Twin Eagles Premium Grills LP to NG Conversion
Contents
1. WITH THEIR ORIFICES INSIDE THE BURNERS AIR SHUTTERS If not properly installed gas may leak outside of the burner that could lead to fire potential damage to your grill and bodily injury b Infrared Rotisserie Burner i Remove rear hood cover to expose infrared burner gas orifice at Defining the Art of Outdoor Cooking ii Remove rotis burner orifice as follows GAS CONVERSION KIT FROM LP TO NG P N CKNG TEBQ 1 57 for TEBO 30 TPBQ 30 2 56 for TEBQ 42 TPBQ 42 ili Replace rotis burner orifice with 1 Orifice 50 for 30 grill TEBQ 30 TPBQ 30 2 Orifice 48 for 42 grill TEBQ 42 TPBQ 42 iv Replace rear hood cover FOR MODELS TWIN EAGLES GRILLS TEBQ TPBQ fay Replace LP regulator with the factory supplied NG regulator a Disconnect the regulator and hose from the LP bottle b Remove the brass coupling from grill manifold c Install regulator directly to grill manifold pipe Make sure that the arrow mark on the regulator is pointing towards the grill 7 d Check for gas leaks using soapy water solution 6 NEVER USE THE GRILL WITHOUT FIRST LEAK TESTING THE GAS CONNECTION o m a Prepare a leak testing solution of sudsy water by mixing in a spray bottle with half liquid soap and half water b Confirm that all control knobs are in the OFF position _ kho c Turn the main gas valve supply ON d Apply leak testing solution by spraying on the pipe joints fittings and hose 1 Al2. e flame ii Remove briquette trays e Perform leak test on the valve stem using the soapy water solution iii Remove prill burners 8 The conversion is complete Fill up the Conversion Label Next paste it next to the original Serial Plate 9 The unit is ready for installation Please refer back to the User s Manual to insure safety proper care and iv Remove grill burner orifices 53 drill size operation v Replace grill burner orifices with 41 drill size vi Install back the burners briquette trays amp cooking grates WARNING IT IS CRITICAL THAT THE GAS BURNERS ARE PROPERLY INSTALLED PN 18567B 04 11
3. l gas connections conversions should be made by a qualified technician and in accordance with local codes and ordinances e A gas leak is detected if 2 Before conducting a conversion to a gas appliance verify that the main gas is shut off and disconnected 1 there is a faint gas smell and or from the appliance ii growing bubbles appear on any of the connection points and or hose DO NOT 3 Insure that you have the Natural Gas Conversion Kit as follows attempt to ignite the grill and IMMEDIATELY turn off the gas supply valve a P N 15110 41 Orifice 41 NG Grill Burner 3 pes f When there is a gas leak call a qualified service technician DO NOT use the grill until the leak is corrected b P N 15108 50 Orifice 50 Rotis Small IR for TEBQ 30 TPBQ 30 NG 1 pc 7 Calibrate burner low flame setting c P N 15108 48 Orifice 48 Rotis Large IR for TEBQ 42 TPBQ 42 NG 1 pc a The grill must be hooked up to the gas supply in order to calibrate burner Ge EN See eee Ora ae ne b Turn on burner and set to low At low setting all ports of the burner must remain lit If the e P N 18351 Label Conversion Gas 1 pc flames are too high or too low calibrate burner valve 4 Replace burner valve orifices c To calibrate burner valve pull off valve knob Insert a skinny flat screwdriver into the valve l stem S d Turn the adjusting screw inside the stem clockwise to decrease flame or counter clockwise to i Remove cooking grates increas
Download Pdf Manuals
Related Search