1.2 ) Guarantee information OSMA is not responsible for damages
Contents
1. into the steel panels is maintenance free An operation time of 1 3 hours is adequate for shoes and boots varies according to degree of wetness The built in clock timer allows individual operating times 5 Transport and storage e During transport the unit must be secured from dislocation and shifting and protected from adverse weather conditions e If the dryer cannot be installed directly after delivery it should be stored in a clean dry place and protected against damage dirt and moisture 6 Service manual Rectifying faults The OSMA Shoe Boot and Glove Dryer is maintenance free Should however faults or problems occur with the product please call your local specialist dealer Assembly instruction ozrg 7 Disposal Taking out of operation The panels can be recycled when professionally disposed of and are therefore environmentally compatible Details of disposal and recycling are shown in the table below ATTENTION Never attempt to open the appliance alone Repairs may only be carried out by trained and qualified service staff Pp mS OSMA SCHUAHTROCKNER Product_ ___Materials__ __Disposal_ steel separating constructio n recycling by metal parts smelting motors metals down Getriebe screws protective recycling caps burning casings plastics or disposal in covers special etc dumps cables rubber PVC separating casings silicon materials plugs polychloro2. 1 General information Thank you for choosing an OSMA product e This operating manual was originally written for German speaking countries and users and has been translated from the German into English e Do not expose flammable or sensitive parts e g plastics electrical parts and cables to sparks or open flames as this presents a fire hazard with formation of harmful gases and can cause damage to insulating materials e Avoid contact with concentrated acids or caustic solutions as these can cause dangerous metal corrosion If necessary affected parts should be replaced as soon as possible e Care must be taken not to cover suction holes 1 1 Correct and intended use of the product The OSMA Shoe Boot and Glove Dryer is intended solely for the purpose of drying shoes boots and gloves In the case of improper handling or misuse of this product the manufacturer s guarantee automatically loses its validity 1 2 Guarantee information OSMA is not responsible for damages caused by false usage or improper handling OSMA does not accept liability to third persons Changes to components or elements without the manufacturer s consent and incorrect installation not in accordance with the manufacturer s instructions will lead to loss of the guarantee 1 3 Directives The OSMA Shoe Boot and Glove Dryer has been manufactured according to European and German standards laws regulations and guidelines and shoul
3. d be operated accordingly However when installing the product the specific local or national electro technical regulations applicable to the country in question must be complied with 2 Technical data Type family2 Serial no model Material Sheet steel powder coated in RAL colours or in high grade steel Dimensions width height depth in mm 235 660 370 Weight ca 9 kg Warm air blower and heating cable output 65 watts Voltage Frequency 230 volts 50Hz Design The shoe dryers differ only in dimensions All drying panels are powered by the same maintenance free blower type and heating cable Maximum connected load 75 Watts Electrical voltage 230 V plug 3 Installation e Installation instructions please see installation kit e Only use the installation material supplied e OSMA TrockNERsysteme are supplied ready to plug into 230 V 50Hz Installation instructions in dry rooms 1 OSMA high grade steel panels for wall mounting can be installed at variable heights on even surfaces 2 Use only original installation material provided screws wall plugs etc 3 Carry out trial run only after tightening all 4 anchoring Screws 4 Operation Dry rooms OSMA high grade steel panels with warm air blower for dry rooms can be operated directly by the clock timer It is neither necessary nor possible to regulate the temperature or strength of the blower as this is done automatically The blower built
4. phen recycling f etc Aa e electronic plastics special parts metals disposal in electrolytes accordance with locally authorized i directives i Packing regulation ARA licence no 13068 Non liability agreement for electrical appliances ERA 50558 Varnished and painted parts should be recycled according to the materials used or disposed of at special dumps in accordance with locally authorized directives O OPERATING MANUAL for SHOE BOOT and GLOVE DRYER family2
Download Pdf Manuals
Related Search