Shure RK244G User Guide
Contents
1. RK244G Replacement Screen and Grille Screen and Grille Retainer Ring Assembly a The Shure RK244G is a replacement screen and grille as sembly for the Model SM57 microphone The RK244G con sists of the complete screen and grille assembly an extra re tainer ring and nameplate REMOVAL CAUTION Use extreme care in removing the screen and grille assembly Avoid damaging the clear plastic diaphragm Bending or tearing the diaphragm will affect the microphone response and may require complete cartridge replacement Rotate to align double tabs with flat area beneath the grill Double Tabs Flat Area 1 Peel the old nameplate off and discard it 2 Rotate the grille assembly until the two metal tabs are centered above one of the recessed flat areas visible through the perfo rated collar Refer to the exploded diagram above 3 Use a small 1 16 in blade maximum screwdriver to depress the two metal tabs while you lift the grille up and over the metal tabs INSTALLATION CAUTION As in the disassembly process above take care not to damage the clear plastic diaphragm 1 Remove the retainer ring from the new screen and grille as sembly 2 Wrap the new retainer ring around the cartridge groove just above the perforated collar 2002 Shure Incorporated 27A3164 Rev 1 Diaphragm Flat Area Groove Perforated Collar 3 Ho2. 2 2893 4055 International Fax 1 847 600 6446 C Printed in U S A
3. ld the two ends of the retainer ring closed around the car tridge and center them above a flat area on the side of the car tridge 4 Hook the crimped tab at the back of the retainer ring into one of the two slots in the grille 5 Lower the front edge of the grille assembly over the retainer ring until it contacts the tops of the two metal tabs and holds the retainer ring closed Be sure the collar is tucked underneath the grille 6 Use a small screwdriver to tuck the two metal tabs under the edge of the grille assembly Continue lowering the grille as sembly into place until the tabs lock into the slot on the retainer ring 7 When properly assembled the grille assembly can be rotated while the perforated collar is held in one position 8 Remove the paper backing from the replacement nameplate Locate the raised index mark along the lower edge of the grill assembly and affix the nameplate so that it covers the retainer ring holes but not the index mark Label Index Tab lf you have a Shure microphone that requires a different nameplate SM77 PE65 PE66 545 etc please contact Shure s Service Department gt an a n SHURE Incorporated Web Address http www shure com 5800 W Touhy Avenue Niles IL 60714 4608 U S A In U S A Phone 1 847 600 2000 Fax 1 847 600 1212 In Europe Phone 49 7131 72140 Fax 49 7131 721414 In Asia Phone 1 852 2893 4290 Fax 1 85
Download Pdf Manuals
Related Search