GT3810 - User Manual FINALV3
Contents
1. SINGLE BLADE 4 CHANNEL 2 4GHz RC HELICOPTER GT 3810 MERCENARY NOTES AND CAUTIONS Flight Notes The Helicopter is suited for flight indoors and outdoors Always ensure you have enough space while flying indoors Ensure the unit is at least half a metre of the ground before attempting any great manouvers Whilst outdoors never flying in wind greater then 10km h or during any moist or wet weather Never crash unit with any great force any damage inccured by any sizeable force will void all the warranty Caution Never disassemble any part of the PCB or any other internal components Never wet any part of the Helicopter or remote control this will damage the unit beyond repair and void all warranty Never expose the unit to any excessive amount of heat Never wet or expose the Li Po battery to extreme heat or near flames Never attempt to charge the Li Po battery with other charger other then the charger supplied with the unit Never attempt to open or modify the Li Po battery REMOTE DESCRIPTIONS Power LED Antenna Power switch Remote Control Mode Switch Direction control stick Forwards and backwards trim Yaw Trim Module Action 1 Stick modes indicator Throttle output display Speed trim tips Diversion trim tips Remote Control Mode Selector Diversion tips Trim indicator2. Backward Battery type Battery Specification Usage Duration Charge Time Mode 4 Li po battery 3 7V 500mAh Helicopter flight time Approx Approx 45 Minutes Throttle Forward 10 Minutes Left side fly right side fly Turn left 7 Turn right Batteries not supplied 1 5V Remote control operation time 18 hours AA sized batteries Alkaline type are 4 Required recommended p Backward 4 POWERING UP AND PAIRING REMOTE ACTIONS Remote Action Helicopter Movement Remote Action Helicopter Movement Direction Stick Throttle Stick t Ascent Left or Right Up or Down Direction Stick Throttle Stick Up or Down 1 i Left or Right Remove the Helicopters shell and place the battery below the PCB There is a small slot where the battery slides in to Connect the battery to the input socket located on the side of the unit Replace cover then switch the Helicopter on O Adjustment of Yaw Trim If the Helicopter keeps leaning to the left please adjust the trim Left right to the RIGHT until it stops flying to the left If the Helicopter keeps leaning to the right please adjust the trim Left right to the LEFT until it stops flying to the right Der Move the throttle stick to the lowest point ON OFF Adjustment of Forwards Backwards Trim If the Helicopter keeps going forward please adjust the trim Forward backward DOWN
3. ON OFF Ensure the batteries are installed in to the Remote Control Then before turning the Remote Control on move the Throttle Stick to the lower point as shown Once the Throttle Stick is lowered turn the remote on Move the Throttle stick up and down then move the direction stick up down left then right This will pair the Remote to Helicopter NOTE It is important that the Helicopter is on by installing the batteries and switching it on first before attempting to turn the Remote Control on It will not pair otherwise Storage Please disconnect the battery from the Helicopter and ensure the remote control is turned off with batteries remove prior to storing the units Or even once you have stopped playing with the unit REMOTE ACTIONS Remote Action Helicopter Movement Remote Action Helicopter Movement Direction Stick Left or Right Throttle Stick Up or Down Direction Stick Throttle Stick Up or Down y Left or Right Adjustment of Yaw Trim If the Helicopter keeps leaning to the left please adjust the trim Left right to the RIGHT until it stops flying to the left If the Helicopter keeps leaning to the right please adjust the trim Left right to the LEFT until it stops flying to the right Adjustment of Forwards Backwards Trim If the Helicopter keeps going forward please adjust the trim Forward backward DOWN until
4. 1 or Mode 3 Move the Remote Control Mode Switch to the Up position which will show the letter R hold on to the Remove Control Mode Selector button while turning the remote control on Mode 1 will be shown on the LCD Turn the remote Off then On again still while holding the Remote Control Mode Switch then the it will show Mode 3 on the LCD Open the battery cover by pushing up Mode 1 Forward Throttle Turn right Left side fly right side fly CHARGING THE LI PO BATTERY Turn left T T Back ackward Use the charging line of the controller to charger the helicopter Mode 3 Throttle A Forward Charging line Left side fly right side fly Turn left Turn right sg KA Backward Throttle on the Left Side Mode 2 or Mode 4 Move the Remote Control Mode Switch to the Down position which will show the letter L hold on to the Remove Control Mode Selector button while turning the remote control on Mode 2 will be shown on the LCD LED Indicator LED green lighton orange lighton _ wes oO L f Mode 2 Charge Completion Charging Throttle Forward Turn the remote Off then On again still while holding the Remote Control Mode Switch then the it will show Mode 4 on the LCD Turn left Turn right Left side fly right side fly BATTERY AND USE INFORMATION Battery usage and charge duration reference sg AN
5. Yaw Trim tips backwards trim tips orwards and Battery lid SELECTING REMOTE MODE AND CONFIGURATION REMOTE INFORMATION There are four different Remote Control Configurations Transmitter gt h Remote Control To select either mode ensure the remote is off and follow Gee Mode Switch these steps I Power switch l m Im Remote Control Use 4 x AA batteries alkalines are E 100 gt Mode Selector suggested Place battery in to the battery A holder according to the polarity markings UHH h Throttle on the Right Side Mode 1 or Mode 3 Move the Remote Control Mode Switch to the Up position which will show the letter R hold on to the Remove Control Mode Selector button while turning the remote control on Mode 1 will be shown on the LCD Turn the remote Off then On again still while holding the Remote Control Mode Switch then the it will show Mode 3 on the LCD Mode 1 Forward Throttle Turn left Turn right Left side fly right side fly CHARGING THE LI PO BATTERY Txt T Backward 5 li Use the charging line of the controller to charger the helicopter Mode 3 Throttl TXI Forward rosse Charging line Left side fly right side fly Turn left Turn right Backward Throttle on the Left Side Mode 2 or Mode 4 Move
6. it stops flying forward If the Helicopter keeps going backward please adjust the trim Forward backward UP until it stops flying backward a Adjustment of Left Right Trim If the Helicopter keeps turning to the left please adjust the Yaw trim to the RIGHT until it stops turning to the left If the Helicopter keeps turning to the right please adjust the Yaw trim to the LEFT until it stops turning to the right SINGLE BLADE 4 CHANNEL 2 4GHz RC HELICOPTER GT 3810 Distributed by TechBrands by Electus Distribution Pty Ltd 320 Victoria Rd Rydalmere ce MERCENARY Ph 1300 738 555 Int l 61 2 8832 3200 Fax 1300 738 500 www techbrands com Made in China NOTES AND CAUTIONS Flight Notes The Helicopter is suited for flight indoors and outdoors Always ensure you have enough space while flying indoors Ensure the unit is at least half a metre of the ground before attempting any great manouvers Whilst outdoors never flying in wind greater then 10km h or during any moist or wet weather Never crash unit with any great force any damage inccured by any sizeable force will void all the warranty Caution Never disassemble any part of the PCB or any other internal components Never wet any part of the Helicopter or remote control this will damage the unit beyond repair and void all warranty Never expose the unit to any excessive amount of heat
7. the Remote Control Mode Switch to the Down position which will show the letter L hold on to the Remove Control Mode Selector button while turning the remote control on Mode 2 will be shown on the LCD LED Indicator LED Turn the remote Off then On again still while holding the Remote Control Mode Switch then the it will show Mode 4 green lighton lt orange lighton on the LCD 07 07 i Mode 2 Charge Completion Charging Throttle Forward Turn left Turn right Left side fly right side fly BATTERY AND USE INFORMATION Battery usage and charge duration reference Backward Battery type Battery Specification Usage Duration Charge Time Mode 4 Li po battery 3 7V 500mAh Helicopter flight time Approx Approx 45 Minutes TAL Throttle Forward 10 Minutes Left side fly right side fly Turn left Turn right Batteries not supplied 1 5V Remote control operation time 18 hours AA sized batteries Alkaline type are 4 Required recommended T Backward PARTS AND ADD ONS TURBO BUTTON AND MODULE CONTROLS NOTE All modules shown on this page are sold separately GT3830 Camera Module GT3832 Bubble Blowing Module Turbo Button Camera Module UNUSED Bubble or Water Module During flight and while the helicopter is moving forward switch the helicopter into H mode using the Low
8. High Speed Button and hold the turbo button to increase the speed of the Helicopter Once the button is let go the Helicopter will resume flying at normal speeds The sockets for each Add On Module sold separately is located underneath the Shell of the unit Please remove the Shell and follow the socket guide as shown above Module Action 1 Module Action 2 The following are the actions for the available add on Modules when connected to the Helicopter Button Module Action 1 located on the top left of the remote amp bottom right of the remote GT3830 Camera Module Start Stop Video record GT3832 Bubble Blower Module Creates bubbles GT3834 Water Sprayer Module Shoots water GT3836 Retractable Winch Retracts up Each module have hooks that clip in to the bottom of the Helicopter Clip a module on to the Helicopter by guiding them through the tabs Button Module Action 2 located on the bottom right front side of remote GT3830 Camera Modules Take snap shot GT3836 Retractable Winch Extend down POWERING UP AND PAIRING Remove the Helicopters shell and place the battery below the PCB There is a small slot where the battery slides in to Connect the battery to the input socket located on the side of the unit Replace cover then switch the Helicopter on O Der Move the throttle stick to the lowest point
9. Never wet or expose the Li Po battery to extreme heat or near flames Never attempt to charge the Li Po battery with other charger other then the charger supplied with the unit Never attempt to open or modify the Li Po battery 10 REMOTE DESCRIPTIONS Antenna Power switch Power LED Remote Control Mode Switch Direction control stick Throttle Yaw Stick a Forwards and Speed trim H backwards trim Left Right trim m Yaw Trim Module Action 1 Backlit LCD Stick modes indicator Remote Control Mode Selector Throttle output display i Y Diversion tips Speed trim tips Diversion trim tips R Trim indicator Yaw Trim tips backwards trim tips Battery lid PARTS AND ADD ONS TURBO BUTTON AND MODULE CONTROLS NOTE All modules shown on this page are sold separately GT3830 Camera Module GT3832 Bubble Blowing Module Camera GT3836 Retractable Winch Module Module UNUSED Bubble or Water Module During flight and while the helicopter is moving forward switch the helicopter into H mode using the Low High Speed Button and hold the turbo button to increase the speed of the Helicopter Once the button is let go the Helicopter will resume flying at normal speeds The sockets for each Add On M
10. odule sold separately is located underneath the Shell of the unit Please remove the Shell and follow the socket guide as shown above T Module Action 1 Module Action 2 The following are the actions for the available add on Modules when connected to the Helicopter Button Module Action 1 located on the top left of the remote amp bottom right of the remote GT3830 Camera Module Start Stop Video record GT3832 Bubble Blower Module Creates bubbles GT3834 Water Sprayer Module Shoots water GT3836 Retractable Winch Retracts up Each module have hooks that clip in to the bottom of the Helicopter Clip a module on to the Helicopter by guiding them through the tabs Button Module Action 2 located on the bottom right front side of remote GT3830 Camera Modules Take snap shot GT3836 Retractable Winch Extend down SELECTING REMOTE MODE AND CONFIGURATION REMOTE INFORMATION There are four different Remote Control Configurations SIE To select either mode ensure the remote is off and follow a these steps 3 Transmitter Remote Control Mode Switch Power switch 1 000 7000 Remote Control Use 4 x AA batteries alkalines are Mode Selector suggested Place battery in to the battery holder according to the polarity markings Throttle on the Right Side Mode
11. until it stops flying forward Ensure the batteries are installed in to the Remote Control Then before turning the Remote Control on move the If the Helicopter keeps going backward please adjust the trim Forward backward UP until it stops Throttle Stick to the lower point as shown Once the Throttle Stick is lowered turn the remote on Move the Throttle flying backward stick up and down then move the direction stick up down left then right This will pair the Remote to Helicopter NOTE It is important that the Helicopter is on by installing the batteries and switching it on first before attempting to turn the Remote Control on It will not pair otherwise Adjustment of Left Right Trim If the Helicopter keeps turning to the left please adjust the Yaw trim to the RIGHT until it stops turning to the left Storage a A a A Please disconnect the battery from the Helicopter and ensure the remote control is turned off with batteries remove prior to If the Helicopter keeps turning to the right please adjust the Yaw trim to the LEFT until it stops turning storing the units Or even once you have stopped playing with the unit to the right
Download Pdf Manuals
Related Search