Troubleshooting Using Bias Voltage
Contents
1. MMI SENSORS A PCE PIEZOTRONICS DIV Troubleshooting Using Bias Voltage Using Bias Voltage as a Diagnostic Tool Piezoelectric sensors are dynamic measuring equipment They use piezoelectric sensing elements to convert or transduce the mechanical phenomena to an electrical signal The mechanical parameter may be force pressure or vibration The raw electrical signal from a piezoelectric element is a high impedance charge signal This charge signal is normally converted to a low impedance voltage signal by either an external charge amplifier or an external voltage amplifier The cables between the charge sensor and the amplifier must be high quality low noise cable and must be kept as short as possible LOW NOISE CABLE READOUT DEVICE CHARGE OUTPUT SENSOR Internally amplified sensors or ICP sensors employ miniature amplifiers to convert the high impedance charge signal into a low impedance voltage signal These amplifiers are internal to the sensor and therefore do not require low noise cables or external amplifiers These amplifiers have set gain so that output sensitivities are standardized O51 COAXIAL CABLE READOUT DEVICE w ICP POWER ICP sensors are two wire sensors They are powered with a constant current DC source The power supply is typically 18 to 30 volts DC current limited via a constant current diode between 2 and 20 mA Typical battery operated supplies offer 2 mA of constant current to extend bat2. the sensor and cabling are functioning properly LOW NOISE CABLE AMPLIFIER READOUT DEVICE CHARGE OUTPUT SENSOR
3. tery life while continuous monitoring systems offer more current in order to drive longer cables 18 28VDC a 2 20m lt 4 READOUT DEVICE CHARGE OUTPUT SFNSOR The signal output of an ICP sensor is a low impedance voltage signal proportional to the dynamic measurement such as force pressure or vibration This voltage signal is carried on a DC bias voltage The AC dynamic signal is superimposed on the DC bias voltage and is allowed to swing between the supply voltage and ground Unlike an operational amplifier Op Amp that requires a plus and minus supply and allows the signal to ride on ground and swing between the plus and minus rails the ICP sensor requires the output signal to be DC biased _ 4h ice Supply Has wale Aave AC Mame Sgal 0 Vide This DC bias voltage is an excellent diagnostic tool The voltage provides a means of verifying that the amplifier is turned on Typical input output power supplies will block this DC bias voltage at the output via a blocking capacitor in order to AC couple the signal to readout devices By teeing off the input into a DC volt meter the bias voltage can be measured While measuring the supply voltage the bias voltage can be measured after the sensor is plugged in If the meter stays at supply something in the system is open or not connected If the meter reads O something in the system is shorted If the meter reads approximately one half the supply voltage then
Download Pdf Manuals
Related Search