1. BEA Application Note 42 8865 V2 02 15 A HALMA COMPANY m E2 m A E5 E6 E7 m E9 LED SIGNAL The ORANGE LED flashes 1 x The ORANGE LED flashes 2 x The ORANGE LED flashes 4 x The ORANGE LED flashes 5 x The ORANGE LED flashes 6 x The ORANGE LED flashes 7 x The ORANGE LED flashes 8 x The ORANGE LED flashes 9 x The ORANGE LED iS On The RED LED flashes quickly after an assisted setup The RED LED lights up sporadically The GREEN LED lights up sporadically The LED and the LCD display are off The reaction of the door does not correspond to the LED signal Motion detection BEA SA LIEGE Science Park ALL E DES NOISETIERS 5 4031 ANGLEUR BELGIUM T 32 4 361 65 65 F 32 4 361 28 58 INFO BEA BE WWW BEA BE X10 SOLUTION Troubleshooting CAUSE LCD The sensor signals Cut and restore power supply an internal fault If orange LED flashes again replace sensor Decrease the angle of the IR curtains Increase the IR immunity filter values gt 2 8 m EJ Deactivate 1 curtain The sensor receives not enough IR energy The radar sensor output is faulty The IR power emitter is Replace sensor faulty The sensor encounters a memory problem MY cut and restore power supply If orange LED lights up again replace sensor Check if the sensor is fastened firmly Check position of cable 2. and cover The sensor vibrates The sensor sees the door Launch an assisted setup and adjust the IR angle Increase the IR immunity filter to value 3 lt 2 8 m Select presetting 2 or 3 The sensor is disturbed by external conditions Check wiring e LED is off Presence detection LED flashes LED flashes quickly T Vv UO Lu