User`s Manual
Contents
1. P N 1 81060 Revision G 7 f 8 Preparing for Transport Press the START STOP button to retract the tape into the overhead mechanism Unplug the transformer from the wall and the back of the FLEX MATE S500 Place the hand held controller and the transformer in their respective compartments on the back of the FLEX MATE S500 Be sure the cords are completely tucked away in the cavities provided 3 Push in the silver button on the right upper bar Carefully lower the overhead mechanism down until the bars fit into the plastic clips CAUTION The overhead mechanism is heavy lower slowly to avoid injury Tilt the FLEX MATE S500 back ward until it rests on the rubber bumper on the bottom of the overhead mechanism Pull the locking knobs up then fold the legs up until they fit into the plastic clips Wrap and secure the rubber straps around the legs and vertical bars Cleaning and Maintenance With unit unplugged clean housing and upper and lower frames with mild soap solution and dry thoroughly Refer to the Service Manual for recommended maintenance frequency CAUTION Avoid getting water inside the housing as it may damage the electrical components P N 1 81060 Revision G 8 of 82. from the unit WARNING Maximum rated load is 30 Ibs CONTRAINDICATIONS USE OF CPM THERAPY IN GENERAL SHOULD BE AVOIDED OR DISCONTINUED AT LEAST TEMPORARILY IF SIGNS OF HYPERTHERMIA IRRITATION SWELLING BLEEDING OR INCREASED OR PERSISTENT PAIN ARE OBSERVED ACUTE INFLAMMATORY CONDITIONS SUCH AS ACUTE ARTHRITIS OR DESTRUCTIVE BONE OR JOINT DISEASES SHOULD NOT BE TREATED WITH CPM PRODUCT IS LATEX FREE CAUTION It is important to install and use this equipment in accordance with the instructions to prevent harmful interference to other devices in the vicinity If this equipment does cause harmful interference to other devices which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures e Reorient or relocate the other device s e Increase the separation between the equipment Connect this equipment into an outlet on a circuit different from that to which the other device s are connected Consult the manufacturer or field service technician for help SAVE THESE INSTRUCTIONS P N 1 81060 Revision G 2of8 AN UL C UL Classification with respect to electric shock fire and mechanical hazards only in accordance with UL 2601 1 CAN CSA C22 2 No 601 1 Meets UL 1431 Standards for Personal Hygiene and Healthcare Appliances Product Description The purpose of the FLEX MATE S500 is to provide continuous passive motion to the s
3. 500 from the box and wheel it to where it is to be used 1 To assemble the FLEX MATE S500 2 Raise the overhead pull the legs down be sure the knobs mechanism until the audible click into place click signifies its proper position Use caution a pinch point exists at the hinge The silver button on the right upper bar as you face the FLEX MATE S500 should be visible through the hole in the plastic housing 3 Remove the hand held controller from the back of the FLEX MATE S500 and place it into it s cradle on the front of the FLEX MATE S500 Remove the transformer and plug it into a grounded power outlet Plug the opposite end of the power cord into the FLEX MATE S500 This will turn the power ON P N 1 81060 Revision G 4of8 Hand Held Controller Instructions cn 1 Place a chair under the raised Uaw overhead mechanism Position the chair so when sitting the patient s non involved shoulder is directly under the tape DOWN START Ca 2 With the patient seated in the chair press and release the START STOP button to lower the tape to approximately shoulder level then press the START STOP button again to stop the movement Grasp the S500 Handle with the non involved hand Slide the S500 Handle through the loop at the bottom of the tape Note It is not necessary to attach the S500 Handle straps at this time Press and hold the UP Limit Press the 90
4. CALIBRATION button until the upper arm is button to calibrate the machine parallel to the ground Release the button to stop the movement The patient s non involved upper arm should now be parallel to the ground The patient s shoulder is now at 90 of elevation P N 1 81060 Revision G 5of8 Hand Held Controller Instructions continued 5 Press and hold the DOWN Limit button until the patient s non involved hand reaches shoulder level 6 Reposition the chair and patient to the other side of the FLEX MATE S500 for the involved shoulder The patient is ready to strap the 500 Handle onto the involved hand Wrap strap 2 around the patient s wrist The strap fastens to itself and should not impede circulation Attach strap 3 to strap 2 on the back of the wrist Q L T Slide the S500 Handle Pull the strap over SQ 7 into the loop at the Remove the S500 Handle from the the fingers and bottom of the tape tape Place the palm of the patient s attach the other involved hand directly over the end to the front Palm label 1 on the foam wrap of the wrist P N 1 81060 Revision G 6 of 8 Hand Held Controller Instructions continued 7 Press and hold the UP Limit Button until the display on the FLEX MATE S500 hand held controller reaches the prescribed elevation or until you begin to feel tightness in the involved shoulder
5. FLEX MATE 500 User s Manual KL C Services Inc 4038 Weaver Court East Hilliard OH 43026 Phone 614 921 8866 Fax 614 921 8877 Toll Free 866 532 3534 P N 1 81060 Revision G 1 of 8 FLEX MATE 500 USER S MANUAL IMPORTANT SAFEGUARDS When using electrical products especially when children are present basic safety precautions should always be followed including the following READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO OPERATION DANGER TO REDUCE THE RISK OF ELECTROCUTION Always unplug this product immediately after using Do not use while bathing Do not place or store product where it can fall or be pulled into a tub or sink Do not place in or drop into water or other liquid Do not reach for a product that has fallen into water Unplug immediately WARNING TO REDUCE THE RISK OF BURNS ELECTROCUTION FIRE OR INJURY TO PERSONS A product should never be left unattended when plugged in Close supervision is necessary when this product is used by on or near children or invalids Use this product only for its intended use as described in this manual Do not use attachments not recommended by the manufacturer Never operate this product if it has a damaged cord or plug If it is not working properly if it has been dropped or damaged or dropped into water Return this product to a service center for examination and repair Keep the cord away from heated surfaces Never use while sleeping or drowsy
6. Never drop or insert any object into any opening or hose Do not use outdoors or operate where aerosol spray products are being used or where oxygen is being administered Connect this product to a properly grounded outlet only Use only the approved power source GlobTek Model GTM375 24 800D that has been supplied with the CPM unit See grounding instructions CAUTION Federal law restricts this device to sale by or on the order of a licensed health care practitioner CAUTION Work in a range of motion as instructed by your healthcare practitioner CAUTION If changing chair height between uses the unit must be re calibrated per the hand held controller instructions CAUTION If you experience increased pain swelling or any adverse reactions while using this product immediately consult your health care practitioner WARNING Set up and use of this equipment should be in a low traffic location and away from children and pets Warn children this apparatus is not designed for hanging climbing or any type of child play It may tip over or collapse with misuse WARNING Pinch points exist during assembly use caution and assemble pursuant to the instructions WARNING Make sure the hand control is accessible to the operator before starting this equipment The stop button on the hand control is the only way of stopping the motion for disabled patients or children using the unit Other users can stop the motion by standing and removing weight
7. Release the button to set the UP limit CAUTION Work in a range of motion as instructed by your Healthcare Practitioner 8 Press the START STOP Button to begin treatment The FLEX MATE S500 will cycle up and down between the set limits at the preset speed Note The range of motion angles on the hand held controller are approximate and depend on the degree of accuracy of the 90 calibration 9 To adjust the speed setting on the FLEX MATE S500 press and release the SPEED Button on the hand held controller to toggle through the 1 Slow 2 Medium and 3 Fast settings Note The default speed is 2 Medium Adjust the speed to accommodate patient comfort 10 To discontinue treatment press the START STOP when the patient s hand is at the bottom of the cycle Remove the S500 Handle from the tape and unstrap to remove the patient s hand 11 To disconnect the power from the FLEX MATE S500 unplug the power cord at the rear of the control panel The current settings will be automatically restored when the power is turned ON again CAUTION If at any time a different height chair is used the 90 Calibration and UP and DOWN limits must be reset as described above Note When there is no weight on the handle and the START STOP button is pressed with the power connected the handle automatically lowers to the full DOWN position and stops The display on the hand held controller reads LO
8. cable requirements of UL 2601 1 UL 1431 CSA C22 2 No 601 1 Grounding Instructions This product should be grounded In the event of an electrical short circuit grounding reduces the risk of electric shock by providing an escape wire for the electric current This product is equipped with a cord having a grounding wire with a grounding plug The plug must be plugged into an outlet that is properly installed and grounded DANGER Improper use of the grounding plug can result in a risk of electric shock Check with a qualified electrician or serviceman if the grounding instructions are not completely understood or if in doubt as to whether the product is properly grounded 1 Grounded Grounded This product is factory equipped with a specific power supply to permit connection to a proper Outlet o m Outlet Box electric circuit Make sure that the product is connected to an outlet having the same configuration as the plug No adaptor should be used with this product Do not modify the plug provided f it will not fit the outlet have the proper outlet installed by a qualified electrician Package Contents 1 FLEX MATE S500 CPM 1 Users Manual 1 Service Manual K j 1 71660 Patient Kit S500 Handle Services Inc 4038 Weaver Court East Phone 614 921 8866 Hilliard OH 43026 Fax 614 921 8877 Toll Free 866 532 3534 P N 1 81060 Revision G 3 of 8 Set Up Instructions Open the shipping box lift the FLEX MATE S
9. houlder joint to increase circulation range of motion and to prevent scarring in the joint The FLEX MATE S500 is designed to passively move the shoulder through the three main planes of movement Safety Precautions e Use only manufacturer approved parts and maintenance procedures to service the unit Refer to the FLEX MATE S500 Service Manual Read and adhere to all warnings and instructions listed on the FLEX MATE S500 and this Users Manual If you suspect the FLEX MATE S500 is not working properly unplug the unit and refer to the Service Manual If you detect a flaw of any type in the power cord immediately unplug the transformer from wall Use only the external power supply provided with the FLEX MATE S500 in order to meet the requirement of UL 2601 1 Table 1 Symbols Used on the FLEX MATE 500 Table 2 Physical and Electrical Specifications Length Width Direct Current Height Weight t Without accessories Attention Consult User s manual before use With accessories Fully packaged Class Type B Continuous Operation Electrical Specifications Not suitable with flammable anesthetics Voltage and current 24 VDC 750 mA Environmental Requirements Temperature Operating 50 F to 95 F 10 C to 35 C Transport amp Storage 40 F to 158 F 40 C to 70 C Humidity Operating 30 75 R H Transport amp Storage 10 100 R H non condensing Standards Compliance Designed to conform to appli
Download Pdf Manuals
Related Search