J050 - Heavy Duty Adapter Operating Instructions
Contents
1. MALE OF FOREIGN MATTER THEN APPLY ONE DROP OF MEDIUM STRENGTH LOCKING COMPOUND LOCTITE 242 OR EQUIVALENT ONTO MALE THREAD AND CONNECT PARTS TOGETHER 3 PERIODICALLY CHECK FOR TENSION ON THESE SCREWS LOOSENED SCREWS WILL RESULT IN ASSEMBLY BREAKAGE A Oe uu PEAVY MEX Duty Adapter Co SEE NOTE 3 BLADE INSTALLATION J050 HEAVY DUTY ADAPTER REPAIR PARTS LIST BAND IT PART ITEM DESCRIPTION J11985 RATCHET WRENCH 1 4 KNB c 1 6 SCREW SPECIAL I 2 8 CUTTERBLADE I 1 9 HEXKEY SPECIAL J 1 1 J06887 J93099 J05187 Refer to website for warranty information http www band it idex com warranty html BAND IT IDEX Inc A Unit of IDEX Corporation 4799 Dahlia Street Denver CO 80216 3070 USA P 1 800 525 0758 F 1 800 627 3925 www BAND IT IDEX com Document P35387 rev D Copyright BAND IT IDEX Inc 2005 Page 2 of 2 All rights reserved2. Operating Instructions J050 Heavy Duty Adapter To Install a BAND IT Junior Clamp using the Heavy Duty Adapter Screw Block Cutoff Screw Setscrew Place Heavy Duty Adapter on nose of BAND IT tool positioned as shown Cut off screw should not extend beyond bottom of screw block Line up tool and adapter slots and tighten two setscrews Insert BAND IT Junior or Junior SID clamp tail into adapter nose through all slots and grip end with band gripper lever When properly tensioned roll tool over hose backing off tension handle to 1 2 turn only through course of rollover depending on type and size of hose until shear hook grips buckle edge Tighten knurled nut by hand securing buckle tightly between edge of hook and nose of adapter BAND IT IDEX Inc Install clamp over hose assembly Tension clamp by turning the handle of BAND IT Tool clockwise Place ratchet wrench on hex nut Operate wrench clockwise until clamp is sheared Clamp is now locked and completed NOTE USE OF A VISE IS OPTIONAL TO HOLD TOOL DURING USE Document P35387 rev D peracid al www BAND IT IDEX com nee nee oe Denver CO 80216 3070 USA l Al ri hts eae P 1 800 525 0758 Page 1 of 2 g F 1 800 627 3925 Repair Parts amp Assembly NOTES 1 TO ASSIST IN REMOVING THREADED PARTS APPLY HEAT TO SOFTEN LOCKING COMPOUND 2 WHEN CONNECTING ITEM 4 KNOB OR ITEM 2 NUT TO ITEM 3 SCREW CLEAN THREADS MALE AND FE
Download Pdf Manuals
Related Search