LF700 LF1500 PRODUCT USER MANUAL USER
Contents
1. VAPERIZA LOW LEVEL FOG TECHNICAL LF700 SECIFICATIONS LF700 LF1500 Smoke 7000cu ft 12000cu ft LF1500 Output per minute per minute Warm Up 4 5 4 5 Time Minutes Minutes Tank 0 5 2 5 Capacity Liters Liters PRODUCT USER MANUAL Pee ee ee Power 110V 110V Supply 240V 240V Unit Dimensions AUDIO VISUAL ENGINEERING LOW LEVEL FOG CAUTION Keep this device away from rain and moisture Unplug Mains lead before opening the housing Make sure of the voltage on your end in suitable for the unit For your own safety please read this user manual carefully before you initially start Any person involved with the installation operation and maintenance of this device hasto Be qualified Follow the instructions in this manual INTRODUCTION Thank you for having chosen the AVE Vaperiza range You will see you have acquired a powerful and versatile device Unpack your item Before you initial start up please make sure that there is no damage caused by transportation Should there be any please consult your dealer and do not attempt to use the device SAFTEY INSTRUCTIONS If the device has been exposed to drastic temperature fluctuation e g after transportation do not switch it on immediately The arising condensation water might damage your device Leave device switched off until it has reached room temperature Always plug in the power plug last Make sure that the power switch is set to the OFF p2. al Run unit in a well ventilated area until tank is empty Replace clean sock Cleaning is now complete Unplug and store it in dry place Remember a well maintained machine should provide years of reliable use The body of the unit may be cleaned with a dry cloth Store dry PLEASE NOTE All information is subject to change without prior notice PRODUCT USER MANUAL
3. osition before you connect the device to the mains Never let the power cord come into contact with other cables Handle the power cord and all connections with the mains with particular caution Make sure that the available voltage is not higher then stated on the rear panel Make sure that the power cord is never crimped or damaged by sharp edges Check the device and the power cord from time to time CAUTION Before filling the machine disconnect from mains Never drink fluid or use it on the inside or outside of a human body If fluid gets in contact with skin or eyes rinse thoroughly with water If it is necessary call a doctor immediately DANGER OF EXPLOSION Never add flammable liquids of any kind to the fog liquid Keep minimum distance of 50cm to nozzle Always disconnect from mains when the device is not in use or before cleaning it Only handle the power cord by the plug Never pull out the plug By tugging the power cord Keep away children and amateurs Never leave this device running unattended STARTING OPERATION Place the machine on a level surface and remove the cap of the fluid tank to fill with high quality fog liquid when the tank is full replace the cap back onto the fluid tank Loose the nut on top cover to open the top cover fill the ice container with some ice cubes then cover the top cover and tighten the nut Firmly insert the remote control plug into the socket on the rear of the machine Ensure the power switch located a
4. t rear of the machine is OFF plug the power cord into a 3 prong grounded electrical outlet consistent with the machine s rated voltage Tum on the power switch the red lamp on the remote control will be on Allow the machine to warm up about 4 5 minutes When the warm up is complete the red lamp will be off that means the ice low fog machine is ready to emit low fog To emit low fog press the remote control red button and hold for the desired length of time The machinemay need to reheat after an extended discharge of fog Note The red lamp on the remote control willcycle on and off as the machine reheats to its operating temperature When not use the machine please tum off the power switch unplug the power cord from the main thenopen the top cover to clear the surplus ice cubes from the ice container and drain the water which the ice cubes dissolved CLEANING THE MACHINE Cleaning your machine regularly will help reduce costly parts replacement and repair charges After every 40 hours of continuous operation or when the machine will be idle for a long time it is recommended to run a cleaning solution composed of distilled water through the system to prevent the accumulation of particles PROCEDURE While unit is unplugged clean with mild soap and water Allow sock to dry completely before reattaching to unit Empty all fog fluid from the machine and replace with distilled water in the tank Plug unit in and allow machine to run as usu
Download Pdf Manuals
Related Search