Knock Sensor
Contents
1. Smee z STANDARD MOTOR PRODUCTS EUROPE Safety N STR U CTI O N S Knock sensors are located on the engine in locations that can get very hot Ensure that the vehicle has cooled to a safe level before attempting to renew the sensor Removal Disconnect battery i Disconnect the sensor s electrical Please Read These First connection Unclip the sensor s wiring loom as necessary Unscrew locating fixings and remove the sensor These instructions are intended as a guide only and are not a substitute for a workshop manual The fitter must have a degree of mechanical competence If you are in any doubt as to your ability to fit the part do not undertake the job Note Check the electrical connector for signs of corrosion damage Fitting the new sensor Ensure that the sensor s mating surface is clean and free from corrosion this is a common failure point Refit new sensor tighten to original P factory torque settings do not over register your warranty online visit tighten Do not use thread lock lubricant For more Technical Tips and to Route the wire in its original position WWW SMm pe co U k ensure that it will not foul any moving parts and that it is routed away from any high tension electrical wires and re secure the wiring loom Reconnect the sensor Reconnect the battery Follow the procedure outlined in your Contact technical sales on vehicle s service manual to clear any fault co2. des that may have been set O 527 839307 you may need to use a fault code reader or specialist equipment Failure www smpe co uk uelParts gt Intermotor Z 2S SMPKNS01 1 to do this may cause the computer to register a fault and stay in limp home mode which may damage the catalytic converter and other emission devices
Download Pdf Manuals
Related Search