Subaru Valve Spring Compressor Manual
Contents
1. WWw company23 com www COINpDAi yig gy Com SPECIAL NOTES e The use of a factory service manual is highly recommended These can be purchased at the dealer or dow nloaded online at http techinfo subaru com e Company23 is not responsible for damage done to your vehicle as a result of misuse of this product e Company23 does its best to ensure the accuracy of this manual but is not responsible for errors e WARNING Never use the camlock tool to remove the camshaft sprocket bolt VALVE SPRING TOOL OPERATING INST RUCTIONS Step 1 You can use the Company23 valve spring compressor tool w ith the cylinder head on the engine in the car or on the engine stand or with the head on the bench In order to remove the valve springs you must remove the valve cover the camcaps the cams and the buckets and shims if applicable Your head should look like the below image Step 2 Using the cam cap bolts from your engine install the Company23 valve spring tool block on the head Make sure the head and tool surface is clean Tighten bolts to 7 ft b 1 kgf m 10 N m You will be able to compress tw o valves in each location you install the valve spring tool block Step 3 Thread the tool stud into the threaded hole with the internal 5mm hex on top Install the spring cage under the stud as show n Step 4 Using a 5mm hex wrench or socket turn the stud clockw ise to compress the valve spring Ensure the spring Cage w indow is poin2. ting outw ards Only compress the spring enough to free the keepers Pro tip If you are doing this w ork with the cylinder head still installed on the engine it is important to prevent the valve from dropping into the cylinder Twocommon techniques are to insert clean rope and fill the cylinder via the spark plug hole or to pressurize the cylinder w ith an air compressor and an air fitting via the spark plug hole ff you use the rope technique make sure to leave enough rope out of the spark plug hole to allow removal i A te A pAn Step 6 Using a 5mm hex wrench or socket turn the stud counter clockw se to relieve the valve spring tension Unthread the stud all the w ay to allow the valve spring compressor cage to be removed Step 7 You can now remove the spring and retainer This will allow the valve and or the valve stem seal to be removed and installed For Questions amp comments please contact sales company23 com 5
Download Pdf Manuals
Related Search