UB-P02II User's Manual
Contents
1. UB PO2II User s Manual 405162100 Copyright 2000 by Seiko Epson Corporation Nagano Japan EMC and Safety Standards Applied Product Name UB PO2ll Model Name M112D The following standards are also applied only to the units that are so labeled EMC is tested using the EPSON power suppliers and TM series printer Europe CE marking North America EMI FCC ICES 003 Class A Japan EMC VCCI Class A Oceania EMC AS NZS 3548 CISPR22 Class B WARNING The connection of a non shielded printer interface cable to this board will invalidate the EMC standards of this device You are cautioned that changes or modifications not expressly approved by SEIKO EPSON Corporation could void your authority to operate the equipment CE Marking The board conforms to the following Directives and Norms Directive 89 336 EEC EN 55022 Class B EN 55024 IEC 61000 4 2 IEC 61000 4 3 IEC 61000 4 4 IEC 61000 4 5 IEC 61000 4 6 IEC 61000 4 11 Introduction Printed in China 2000 12 FCC Compliance Statement For American Users This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the in2. the board connector Unpacking Make sure you have these items 4 UB P02II 4 This manual Procedure 1 Removing the interface board from the printer Remove the two screws that securing the interface board then pull the board to remove it You will use the screws when installing the UB P02II A CAUTION Put the removed interface board into an anti static bag for storage to prevent damage from static electricity 2 Installing the interface board enclosed in the package Hold the UB P02II as shown in the illustration below Push the UB P02II in gently until you feel the connector fit into place Ee 2 Connector of the UB P02ll Connector of the TM printer 3 Securing the UB PO2II Secure the UB P02II with the two screws 4 Setting the printer settings Change the printer settings to match the printer to the new interface See the parallel interface settings described in the printer documentation for the settings Make sure you set the printer settings Otherwise the printer may not work correctly Printed on Recycled Paper
3. struction manual may cause harmful interference to radio communications Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense FOR CANADIAN USERS This Class A digital apparatus complies with Cana dian ICES 003 Cet appareil num rique de Classe A est conforme la norme canadienne ICES 003 This manual describes how to replace the interface board on TM series printers designed for the UB PO2II You must check the printer settings after replacing the interface board See the documentation that came with the printer for information about the settings display connector of the printer When you use the UB P02II note that you will not be able to use the display module customer About The Symbol In This Manual Z CAUTION Cautions must be observed to avoid minor injury to yourself or damage to your equipment Precautions A CAUTIONS Disconnect the power supply from the printer before you remove the interface board otherwise you may damage the interface board and the printer You must disconnect the power supply because the electrical current is flowing in some parts of the printer circuit even when the power switch is turned off Wear a grounded wrist strap when handling the interface board to prevent dam age from static electricity To avoid contamination do not touch
Download Pdf Manuals
Related Search