Installation Manual FHC20M ELECTRIC STRIKE
Contents
1. lt FSH gt Installation Manual FHC 20M ELECTRIC SIRIKE PRODUCT FHC 20M is a monitored Electnc Strike to replace the old HARCOR Electnc Stnke The stnke isa modified version of the FSH FES20M product with all its features and functions including field selectable locking function from Fail Safe to Fail Secure and comprehensive monitonng features The FHC20M requires a small modification on the frame to replace existing old HARCOR Electnc Strikes WIRING Connect the winng according to list below Power Input Multi Voltage 11 30VDC 12 VDC current 220 mA 24 VDC current 110 mA Wire output Red Black LSS Lock Status Sensor Black Common Yellow NO PTO NC PTL Green NC PTO NO PTL DSS Door Status Sensor Black Common Blue NO Orange NC ATS Anti tamper Sensor Black Common Red NO White NC Sensor Output LSS Sensor Output DSS Sensor Output Anti tamper Sensor Output 3 A 125 VAC 3 A 125 VAC 5A 125 VAC 2A 30 VDC 2A 30 VDC 3 A 250 VAC NOTE FHC 20M Senes Electnc Stnke factory setting is Power to Lock PIL The control circuit for the door stnke is protected against reverse polanty connection No additional diode protection required The product must not be installed in applications where it will be exposed to wind and weather extemal gatesetc PRODUCT DIMENSIONS 138 119 60 V1 1 2013 lt FSsH gt www fshlocking com au INSTALLATI2. ON FRAME MODIFICATION _ SA POSITION OF DOOR LATCH Front face of E _ Strike keeper Door Latch SE KO Door Frame As drawn in the diagrams there should be a Imm gap between the doorlatch and the front face of the stnke keeper preventing the doorfrom creating back pressure on the stnke keeper when the door isclosed V1 1 2013 lt FSH gt www fshlocking com au FIELD SELECTION PROCEDURES TO CONVERT PTO POWER TO OPEN TO PTL POWER TO LOCk Remove the rubber cap to expose the capstan wheel Slacken both of the capstan release screws two full revolutions DO NOT REMOVE Remove the sticker from the cover end opening hole Insert the tool pin through the cover end opening hole and push down the solenoid Hold it in position and at the same time insert the tool thru the cover plate opening hole and turn the capstan wheel in the direction of the keeper to the stop The strike is now in the Power to Lock mode Tighten the two capstan releasing screws replace the rubber cap Replace the sticker after changing over locking function V1 1 2013 lt FSH gt www fshlocking com au FIELD SELECTION PROCEDURES TO CONVERT PTL POWER TO LOCK TO PTO POWER TO OPEN Remove the rubber cap to expose the capstan wheel Slacken both of the capstan releas
3. e screws two full revolutions DO NOT REMOVE Remove the sticker from the cover end opening hole Insert the tool pin through the cover end opening hole and push down the solenoid Hold it in position and at the same time insert the tool thru the cover plate opening hole and turn the capstan wheel in the direction of the release screw to the stop The strike is now in the Power to Open mode Tighten the two capstan releasing screws and replace the rubber cap Replace the sticker after changing over locking function WARRANTY FSH Fire amp Secunty Hardware Pty Ltd FSH warrants this product against faulty workmanship and matenals fora penod of 5 years The warranty does not cover fair wearand tear The product must be installed according to FSH specifications V1 1 2013
Download Pdf Manuals
Related Search