10/100M Ethernet Network Interface Card USER'S MANUAL
Contents
1. Linux Netware 5 x SCO UNIX Solaris LINK ACT 0 C to 55 C Operating 10 to 90 Non condensing FCC Class B CE Mark 3W Max To insert the network adapter into your PC follow the steps bellow 1 Turn off the computer and remove its cover 2 Insert the adapter into a PCI slot 3 Lock this adapter to the rear of the computer and put back the computer cover 4 Connect the adapter to network using twisted pair cable 2 Driver Installation Use the drivers supplied by the diskette included in this product Trouble shooting If you experience any problems with the adapter first make sure the appropriate driver is loaded the proper cable is connected to the adapter port and the hub switch complies with the adapter specification such as 10Mbps 10Base T 100Mbps 100Base TX then check the LED The adapter provides LEDs to indicate network link LNK The LED indicates if the UTP has been LINK ok or not When the light is OFF it indicates that the UTP port has not been connected or LINK not ok When the light is ON it indicates that the UTP port LINK ok2. TEEE802 3u 100Base TX And combines two transmission rate 10 100M on one RJ 45 connector This adapter supports bus Duplex function to connect to Switching Hub Extensive drive support for commonly used network operating systems is available Features amp Specifications 1 Feature amp Benefits 1 Compliant 66 33 MHz 32 bit PCI V2 2 MAC BIU supports data rates from 10Mb s to 100 Mb s This allows support for traditional 10 Mb s Ethernet or 100 Mb s Fast Ethernet Complies with the IEEE 802 3 CSMA CD 100Base TX and 10Base T standard Full duplex design to double the performance to 20Mbps 200Mbps One shield connector for 100Mbps or 10Mbps network speed Support Auto negotiation function Auto setup IRQ and I O address NDIS 4 5 driver for Microsoft Windows 95 98 Me NT 2000 Linux and Netware ODI driver for Server SCO UNIX Solaris 8 Provide LEDs to indicate network link SO GU eR Gs 2 Technical Specification Topology Star Connector RJ 45 Standard IEEE 802 3 10Base T IEEE 802 3u 100Base TX Transmission Rate 10Mbps or 20 Mbps 100Mbps or 200Mbps Hardware Required IBM compatible PC with available PCI Slot PCI2 1 2 2 66 33MHz 32bit 3 0 4 0 IRQ Line 1 0 Address Drivers LEDs Temperature Humidity Certification Power consumption Installation 1 Hardware Installation Assigned by system Assigned by system NDIS 4 5 for Windows 95 98 Me NT 2000
3. 10 100M Ethernet Network Interface Card USER S MANUAL FCC COMPLIANCE STATEMENT This equipment has been tested and found to comply with the limits of a Class B computing devices pursuant to Part 15 of the FCC rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates used can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications If you suspect this product is causing interference turn your device on and off while your radio or TV is showing interference If the interference disappears then when you turn the device off and reappears then you turn the device off and reappears then you turn the device on something in the device is causing interference You can try to correct the interference by one or more of the following measures 1 2 3 4 1 0 2 0 Reorient Relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit difference from that to which the receivers connected Ensure that all expansion slots on the back or side of the computer are covered Also ensure that all metal retaining brackets are tightly attached to the computer Introduction This NIC is 32 bit 10 100Mbps Fast Ethernet Adapter series It supports IEEE 802 3 10Base T
Download Pdf Manuals
Related Search