Operating Instructions - HF
Contents
1. Operating Instructions X 2 SSB Transceiver CODAN 1 Switch transceiver On by rotating the Volume control clockwise The Indicator will light Select the required Channel and Mode USB or LSB Follow the tuning instructions in 6 below No tuning required for broadband or dipole antennas 2 With the Mute switch Off set the Volume control for a comfortable listening level The Clarifier may be adjusted for natural sounding speech as required 3 The Mute will remove background noise when no signals are present and should be switched Off to prevent the occasional loss of syllables when communicating in the presence of weak signals 4 Hold the microphone side on close to the mouth and speak clearly Take care to press the transmit button before speaking Always listen before transmitting to ensure that the selected channel is free of traffic 5 When transmitting the Indicator light will flicker Tune will cause the Indicator to light continuously 6 After changing Channel a Where a multi frequency tapped whip is being used select the correct tap position for the frequency in use o Where an automatic antenna tuner is being used select Tune for approximately one second and ensure that the tune complete double high beep is heard c Where a manual antenna tuner is being used set the tuner controls to the logging scale positions Before transmitting operate the Tune switch and adjust the Tune control on the tuner for m2. aximum meter reading 7 Warning tones Tones are used to warn of operator error or equipment status Low Tone Beep High Tone Beep Single Transmit inhibited Double Tune complete Double Tune fail check antenna Repetitive Channel not programmed Slow repetitive Low supply voltage Fast repetitive PTT time out Continuous Tone Low Tone Channel unavailable High Tone High supply voltage Warning a Do not obstruct the free flow of air through the transceiver rear fins b Where two antennas are used ensure they are connected to the correct antenna sockets for the frequency in use Belfer Comnuurucatens wrorllunr lR Operating Instructions cont d RFDS Emergency Call Australia only s Switch transceiver On and adjust as in 1 to 6 Ensure a local RFDS channel has been selected on other channels the call will not be transmitted Operate Emgcy Call switch for at least 15 seconds then wait for a reply before transmitting Unattended RFDS base stations will transmit a tone within 90 seconds if the call has been received Beller comnumicateens aorldundke
Download Pdf Manuals
Related Search