailwind Specifications Temperature Display Modes Temp Current temperature Max Temp Maximum temperature since last clear Min Temp Minimum temperature since last clear Wind Chill Current wind chill based on current temp and 5 sec avg speed Min Wind Chill Lowest wind chill since last clear Visit www davisnet com for complete specifications Davis Instruments Davis Marine Europe 3465 Diablo Avenue Hayward CA 94545 U S A Uilenkade 12 NL 3336 LP Zwijndrecht The Netherlands Phone 510 732 9229 Fax 510 732 9188 info davisnet com www davisnet com Phone 31 78 6194316 Fax 31 78 6192689 euro davisnet com www davisnet com 00276 007 Rev B September 2010
Download Pdf Manuals
Related Search