3715 Electronic Entry Device USER OPERATING INSTRUCTIONS
Contents
1. LA GARD LGBASIC 3715 Electronic Entry Device USER OPERATING INSTRUCTIONS FEATURES Please see Manager Instructions for addi tional features that may be activated on your unit USER CODE e Open Lock e Change Code WRONG TRY PENALTY e Four 4 consecutive invalid codes initiates five minute delay period LOW BATTERY WARNING e Repeated audio and visual signal LED flashing and repeated beeping during opening indicates battery low AUDIO AND VISUAL SIGNAL e Double signal LED flashes and unit beeps indicates entry is valid or accepted e Triple signal indicates invalid or not accepted MITON IGE I WEBI vuy OPENING THE LOCK 1 Enter valid six 6 digit code 2 The lock will indicate a valid code entry with a double signal 3 Within four 4 seconds turn handle to the open position 4 Pull door open e Invalid Code Entry Lock will signal three 3 times WRONG TRY PENALTY e Entry of four 4 consecutive invalid codes starts a 5 minute delay period LED flashed red at ten 10 second intervals e At the end of the delay period two more consecutive invalid codes will restart an additional 5 minute delay period Entry will not respond to a single keystroke during delay period copyright 2004 P N 12 234 rev 4 7 07 LA GARD A Member of The Kaba Group page 1 of 2 CHANGING YOUR CODE ALWAYS PERFORM THIS OPERATION WITH THE DOOR OPEN 1 Ente2. pad and the safe door Pinched cables can result in a short circuit copyright 2004 P N 12 234 rev 4 7 07 LA GARD A Member of The Kaba Group page 2 of 2
3. r zero six times 2 Enter your existing six 6 digit code one time 3 Enter your NEW six 6 digit code two times 4 If a mistake is made wait thirty 30 seconds and repeat steps 1 3 5 Test lock operation several times before closing the door e Valid Code Entry Double signal after valid six 6 digit code is entered e Invalid Code Entry Triple signal and old code is still valid BATTERY LOW WARNING e Repeated beeping during an opening indicates that the battery is low and needs immediate replacement e Uses one 1 9 Volt Alkaline Battery LA GARD recommends the use of Duracell or Eveready Alkaline batteries LA GARD recommends the replacement of batteries at least once annually If battery is depleted and will not allow lock to open simply follow instruc tions below Lock contains a non volatile memory even with batteries removed the lock will retain all programming CHANGING YOUR BATTERY 1 Slide the keypad housing up and carefully pull away from mounting surface to expose battery compartment 2 Remove 9 Volt Alkaline battery and replace with new one 3 The connector is easily removed by unsnapping it from the two terminals on the top of the battery CAUTION Hold onto battery termi nal to avoid pulling wires out of housing 4 Carefully position the keypad over the mounting screws and slide the keypad housing down Ensure that there are no wires or cables trapped between the input
Download Pdf Manuals
Related Search