取扱説明書 - Just Music
Contents
1. 5 1 0 0 0 0 4 5 5 5 0 3 Roland Keyboard Stand KS V8 Owner s Manual A Caution Before using this stand carefully read the sections entitled USING THE STAND SAFELY and IMPORTANT NOTES separate sheet These sections provide important information concerning the proper operation of the stand The manual should be saved and kept on hand as a convenient reference Make sure that another person is on hand to help with the assembly and setup Assembly and adjustment must be performed on a flat and level surface Be careful not to pinch your fingers when setting up the stand Do not move the stand with the keyboard resting on it Doing so may cause the keyboard to overturn or fall If any of the bolts that are not involved in the assembly procedure have become loose use a commercially available allen wrench 5 mm to tighten them Check the parts Before you begin assembly check to make sure that you have all of the parts 1 Stand 1 2 Support bar with bolts 2 3 Cable cover 2 4 Stud screw 4 5 Allen wrench 1 6 Knob bolt 4 7 Headphones hook 1 For details on using the knob bolts and headphone hook refer to the owner s manual2. ALR 1 A x A A 2 A 9 a B 2 HPR 2008 gt C C o j 5 C
3. 7 5 C 8 z 4 B 10 11 B2 2 2 AP
4. that came with the piano You ll need to provide a Phillips screwdriver 0 J gt N 7 Inthe interest of product improvement the specifications and or 4 appearance of this unit are subject to change without prior notice AS Assembly Use the included Allen wrench to remove the bolts marked A and washers a Leg rm as VA Lay the stand on its back A Use the included Allen wrench to remove the two bolts marked B and their washers then swing the arm to the position shown in the illustration Raise the support columns as shown in the illustration and while holding the columns in place use the previously removed bolts A and washers to fasten the columns to the leg Washer Support column BD mM m A oo eoon Copyright 2008 ROLAND CORPORATION All rights reserved No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION Use the included allen wrench to remove the bolts C and washers that are attached to the support bars Pi C o Using the bolts C and washers that you removed in step 5 loosely fasten the support bars to the leg Raise the arm and using the bolts C and washers you removed in step 5 fasten the support bars to the arm C Washer step 6 Fasten the arm using the two bolts B and washers you removed in step 4 B W
5. Roland Keyboard Stand KS V8 A 5mm 1 2 3 4 5 6 7 miv
6. asher Place the stand upright Turn the adjusters located at the positions shown in the illustration so that the stand is horizontal relative to the floor Adjust them so that the stand does not lean or wobble Attaching the cable covers Attaching the cable covers allows you to improve the appearance of your setup by neatly organizing the cables connected to the keyboard Use a Phillips screwdriver to attach two stud screws to each support column Hook the two holes in each cable cover onto the two stud screws you attached to each support column Ifyou have difficulty attaching the cable covers temporarily loosen the screws and re tighten them after you ve attached the cable covers Storing the allen wrench The included allen wrench can be inserted into the holder shown in the illustration Stored here it can be removed whenever needed
Download Pdf Manuals
Related Search