Troubleshooting Guide (English)
Contents
1. Bair Hugger Therapy 700 Series Temperature Management Unit Troubleshooting Always refer to Temperature Management unit s operator and service manual Permanent errors a fault condition always occurs at turn on or after pressing a temperature setting Fault Code Possible Cause Solution FC 01 Faulty hose end sensor at Replace hose Refer to service manual or IFU included with i patient end of hose replacement part for instructions FC 02 FC 03 Faulty elbow sensor Replace elbow sensor Refer to IFU included with FC 04 replacement part for instructions FC 05 FC 06 Hose disconnected from unit Reattach hose FC 07 Calibrate and return to service refer to service manual Does blower run in ambient mode Paley heaterelementor contral If NO call Arizant Technical Support mae If YES check continuity of J4 connector on control board FC 08 e White to black e White to blue e White to yellow If open replace heater Otherwise replace control board Calibrate and return to service refer to service manual FC 09 Faulty heater element Replace heater FC 10 Calibrate and return to service refer to service manual Defective user interface Replace user interface FC 50 Calibrate and return to service refer to service manual Reset microprocessor EEPROM error Press the Bair Hugger logo and Standby button at same FC 53 54 time while connected to power source Release buttons i when Stan2. dby light remains on Calibrate and return to service refer to service manual FC 100 Defective control board Replace control board FC 101 Calibrate and return to service refer to service manual Call Technical Support for Replacement Parts at 1 800 733 7775 EVERYONE DESERVES A HUGG Bair Hugger Therapy 700 Series Temperature Management Unit Troubleshooting Fault Code Possible Cause Solution i S Hose end at patient end occluded Disconnect from power source Remove hose zz occlusion Position hose end correctly into hose card FC 01 gt S refer to the operator s manual Reconnect to power 8 source If no fault occurs unit is ready for use lt 2 m FC 02 Hose end sensor failure at patient end Disconnect from power source Allow unit to cool 5 FC 03 Faulty elbow sensor Reconnect to power source If no fault occurs unit is e Moisture ready to use W FC 04 gt Intermittent sensor failure E FC 05 High heat 2 FC 06 5 oS FC 07 Oo 2009 Arizant Healthcare Inc All rights reserved 10393 West 70th Street Eden Prairie MN 55344 USA TEL 800 733 7775 952 947 1200 FAX 800 776 0002 e 952 947 1400 Bair Hugger and the Bair Hugger logo are trademarks of Arizant Healthcare Inc registered or pending in the U S Patent amp Trademark office and in other countries 602880B 12 09 EVERYONE DESERVES A HUGG
Download Pdf Manuals
Related Search