Door Swing Hdw 8.1
Contents
1. SWINGING DOORS HARDWARE MULTI POINT LOCK SYSTEM AFTER 5 10 99 AMEROCK MARVIN Windows and Doors Built around you YOU WILL NEED TO SUPPLY Lock System Installation Safety glasses Phillips screwdriver 7 Check passage latch orientation before installing Flat blade screwdriver mortise lock in panel The beveled side of the passage latch must face the exterior of the door and be closest to the panel bottom as shown in illustrations 2 and 3 If Lock System Removal the beveled side of the passage latch is facing the wrong direction simply disengage passage latch by activating the release on the mortise lock using a Phillips screwdriver as shown in illustration 3 Rotate passage latch 1 2 turn to correct orientation and engage by pushing latch fully into mortise lock and NOTE When operating multi point lock the door panel should be upright installed position This will enable the lock mechanism to operate without false binding 1 Open and detach panel from hinges DO NOT attempt to releasing A distinctive click will be heard See remove adjustable hinge pins they are not removable illustration 3 lay on edge locking stile up on a clean level surface 8 PI rtise lock i f latch i Take appropriate precautions when handling do not Spe eed Oer N pangs EnSunng passage ateis oriented as described in previous step Fasten screw damage frame panel or floor at top of mortise lock Replace mortise lock cover 2 Remove2. ce Manual 11708609 SWINGING DOORS HARDWARE MULTI POINT LOCK SYSTEM AFTER 5 10 99 AMEROCK IMPORTANT During the next steps the panel MUST be held firmly in place on the hinge edge with locking stile up 10 Wt 12 13 14 15 16 Activate head foot bolt mechanism by depressing safety trigger and lifting handle Slide rod into stile guide into mortise lock receiver Apply slight pressure against end bolt to hold rod Rotate clockwise to engage threads in mortise lock Locking rod should be fully tightened in 5 6 turns Ifnot reposition rod and repeat procedure Repeat above for top locking rod Rounded tip on end bolts should be orientated so ramp is to the interior of panel Check lock operation To avoid false binding tip panel upright as installed and support off floor 2 51 This will give bottom rod assembly clearance to extend Depress safety trigger and operate multipoint latch handle several times retract end bolts Lay panel on hinge stile edge Check to ensure end bolts are properly adjusted install end bolt guides Replace panel check alignment with frame also check latch end bolt and dead bolt operation Adjust as needed 2 2005 8 1 7 MARVIN Windows and Doors Built around you Marvin Service Manual 11708609
3. end bolt guide from top and bottom of panel Fasten to stile with screws by hand with a Phillips See illustration 1 screwdriver DO NOT use a power driver See illustration 2 3 Unthread bottom locking rod end bolt assembly from sabia mortise lock pull from stile See illustration 1 9 Align and reapply exterior and interior handle assemblies fasten with machine screws using a Phillips screwdriver DO NOT use a power driver Top locking rod PY re Interior la Locking stile Lila handle assembly Exterior gt multi point handle assembly i a Bottom locking rod oo aie End bolt eo w End bolt g Cutaway for Ne guide Active l illustration ae h pane 1 Screw me mortise purposes lock N Cu is Bottom rail Sin Exterior handle a Le 8x 1 assembly oe wood screw A Locking stile 2 Bottom locking rod 4 Repeat steps 2 and 3 on top locking rod end bolt assembly x 5 Remove handle assemblies from interior and exterior of panel See illustration 2 9 kA Ss 6 Remove Phillips flat head wood screws securing mortise p p lock cover plate from panel edge lift from stile mortise Remove screw at top of mortise lock and lift assembly from stile See illustration 2 l aN ry cp p 7 N Y Y 19970072 3 2 2005 8 1 6 Marvin Servi
Download Pdf Manuals
Related Search