installation manual rear parking assist sensors
Contents
1. MITSUBISHI GENUINE ACCESSORIES a Drive earth PART NUMBER APPLICABLE MODEL 34 OUTANDER INSTALLATION MANUAL REAR PARKING ASSIST SENSORS Thank you purchasing MITSUBISHI genuine PARKING SENSOR SYSTEM This manual ex plains the procedure for instoling PARKING SENSOR SYSTEM Read this manual thoroughly Belore installation to ensure proper work BILL OF MATERIALS 1 Wire Harness 1 25 Module 10 Seaso Clips 4 wa E be LES O thine Caryaiate pe x SD vin gt TP oral Taecnerata cometa gee pres a se FE 5 4 2 BEFORE INSTALLATION Disconnect NEGATIVE terminal LINE COLOR None 2 ine 3 Orange Black Line Blue Whiteline 5 Red White 2 5 Yellow Green Line Use 42088 thick white wire BACK LIGHT MI Function inspection Troubleshooting Symptom Possible Cause Confirmation Method Solution When the gears shif2. ach sensor functions properly Connect the plug of each sensor properly and replace any damaged sensors with The sensors hamess has not been connected to the ECU Confirm whether the harness has been connected properly Connect te plug ofthe harness to the ECU 16 The gear the warning does not off although there are objects behind the vehicle One of the sensorsis damaged Tonf rm whether each sensor functions properly Replace any damaged sensor with anew one The objects are outside the range of detection Refer to the sence manual for the range of detection The warning does not off when objects are outside the detection area ECU is damaged Confirm whether the ECU is damaged Replace ECU witha The gear the warning goes off although there is no object behind the vehicle for a whi The sensor surface covered with foreign materials such as mud water drops etc Confirm whether the sensor surfaces covered with foreign materials lean up the sensor surface and see fit functions normally One of the sensorsis damaged Confirm whether each sensor functions properly place any damaged sensor with anew one The gear isin Wand the warning goes off intermittently although there is no object behind the vehicle The sensors are not led inthe proper positio
3. n Confirm whether the sensors are installed in the proper position Reinstall the sensorsin the proper position The sensors have detected harsh roads Confirm the road condition possible when the system detects harsh roads or small objects on the road The vehicles posture 5 weighted heavily to side Confirm the vehicles posture Misdetection may occurif the vehicle is heavily weighted in the rear or at the cusp of a steep indine Refer to service manual for figure Product specification Noms Speciication Rated Voltage pe 120v Operation Voltage DC94v Operation Temp tore Toe Storage Temp GENUINE PARTS MITSUBISHI MOTORS Drive earth SET PRINTER TO ACTUAL SIZE or NONE NOT SCALE OUTLANDER REAR PARK ASSIST TEMPLATES MODEL YEARS 2007 ON REVERSE FOR RIGHT SIDE OUTLANDER T Corner 0 20 10 0 Unitimmi ALLIGN WITHTHICKEDGE 50 49 30 20 10 vu 3908
4. ted to R the alert does not beep The buzzer plug has not been inserted Confirm whether the buzzer plug is inserted Insert the buzzer plug correctly Taillight power wire has not been spliced correctly Check if reverse ante are on or that the thick white wire has been spliced Splice the thick white The fuse to the ECU have blown Check whather the fare has been blown Replace the fase witha ECU is damaged Confirm whether the ECU is damaged Replace ECU witha When the gears shifted to R the alert beeps twice not once One or more of the sensorsis not connected properly Confirm whether the sensors are properly connected Connect te plug of each sensor properly One of the sensors may be damaged Confirm whether each sensor functions properly Replace any damaged sensor with anew one When the gears shifted to R the alert beeps three times Two of the sensors are not connected properly or may be damaged Confirm whether the sensors are properly connected and whether each sensor functions properly Connect the plug of each sensor properly and replace any damaged sensors with When the gears shifted to R the alert beeps four times Three or more of the sensors are not connected properly or may be damaged Confirm whether the sensors are properly connected and whether e
Download Pdf Manuals
Related Search