User Guide
Contents
1. SPECIFICATION RECEIVER Frequency 433 92MHz Power 240V 10 50Hz In standby mode power consumption 0 25watt Output load 40 250 watt Incandescent Min 40 max 250 watt direct connect with incandescent lamp not compatible to dimmable energy saving bulb If connect with non dimmable electronic transformer for low voltage 12V halogen lamp not compatible to traditional transformer the load here means the VA of the electronic transformer Max load electronic transformer can be used is 200VA FAULT FINDING No activation Check battery polarity or running out battery Check code program successful CAUTION Do not place two receivers near each other the distance should be above meter Warning DO NOT OVERLOAD Do not plug or use in damp places like patios cellar flammable liquid solvents paints etc2. USER MANUAL Model EYCR 250 Dimmer Receiver FEATURES e No wiring easy operation just plug and use e 67 million codes self program function receiver e Receiver has 6 memory settings no memory loss forever e Green LED indicator EYCR 250 when there is no application plug in the LED will not light on e Receiver lower standby power consumption 0 25 watt LED LEARNING BUTTON e EYCR 250 compatible with non dimmable electronic transformer for low voltage 12V halogen lamp NOT for traditional transformer INSTALLATION Controller Receiver e Plug in receiver into wall outlet e Green LED indicator on receiver should light on EYCR 250 will not e Connect lamp plug into receiver Remote control Transmitter e Remote control till 30M in open area OPERATION ON OFF RECEIVER Press transmitter button ON to switch on Press transmitter button OFF to switch off DIMMER RECEIVER Press transmitter button ON twice light will start to dim press again light stops at required brightness HOW TO LINK CODE To start program your transmitter with the receiver Receiver plugged on power Bring the transmitter near the receiver push the self program button on receiver once Receiver led will blink slowly press transmitter selected ON button lt oO a Receiver connected lamp will blink twice code is confirmed and led stops blinking Remember the
3. transmitter button you selected for the programmed receiver Transmitter and Receiver codes are auto programmed TO CHANGE OR DELETE CODE INDIVIDUAL DELETE Push the self program button once led will blink slowly Press selected OFF button on transmitter programmed memory is deleted Receiver connected lamp will blink twice for confirmation Repeat step for re setting ALL MEMORY DELETE Push the self program button till the LED blinking continuously Release and push again once Receiver connected lamp will blink twice for confirmation ALL PROGRAMMED MEMORY WILL BE DELETED FROM RECEIVER RECEIVER HAS 6 MEMORY SETTINGS Self program function RECEIVER has 6 memory settings It can be programmed as to your requirement with special effect It can be programmed to switch ON at one time individually or programmed with different combinations switching This means one receiver can be programmed into max 6 different combination Example If there is 3 receivers receiver 1 lamp shade receiver 2 night light receiver 3 fan Receiver 1 2 3 can be control individually with transmitter button 1 2 3 Receiver 1 3 can be programmed with transmitter button 4 lamp shade and fan ON OFF at same time Above settings Receiver 1 and 3 takes up 2 programmed memory and Receiver 2 only 1 program memory different combinations and settings can be teamed up and control from transmitter
Download Pdf Manuals
Related Search