Installation - Roland Sands Design
Contents
1. ROLAND SANDS DESIGN ASSEMBLY INSTRUCTIONS 5 Remove the pivot bushing from the stock lever and install into the RSD Regulator lever REGULATOR CLUTCH LEVER INSTALLATION Turn your motorcycle off and disconnect the battery 2 Slide rubber boot away from the clutch cable adjuster Using a 9 16 and 1 2 wrench completely collapse the clutch adjuster 6 Remove the plastic anti rattle tab from the stock clutch lever and install onto the RSD Regulator lever NOTE When installing 0062 2058 Clutch Lever for 04 up Sporster models use the provided M4 screw to hold down the anti rattle tab 3 Using a snap ring pliers remove the retaining ring from the pivot pin located on the underside of the clutch pivot housing Save the retaining ring it will be reused 7 Install the RSD Regulator clutch lever plastic clutch cable pivot pin clutch cable main pivot pin and retaining clip Warning 2007 up models are equipped with a clutch interrupt switch Care must be taken during installation to not damage the switch and rubber boot Failure to install carefully and correctly may result in damage to the switch RSD is not responsible for damage caused by improper installation For additional instructions consult the service manual for your specific model 8 Once the RSD Regulator clutch lever is in position adjust the clutch cable Consult the service manual for specific clutch adjustment procedures 9 Adjust your new Regulato2. ROLAND SANDS DESIGN i Jf REGULATOR BRAKE LEVER INSTALLATION d ma OF IERS Turn your motorcycle off and disconnect the battery A 2 Using a snap ring pliers remove the retaining ring from the pivot pin located on the underside of the brake FZ master cylinder Save the retaining ring it will be reused ZO 4 Remove the pivot bushing from the stock lever and install into the RSD Regulator lever RSD Regulator levers for FLH and XL models have a bushing pre installed at the factory 5 Carefully install the RSD Regulator brake lever making sure not to damage the brake light switch and rubber boot APPLICATION BRAKE P N CLUTCH P N 2008 2012 FLH TOURING MODELS 0062 2055 j 0062 2054 S dnes he RSD Aaculator brake leveris e a erna PEREA 996 2012 BIG TWIN 1996 2003 XL SPORTSTER MODELS 0062 2057 0062 2056 Gaia BE errata ice Se Arete ie nel a a A ncn 2004 2012 XL SPORTSTER MODELS 0062 2059 J 0062 2058 7 Adjust your new Regulator brake lever to your sweet spot using the adjuster knob 8 Reconnect the battery and make sure the brake is functional and test the brake light 9 Move on to RSD Regulator clutch lever installation page 2 or go for a ride For questions pertaining to the installation of this product please contact the Performance Machine technical department at 1 800 479 4037 This product is manufactured in the USA by Performance Machine LLC 0048 0839 REVISIONA 3 29 12 PAGE 2
3. r clutch Lever to your sweet spot using the adjuster knob 10 Reconnect the battery and make sure the clutch lever is disengaging the clutch II Go for a ride For questions pertaining to the installation of this product please contact the Performance Machine technical department at 1 800 479 4037 This product is manufactured in the USA by Performance Machine LLC
Download Pdf Manuals
Related Search