Home

Audio Receiver

1. User and Installation Guide iFinity Digital Wireless Audio Receiver Amphony a N a m a a o dd w fe a User and Installation Guide A mphon y LEGAL LIMITATIONS REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS YOUR EXCLUSIVE REMEDY WE SHALL NOT BE HELD LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESSED OR IMPLIED WARRANTY ON THIS EQUIPMENT NOR FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF OR INABILITY TO USE THIS EQUIPMENT UNDER NO CIRCUMSTANCES SHALL OUR LIABILITY IF ANY EXCEED THE PURCHASE PRICE PAID FOR THIS EQUIPMENT EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW EXCEPT AS PROVIDED HEREIN WE MAKE NO WARRANTIES EXPRESS OR IMPLIED INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE WE RESERVE THE RIGHT TO REFUSE TO HONOR THIS WARRANTY IF WE DETERMINE ANY OF THE ABOVE EXCEPTIONS TO HAVE CAUSED THIS EQUIPMENT NOT TO HAVE PERFORMED PROPERLY THIS WARRANTY SHALL BE VOID IF ANY FACTORY APPLIED IDENTIFICATION MARK INCLUDING BUT NOT LIMITED TO SERIAL NUMBERS AND WARRANTY LABELS HAS BEEN ALTERED OR REMOVED THIS WARRANTY SHALL ALSO BE VOID IF THE TRANSMITTER OR AMPLIFIER HAVE BEEN OPENED BY AN UNAUTHORIZED PERSON This warranty gives you specific legal rights which may vary from state to state Some states do not allow the exclusion or limitation of incidental or consequential damages or allow limitations on the du
2. any obstacles iFinity Transmitter or Receiver too close to wireless LAN device In some cases there may be strong interference preventing proper reception of the audio signal which can be caused by wireless networks or cordless phones Either elim inate the interference locate the base unit of the cordless phone in anotherroom set the wireless network to use the 5 8 GHz frequency band rather than 2 4 GHz relocate the transmitter relocate or reorient the receiver to improve reception Also tryto lower the power output of your wireless LAN router Audio willdrop out if there are too many obstacles between the transmitter and the receiver tryrelocating the transmitter or receiver toimprove reception Increase the distance b amp ween the iFinity transmitter or iF inity receiver and your wireless LAN router For up to date troubleshooting advice visit www amphony com User and Installation Guide Technical Specifications Output level 1 Vrms Frequency response 2 Hz 20 kHz Number of wireless audio channels 4 Signal to noise ratio typ 91 dB A weighted Total harmonic distortion typ 90 dB Channel separation typ 90 dB Amphony Page 8
3. er or neglected maintenance This warranty does not cover equipment sold AS IS or WITH ALL FAULTS equipment removal or reinstallation shipping damage if the equipment was not packed and shipped in the manner we prescribe nor equipment purchased serviced or operated outside the contiguous United States of America Page 12 A User and Installation Guide NON USE PERIODS e When the product is not being used for a long period of time unplug the product CLEANING e Unplug the product before cleaning e When the system gets dirty wipe it with a clean soft cloth If necessary wipe it with a soft cloth slightly dampened with soapy water Wipe dry immediately with a dry cloth e Never use benzene aerosol cleaners thinner alcohol or any volatile cleaning agent e Do not use abrasive cleaners as they may damage the finish SERVICE e Do not open the cabinet of any components Opening the cabinets may present a shock hazard and any modification to this product will void your warranty Do not attempt to service the unit yourself Page 11 Amphony User and Installation Guide Pairing the receiver with the transmitter In order to receive audio the receiver must first be paired with your iFinity audio transmitter Press the pairing button of your iFinity transmitter please refer to your iFinity transmitter user manual for further details The transmitter network status light will start flashing quic
4. kly Press the pairing button of your iFinity wireless audio receiver within 5 minutes This button is located at the bottom of the receiver please see picture on next page Once the receiver locks to the transmitter signal the receiver network status light will light continuously You now should be able to hear the audio You can pair up to 4 wireless receivers with one transmitter Pair each wireless receiver as shown above Description of the receiver network status light Flashing Slowly Not paired to any transmitter signal Flashing Quickly Pairing Mode Always On Audio is being received ATTENTION Do not connect the receiver to passive speakers Use the Model 480 Wireless Audio amplifier to connect to passive speakers Page 4 Amphony User and Installation Guide Receiver bottom view Network Status Light Amphony Receiver Pairing Button User and Installation Guide A mphon y IMPORTANT SAFETY INFORMATION ATTENTIONI READ THESE SAFETY INSTRUCTIONS CAREFULLY AND HEED ALL WARNINGS IN THIS MANUAL POWER SOURCE To product malfunction and to protect against electric shock fire or personal injury please observe the following e This product has been designed to work with 120 volt AC current using the supplied AC adapters Connection to a line voltage other than that or use of non compatible AC adapters may create a safety and fire hazard and may damage the product D
5. o not run power cords under rugs or carpets or place heavy objects on them e Damaged or deformed power cords are hazardous and should be replaced immediately by a qualified service technician LOCATION e Do not use this product outdoors or in cars Do not place this product in direct sunlight or near heat sources Keep this product away from strong magnetic objects VOLUME CONTROL Do not turn up the transmitter volume while listening to a portion with very low level input or no audio signal to avoid damage to your speakers during a peak level audio portion e Turn the transmitter volume control to minimum prior to connecting or disconnecting the transmitter or receiver and prior to switching audio sources as this may cause loud clicks which can damage your speakers CARE e Do not place any object containing water or other liquids on this product e Do not remove the cabinet Touching parts inside the cabinet could result in electric shock and damage to the product Page 10 A User and Installation Guide A mphon y Copyright C 2012 Amphony All rights reserved The information contained herein is subject to change without notice Revisions may be issued to advise of such changes and or additions All product names trade names or corporate names mentioned in this document are acknowledged to be the proprietary property of the registered owners FCC ID PMJRX1 This device complies with part 15
6. of the FCC Rules Operation is subjected to the following two conditions 1 This device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation Caution Any changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment Page 9 User and Installation Guide A mphon y Troubleshooting plugged in transm itter or faulty power outlet See under Strong Interference on next page Audio is dis torted Strong interference See under Strong Interference on next page is too low audio output Transmitter volume Adjust the trans mitter volume control to control set too low achieve desired audio level Audio drops out Strong interference See under Strong Interference on next inter mittently or page crackles Unstable power See under Unstable power suppl y supply below Audio drops out Strong interference See under Strong inter mittently or Interference on next page crackles Unstable power Ensure that the power outlet supply delivers a stable vol tage Very strong surges or vol tage fluctuations may cause audio dropouts Tryusing a surge pr ector Page 6 User and Installation Guide Amphony Transmitter range is extremely short Transmitter affects wireless LAN speed Strong interference Too m
7. ration of an implied warranty so those limitations may not apply to you Note No responsibility is assumed for the presence of interference outside of Amphony s control such as other transmitters or cordless phones which may hamper proper signal reception Contents Unpacking Selecting the audio Channels _ ii Connecting the receiver ii Placing the receiver lt il ii Troubleshooting Technical specifications Safety information Limited Warranty User and Installation Guide Note This product requires an iFinity Audio Transmitter for operation not included Unpacking Check that this package contains One iFinity Wireless Audio receiver one 9 V AC adapter wallwart one dual RCA cable Connecting the receiver Connect the DC power input of the receiver with the supplied 9 V AC adapter wallwart Connect the receiver to active loudspeakers active subwoofers or an audio amplifier via the supplied RCA audio cable ity Receiver AC adapter Power outlet Audio Input Page 3 Active speaker Amphony Limited warranty WHAT YOUR WARRANTY COVERS This warranty extends only to the original user of the equipment you your and is limited to the purchase price of each part Amphony and its affiliated companies we our us warrant this Wireless Audio Receiver again
8. st defects in materials or workmanship as follows LABOR For a period of ninety 90 days from the original date of purchase if we determine that the equipment is defective subject to the limitations of this warranty we will replace it at no charge for labor We warrant any such work done against defects in materials or workmanship for the remaining portion of the original warranty period PARTS For a period of one 1 year from the original date of purchase we will supply at no charge new or rebuilt replacement parts in exchange for parts we determine are defective subject to the limitations of this warranty We warrant any such replacement parts against defects in materials or workmanship for the remaining portion of the original warranty period Note Parts means items included in this package It does not include other parts purchased separately WHAT YOUR WARRANTY DOES NOT COVER This warranty does not cover consumer instruction physical setup or adjustment of any consumer electronic equipment or signal transmission problems This warranty does not cover cosmetic damage damage due to the affixing of any attachment not provided with the product loss of parts connecting the product to any but the specified receptacles lightning electrical surges fire flood or other acts of God accident misuse abuse repair or alteration by other than authorized service personnel negligence commercial or institutional use or improp

Audio Receiver

Contents

Download Pdf Manuals

Related Search

Related Contents