User Guide ControlSpace™ AMS-8 PC Kit 1. Room Control Room
Contents
1. User Guide ControlSpace AMS 8 PC Kit 1 Room Control Room Control can be used to change the source and volume settings of a room This module contains 3 displays showing 1 the selected room 2 the selected source 3 alisting of available sources and rooms depending on the button pushed When no button is pushed the third display shows the actual status of the room Audio Mode Mona input signal Volume level 2695 On Off button Settings button Pin code protected Button to open all modules Paging panel amp Presets Events only available in Multi User Mode Room select By pushing this button upper one is able to select another room to control only available in Multi User Mode Source select By pushing this button lowest one is able to select another source to listen to Minimize Close button Volume fader Move this fader to adjust the level in the room shown on the display GSE Mute Push this button to mute the source only available in Single User Mode 2 Paging Panel The paging panel can be used to page into one or more rooms zones by using a separate microphone This panel can also be used to send a pre recorded message or commercial or music track into one or more selected rooms zones only in combination with ControlSpace AMS 8 Message Storage Card Paging status Zone button Push to select a room zone button turns into green Push and hold until the button cha2. nges to red to block a room zone for paging messaging Message select Push this button to select a message listed in the Status Display Push to talk Push this button to make a page into the selected room s zone s a chime signal will be played before the microphone will be released for paging Push this button to select all zones at once Push this button to deselect all zones at once Paging Message Status display Shows the status of paging and messaging of the whole system also if the page or message is activated from another user interface e g a hardware paging panel or the ControlSpace AMS 8 Event Scheduler Paging status 3 Presets amp Events This module can be used to activate 1 Room Combining presets and 2 Events from the Event Scheduler All programmed Presets and Events will be listed in the status display the lowest display in the picture below To activate Click on 1 of the listed Presets or Events A highlighted Preset or Event indicates that these are active at the moment When a red indicator is shown in front of a Preset or Event one cannot activate this Preset or Event User disabled Presets and Events and the user ability to control these can be defined by your system installer Event 1 Standby Event apie Bane eA DA rai Event 2 F t Event m mh 4 Lert qe Exen JE Event 4 Switch Event
Download Pdf Manuals
Related Search