`GEN-3` Power Cooler
Contents
1. SAR PERFORMANCE EA amp MNES GEN 3 Power Cooler PART RS1752 PC I We strongly recommend the use of a service manual to familiarize yourself with the various components and procedures involved with this installation Please note that some of the original clamps hoses and hardware removed in the disassembly process will be used in the installation process These instructions have been written in step by step format and refer to illustrations We suggest reading through the instructions entirely before performing installation Please follow these step by step instructions and illustrations carefully APPLICATION S Sea Doo models utilizing RIVA GEN 2 Power Cooler Kit and 2008 10 models utilizing OEM intercooler xxx ALLOW ENGINE TO COOL COMPLETELY BEFORE PERFORMING INSTALLATION xxx Required Specialty Tools Part OEM Service Manual Please Call INSTALLATION INSTRUCTIONS Remove bolts 2 and reusable clips 2 securing decorative cover to top of grab handle RXT X moving deck Remove rear boarding platform Remove rear storage buckets RXT X fixed deck Remove rear access panels 2 RXP X 260 Remove side covers 2 bolts each side Word doc Part RS1752 PPC I H1 12 11 12 RXP X 260 continued Remove bolts 1 at rear and reusable clips 4 at front 1 Exhaust connection between water box muffler securing decorative cover to outside of grab handle and exhaust outlet Remove and save2. blowing out motor afterwards IMPORTANT MAINTENANCE TIP To assure optimal performance extra care must be used with flushing the cooling system after riding After flushing craft using stock Sea Doo flush kit you must flush the RIVA Power Cooler using the supplied flush kit When doing so we strongly recommend the use of a salt deposit remover such as Salt Away which can be purchased through RIVA Racing s parts department When flushing with a salt deposit remover do not flush with fresh water afterwards Allow salt deposit remover to remain in cooling system This will prevent build up of salt and or mineral deposits from water left in cooling system that could clog intercooler core Your Power Cooler is equipped with a sacrificial anode This should be inspected at the beginning and end of each riding season Replace as needed by contacting RIVA Racing s parts department NOTE Apply pipe thread sealant when replacing Do not over tighten Remember the water belongs to everyone Please ride responsibly and respect the environment Technical Support For answers to questions regarding installation or trouble shooting RIVA Performance Products contact RIVA Technical Support directly at 954 247 0705 or by e mail at tech _support rivamotorsports com Limited Warranty RIVA GEN 3 Power Coolers carry a 90 day limited warranty to the original purchaser They are warranted to be free of defects in materials and workmanship under normal
3. C I H1 12 11 12 Secure bilge siphon hoses 2 to Power Cooler using supplied zip tie Connect intercooler air inlet and outlet hoses to Power Cooler NOTE Do not over tighten clamps 2012 amp Newer Craft Install supplied T fitting into Power Cooler flush hose and secure with supplied 21 0 Oetikers Connect stock 1 4 vent hose and secure with stock clamp NOTE Do not over tighten clamp 2008 2010 craft equipped with OEM intercooler Follow intercooler vent hose down to thru hull fitting Remove and install supplied block off onto thru hull fitting Secure with stock clamp NOTE Do not over tighten clamp Craft equipped with RIVA GEN 2 Power Cooler Follow intercooler vent hose down to T fitting in exhaust cooling line Replace T fitting with supplied brass 3 8 barbed hose splicer NOTE Do not over tighten clamps RXT X moving deck Replace rear storage buckets and rear boarding platform RXT X fixed deck Replace rear access panels 2 RXP X 260 Replace rear grab handle Check bilge for tools rags etc Run craft on a flush kit to check for proper operation FLUSHING INSTRUCTIONS e RIVA Power Cooler must be flushed independently of motor using supplied flush kit fitting This can be done before or after flushing motor using stock Sea Doo flush point e Engine must be running when flushing RIVA Power Cooler e Do not over rev engine when flushing or
4. clamps 2 Supercharger to intercooler hose discard 3 Intercooler to throttle body hose discard orrionese i All models Disconnect intercooler air inlet and outlet hoses from intercooler w Remove coolant overflow reservoir Remove grab handle 6 bolts Disconnect straps 2 securing intercooler to hull SSS o m gt iw 2013 amp Newer Models Disconnect Intercooler Vent Hose Word doc Part RS1752 PPC I H1 12 11 12 Disconnect water inlet and outlet hoses from intercooler NOTE Mark each hose before disconnecting A WATER OUT PRESS ie 4 7 A VG fa ee gt o a PE Fi a P N DJA ee d s a 2 4 7 A g do a A P FE es l E ie d ie a7 P I a N WATER IN i l a 4 gt sat g E ME an gt N O Remove intercooler For RXT X S3 hull models intercooler can be removed through openings at rear of craft by carefully rotating as you guide it out either side Place supplied GEN 3 Power Cooler in hull For RXT X S3 hull models intercooler can be installed through openings at rear of craft by carefully rotating as you guide it in either side Secure water inlet and outlet hoses to GEN 3 Power Cooler WATER OUT N ES Ka lt ad ME 4 2 gt d l 4 i Pe i Ensure stock rubber pad is in place under Power Cooler Secure Power Cooler in place using stock straps 2 Word doc Part RS1752 PP
5. lacement parts will be returned freight collect Word doc Part RS1752 PPC H1 12 11 12 4
6. use and service Customer modified components will be void of warranty This warranty is limited to defects in the primary components only Finish and or wear marks in or on primary components are not covered under this warranty RIVA Racing s liability is expressly limited to the repair or replacement of the components contained within or associated with this kit RIVA Racing agrees to repair or at RIVA s option replace any defective unit without charge if product is returned to RIVA Racing freight prepaid within the warranty period Any equipment returned which in RIVA s opinion has been subjected to misuse abuse overheating or accident shall not be covered by this warranty RIVA Racing shall have no liability for special incidental or consequential damages or injury to persons or property from any cause arising from the sale installation or use of this product No other warranty express or implied including but not limited to the implied warranties of merchantability and fitness for a particular purpose applies Various states do not allow for the limitation of incidental or consequential damages and therefore the above exclusion or limitation may not apply to you Warranty does not include the expenses related to freight or transportation of parts or compensation for any inconvenience or loss of use while being repaired A copy of the original invoice and a Return Authorization Number RA must accompany all warranty claims Warranted rep
Download Pdf Manuals
Related Search