Monty-8 user manual.indd
Contents
1. CD or SD players USB players MP3 players and linked amplifiers PAS are turned off and volume settings are set at zero Connect all devices as shown above Connect the outputs to the power amplifier s tape decks and or audio sources 9 Switch everything on in the following order audio input sources i e Microphones instruments CD players USB or SD players MP3 players last any amplifiers 10 When turning off always reverse this operation by turning off amplifiers last any input devices Oo PN o N 2 4 FEATURES O a H q 1 1 J 1 i H DDEC its INS MIC CO TAPE N i ee 888888 8 H Bm ove v M4 bh Eos LEVEL LEVEL m a MIDDLE BASS H se COG 4 H 6 1 1 Low E c H LNK 5 SOUND SYSTEM OUTPUT BATTERY LEVEL A A A A 7 8 9 10 1 Microphone 1 Balanced Input with Level Control 1 4 and XLR This jack can either take a 1 4 balanced or a XLR balanced cable An XLR Cable is inc luded with the microphone 2 Instrument Microphone 2 Input with Level Control 1 4 This mono input accepts a 1 4 input such as a microphone guitar or other musical inst rument 3 CD Tape input with Level Control Stereo RCA This knob controls the level of the CD and the RCA input This stereo RCA input can be used to connect a CD MP3 or other audio source To connect to a portable device with a2. 1 8 headphone jack you need a standard 1 8 to RCA adapter which is NOT included 4 EQUALIZATION CONTROL EQUALIZATION This is a 3 band equalizer that allows you to adjust the frequency response of the MAIN bus signal 5 Master Volume Control This knob controls the master volume of the system 6 MP3 player It has two input mode USB and SD input LCD display for the correspond input 7 Power Adapter IEC Insert the included power cable here to charge the unit Note that the system can run off the power adapter while it simultaneously charges the battery The charge indicator illum inates when the battery is charging 8 Power Switch Turns this apparatus ON OFF 3 9 Link Output This 1 4 jack can be connected to the system input of an amplifier or amplified loudspeaker such as another system 10 Battery level indicator while the unit is powered ON these four lights indicate the power left in the battery Battery life varies based on volume and usage 5 CONNECTION EXAMPLES Important with all large speakers an initial break in period is needed to perform at optimal levels To properly break in your system play an audio source at medium volume for a few hours ea o2 o K Wo To other AMP ZA Cable sold separately 4 6 IMP
3. Gall USER S MANUAL Portable PA System for MP3 MONTY 8 Please read this manual carefully and proper take care of this manual 1 IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION To reduce the risk of electric shock do not remove the top cover or the rear section No user serviceable parts inside refer servicing to qualified personnel WARNING To reduce the risk of fire or electric shock do not expose this appliance to rain and moisture This symbol wherever it appears alerts you to the presence of uninsulated dangerous voltage inside the enclosure voltage that may be sufficient to constitute a risk of shock This symbol wherever it appears alerts you to important operating and maintenance instructions in the accompanying literature Please read the manual 2 DETAILED SAFETY INSTRUCTIONS 1 Read these instructions 2 3 Keep these instructions Heed all warnings Follow all instructions Do not use this device near water Clean only with a dry cloth Do not block any ventilation openings Install in accordance with the manufacturer s instructions Do not install near any heat sources such as radiators heat registers stoves or other app aratus including amplifiers that produce heat Do not defeat the safety purpose of the polarized or grounding type plug A polarized plug has two blades with one wider than the other A grounding type plug has two b
4. ORTANT NOTE Use this troubleshooting guide if The sound is distorted at high volumes Input is clipping Try lowering the input gain or the volume control on your sound sou rce or music instrument Output is clipping Lower the main volume level There is too much bass Try adjusting the tone or EQ control on your sound source to lower bass level This will allow you to play the music louder before clipping distortion occurs The link cable is being plugged into the instrument or MIC input instead of the RCA line input 7 SPECIFICATIONS Input Voltage AC 110 120V 60Hz 220 240V 50Hz Output Wattage 8 peak 22W 10 peak 50W Output Wattage 8 RMS 15W 1 THD 10 RMS 30W 1 THD Frequency Response 70 50kHz 3dB Bottom pole mount specifications Standard Pole Mount found at professional audio retailer Depth 97mm 3 819 Diameter 37mm 1 457 Battery life Over 6 hours at full volume of the system when fully charged dimensions W x D x H 8 386x307x456mm 15 197 x 12 087 x 17 953 10 437x340x507mm 17 205 x 13 386 x 19 961 Weight 8 17 5 kg 10 22 5 NOTE Battery life may vary based on temperature age and volume usage of product 5
5. lades and a third grounding prong The wide blade or the third prong are provided for your safety Ifthe provided plug does not fit into your outlet consult an electrician for replacement of the ob solete outlet 1 10 Protect the power cord from being walked on or pinched particularly at plugs extension cords and the point at which they exit the unit 11 Only use attachments accessories specified by the manufacturer 12 Use only with the cart stand tripod bracket or table specified by the manufacturer or sold with the device When a cart is used use caution when moving the cart device combination to avoid injury from stumbling over it LAT gt 13 Unplug this device during lightning storms or when not used for long periods of time 14 Refer all servicing to qualified service personnel Servicing is required when the unit has been damaged in any way such as power supply cord or plug is damaged liquid has b een spilled or objects have fallen into the device the unit has been exposed to rain or moisture does not operate normally or has been dropped 3 INTRODUCTION FULLY CHARGE THE BATTERY BEFORE FIRST USE FOR MAXIMUM BATTERY LIFE Make sure all items READ SAFETY INSTRUCTION BOOKLET BEFORE USING THE PRODUCT MAKE SURE THAT YOU HAVE COMPLETELY CHARGED THE BATTERY Study this setup diagram Place product in an appropriate position for operation Make sure all input devices such as microphones
Download Pdf Manuals
Related Search