Sprayer User Guide ˘ TOTAL Spray Applicator
Contents
1. Iypecacall veid Sprayer User Guide TOTAL Spray Applicator Instructions For Use Make sure that all connections are fastened tightly When filling and pressurising ensure sprayer is in an upright position Engage handle with the pump cap and unscrew pump by turning counter clockwise then remove Pour the liquid to be sprayed through the opening at the top Do not fill the tank above the rated working volume as the balance of tank space is required for compressed air The maximum working volume is marked on the outside of the tank Replace the pump and tighten by turning clockwise Over tightening of the pump may cause damage to the engagement thread Pump the handle using full even strokes with both hands until the pressure gauge indicates the maximum pressure marked in red At this level there will be enough pressure in the tank to empty its contents without additional pumping If the sprayer is not filled to the normal working capacity the pressure may be kept below the red mark to avoid excessive pumping To spray squeeze the trigger of the discharge valve Transport the sprayer by holding the pump handle with the spare hand When the trigger is released spraying stops immediately Do not spray against the wind or in strong winds Where a compressed air filler valve is installed in place of the hand pump please ensure the valve s Instructions for Use are followed as supplied separately Maintenance amp Care2. Release residual pressure from tank before unscrewing the pump by pulling up the red safety valve button at the top of the tank Empty sprayer after use and rinse carefully with water or suitable cleaning agent Never leave spraying liquid in the tank for extended periods greater than 1 week Once the tank is empty there will be some residual liquid remaining Rinse out this liquid twice with 1 2 litre clear water or cleaning agent recommended by the liquid s manufacturer shaking the sprayer well and spraying out the diluted liquid Never dispose of residues in sewers or on the ground Follow the manufacturer s directions for disposal of materials Once a year clean the slotted filter in the discharge valve with water Once a year lubricate gaskets Apply oil sparingly on the piston rod to lubricate the piston washer CUSTOMER SERVICE CENTRE 1300 780 250 void freie e Atleast once a month check for leaks and correct functioning of all components under maximum tolerable working pressure in working and idle mode including o Tightness of all sorayer components at maximum allowable pressure with 5lt of liquid in tank o Correct functioning of air pump discharge valve D safety valve B and pressure gauge A o Condition of tank and pressure hose C o Spray pattern and precise dosage of nozzle a s CUSTOMER SERVICE CENTRE 1300 780 250 reid Trouble shooting Read safety
3. instructions Empty tank and release residual pressure No pressure builds up in the device Pump is not screwed on Screw the pump on tightly tightly O ring is faulty or not aligned properly Replace or realign O ring Diaphragm is defective Replace the diaphragm Piston washer is faulty Replace piston washer Liquid flows out of the pump Valve disk dirty or defective Clean or replace valve disk Nozzle does not spray even though pressure is present Safety valve releases pressure too early Shut off valve does not close Liquid released without discharge trigger squeezed Pressure gauge is not indicating any tank pressure Filter and or nozzle blocked Clean the filter and or nozzle Safety valve is defective Replace safety valve O ring on the pressure bolt Grease the O ring of not greased Defective the pressure bolt pressure bolt or O ring Replace the pressure bolt or O ring Pressure gauge is defective Remove attachment 2 at top then unscrew pressure gauge amp replace CUSTOMER SERVICE CENTRE 1300 780 250
Download Pdf Manuals
Related Search