SERVICE MANUAL
Contents
1. Mid SERVICE MANUAL Models 230 260 280 230 260 280 Dimentions WxHxD mm 540x1169x634 540x1440x634 540x1600x634 SUPPORT WHITE GOODS ASSEMBLE 8 DISASSEMBLE A Changing The Door Swing Direction to Right Hand 2 Dismantle the refrigerator and freezer door from cabinet by pulling towards to you together with the middle hinge Fig 2 1 Remove the freezer door panel caps Unscrew the two screws which are fixing the middle hinge Fig 1 Freezer door panel right cap Freezer door panel left cap f Pre Pull the doors towards to you with middle hinge S Unscrew the two middle hinge screws Figure 1 Figure 2 3 Lie down the appliance to the left side Dismantle both leveling feet and unscrew the bottom hinge fixing screws and remove it Fig 3 Unscrew the bottom hinge pin and screw in the next hole Fig 4 Then screw the hinge to the left side of the refrigerator Screw the both leveling feet Figure 3 Figure 4 1 DECEMBER 2011 VESTEL WHITE GOODS DOUBLE DOOR 230 260 280 CUSTOMER SUPPORT 4 Remove the two big caps on the middle bracket Unscrew the two screws fixing the top hinge and remove it Remove the top hinge screw left cap on the left side Remove the middle hinge screw cap big on the right side Fig 4 a Rotate the top y hinge pin by 180 Figure 5 6 Assemble the top hinge to the2. Check the over load windings might be compressor thermostat is any thermostat relay faulty or there might replace if according to leakage by settings group mechanical jamming there is seasonal the help of Adjust the 009 problem with conditions foam Fix thermostat Check the pressure and Charge according to compressor replace the gas again seasonal if needed conditions Check all pipes tubes and welding points against gas leakage Before charging gas to system change dryer and vacuum at least 30 minutes then charge the system with amount written on label Compressor primary winding should be around 10 Q and secondary around 15 at 25 C ambiance temp 7 DECEMBER 2011 VESTEL WHITE GOODS DOUBLE DOOR 230 260 280 CUSTOMER SUPPORT Excessive Cooling Is the thermostat setting appropriate to season conditions No Yes Is there any icing formation in refrigerator section No Yes Set thermostat to a lower setting did thermostat cut out Compressor stops running Yes Check the thermostat bulb does it touch the end of the pipe If not push the bulb until end No ok No Check the temperature values of fridge section Are they normal Yes Adjust the thermostat Inform the customer No Replace thermostat TROUBLE SHOOTI
3. left side Fig 6 Insert the two middle hinge screw caps big to the right side of the middle bracket You can find the new caps in the user manual bag Insert the middle hinge screw cap big to the left side You can find the cap in the user manual bag Insert the top hinge screw right cap to the right side You can find the top hinge screw right cap in the user manual bag ASSEMBLE amp DISASSEMBLE Remove the middle hinge screw cap big Remove top hinge screw 46 left cap S S Unscrew the top hin Remove the two op ge middle hinge screw caps big f Figure 4 5 Unscrew the screw fixing the top hinge pin Turn the pin by 180 then fix it to the top hinge by screwing it Fig 5 Insert the top hinge screw right cap Insert the middle DS hinge screw cap big e A p Insert the two middle hinge screw caps big here Figure 6 DECEMBER 2011 WHITE GOODS ASSEMBLE amp DISASSEMBLE SUPPORT 7 Replace the top bushing and top bushing cap Fig 7 You can find the new bushing cap eng in the user manual bag s Remove the bottom bushing bottom stopper and then assemble the bottom bushing bottom stopper to the left side Fig 7 de REFRIGERATOR DOOR 4 BOTTOM STOPPER Figure 7 te 8 Remove the top bushing and insert it into left 1 hole Fig 8 Unscrew the screw fixing the freezer door stopper right on the
4. NG CHART Is thermostat connections Correct the thermostat connections Adjust the thermostat according to seasonal conditions Is the icing at the whole of back wall on serpentine No Yes Compressor pressure might be low or there might me clogging at the system Check the gas and pressure level If there is clogging clean the system and gas charge again Yes Replace thermostat DECEMBER 2011 VESTEL WHITE GOODS DOUBLE DOOR 230 260 280 CUSTOMER SUPPORT TROUBLE SHOOTING CHART Door Gasket Adjustment Is the ground under the unit is flat No Yes Are the adjustable feet in correct position No Yes Is there any misalignment at hinge axis or loose screws No Yes Correct the axis and tighten the screws Product should be on a firm and flat surface Adjust the feet properly according to ground surface As a service solution add 3 washers between Is the form of gasket deformed No the door bottom and hinge Correct the gasket form with hot water Check after correction Is the gasket closing properly If the gasket is changeable replace the gasket if not replace the door Heavy foods drinks on the door shelves must be shifted to the hinged side Correct the gasket form by the help of hot water and ha
5. ir dryer 9 DECEMBER 2011 DOUBLE DOOR 230 260 280 CUSTOMER WHITE GOODS TROUBLE SHOOTING CHART SOC OR Abnormal Noise Product should be on a firm and flat surface Is the ground under the unit is flat Adjust the feet Are the properly adjustable according feet in correct to ground position surface Are capillary or other Pipes should not touch any other surfaces compressor feet Tighten the loose compressor feet loadside pipes touching somewhere Is there bitumen on the capillary Vacuum the system and make gas charge and on the place that capillary leaves the heat exchanger Place the bitumen on capillary and on point that capillary leaves the heat exchanger 10 DECEMBER 2011
6. is off on this setting e By turning the knob between 1 and 5 you can increase or decrease the cooling degree e The refrigerator is designed to get optimum performance when the thermostat knob is set between position 2 to 4 5 DECEMBER 2011 DOUBLE DOOR 230 260 280 ae WHITE GOODS REFRIGERANT CYCLE DIAGRAM SUPPORT F EVAPORATOR HOT PIPE CONDENSER E X lt T N zi Aa lt O 6 v E LI 5 z 1 1 O a O lt if e a SUCTION PIPE gt gt COMPRESSOR 14 14 Slle s he D LI LLI re E E o ila E lt g LL Z A LU ij Z X Lu gt y O O O a Q H or a a a Z O O lt lt lt 5 O Q T O T l 5 O u a D O LL 14 8 DECEMBER 2011 No Insufficient cooling Inform customer 220 240v Check the voltage at compressor terminals Is the power consumption of compressor No Yes Is compressor working Is the thermostat ok There migh be clogging Evacuate the system Charge the gas agai Break the service pipe is there any gas evacuation Replace the thermostat Is over load relay ok Check thermostat connections Is it working normally Replace Compressor Check the Adjust the Check if there
7. right side and remove it Than assembly the freezer door stopper left FREEZER on the left side Fig 8 DOOR You can find the freezer door stopper left in the user manual bag F DOOR STOPPER _s F DOOR STOPPER LEFT Figure 8 3 DECEMBER 2011 DOUBLE DOOR 230 260 280 CUSTOMER WHITE GOODS ASSEMBLE amp DISASSEMBLE SUPPORT 9 Turn the middle hinge by 180 Assemble the freezer door and refrigerator door together with middle hinge Reverse operation of item 2 Fix the middle hinge by tighting the screws Fig 9 And insert the freezer door panel caps Turn the middle hinge 180 Figure 9 DECEMBER 2011 WHITE GOODS ASSEMBLE 8 DISASSEMBLE SURPORTI B Changing The Thermostat Remove the lamp cover and unscrew the fixing screw Remove the screw cap and unscrew the fixing screw Remove the thermostat box by pulling it and disconnecting the wire connector Remove the thermostat knob by pulling forward Loosen the nut fixing the thermostat 5 Pull out the thermostat bulb from the housing 6 Replace the thermostat with a new one and assemble the thermostat box following the steps backwards C Thermostat Knob e This knob is used to control the temperature of the freezer and refrigerator parts automatically It can be set to any value between 0 and 5 positions e Q position indicates that the thermostat is off The refrigerator
Download Pdf Manuals
Related Search