STADT PILOT IGNITION OPERATING INSTRUCTIONS
Contents
1. ISSUED IN THE INTEREST OF PUBLIC SAFETY 5 October 1998 E amp S TA ae oY J as ae a NA OPERATING INSTRUCTIONS HEATERS READ _ FIRST Preliminary Turn OFF the wall thermostat and power to the heater unit To RESTART your heater Open duct register in all rooms Turn on gas Supply at the meter and unit Pilot Models 1 Turn gas control knob to PILOT position refer Fig 1 Open pilot viewing Window refer Fig 2 2 Push gas control knob down fully and hold down to allow gas flow to pilot Continue to hold gas control knob down and press ignition button if fitted down fully to provide spark for ignition If pilot does not light press ignition button again If no ignition button is fitted apply a lighted match to the pilot burner accessible through pilot viewing window WARNING Do not use a gas lighter 4 Once pilot is alight continue to hold gas control knob down for Approximately 30 seconds before releasing 5 Check that pilot flame is still alight with gas control knob released If not recommence lighting procedure Step 2 6 Turn gas control knob to ON position 7 Turn power 240 volts on at power point 8 Set wall thermostat inside house to desired temperature above room temperature 9 Burner will light automatically from pilot flame soon after setting thermostat Fan will operate some minutes later Important Should the heater fail to light at any time check that the pilot flame is2. alight If not turn the gas control knob to the OFF position wait five minutes for unburnt gas to clear then repeat lighting procedure If for any reason gas knob is jammed do NOT use any hand tool to unlock as this could be very dangerous Ring Service 98002409 Slide Pilot Door to Gas Valve Knob
Download Pdf Manuals
Related Search