BULLSEYE Smart Control Quick Start Guide
Contents
1. Smart Gontrol QUICK Start GUIade P BULLSEYE Smart Control Quick Start Guide gt ARAN AAA ARANA gt mu k i E a E x i i eE Step 1 Remove safety glasses from kit and put them on in order to protect your eyes i er a Step 3 Install red and black power lead to smart Step 4 Connect Power lead to vehicle battery control bottom banana jacks red to red red to positive battery terminal and black to black to black negative battery terminal NO Fa TOMLADO SATWA LITA 3er Step 5 Make sure that the red power lamp is on Step 6 Take out the yellow lead and connect indicating the smart control has power and is ready lead to yellow banana plugs on top of the smart to use NOTE if the fuse located on the bottom of control unit the smart control is blown the power lamp will not be on BULLSEYE Smart Control Quick Start Guide Step 6 Connect the yellow leads to the yellow back probes Step 8 Turn on the vehicles ignition key to the on position do not start the engine lt is a good idea to connect a battery maintainer or battery charger to insure the battery voltage is stable for the entire testing time Step 7 Now back probe the vent solenoid The vent solenoid will have two wires power and control either back probe can be connected to either vent solenoid wire The vent solenoid is normally open and will have to be closed to seal the fuel containment system to2. N I i i re i d e S we i A Step 13 Take out the blue lead and connect lead to blue banana plugs on top of the smart control unit BULLSEYE Smart Control Quick Start Guide y T Muge i Activation GE en a Step 15 Now back probe the purge solenoid Step 16 Once all testing is finished actuate the The purge solenoid will have two wires power purge control so the pressure in the fuel and control either back probe can be connected containment system is dumped in to the intake to either purge solenoid wire The purge solenoid manifold of the engine NOTE this may cause is normally closed Open and close the purge a hard start condition control valve and watch to see if the pressure is stable or leaking after the valve is actuated Note the purge solenoid is usually close to the intake manifold on the engine Pg 4
3. test for leakage Note the vent solenoid is usually close to the carbon canister Additionally not all vehicles will have a vent solenoid Some may have pumps in which the inlet or outlet will be plugged using the red cap plugs from the bulls eye kit if the unit has more than two wires consult a service manual Step 9 If the back probes are connected to the solenoid wires the green connected A lamp and connected B lamp will be on If one or both lamps are not on check the connections at the solenoid make sure there is power supplied from the vehicle to the solenoid additionally if the fuse s in the smart control is blown the lamp will not be on these are located on top of the smart control box next to the yellow banana plugs BULLSEYE Smart Control Quick Start Guide Step 10 To actuate the solenoid push the red on button and to un actuate the solenoid push the black off button wi en gt Step 12 Actuate the vent valve in order to close it now open the low pressure regulator shut off valve so the CO2 will pressurize the fuel containment system Step 14 Connect the blue leads to the blue back probes Step 11 If the fuel containment system has more pressure than 15 of H20 the vent valve may not open This means if you are testing the valve to see if it can open and close and still seal the test must be done with less than 15 H2O in the system i a e i A i i Pe m
Download Pdf Manuals
Related Search