User Manual Optiseatset:
Contents
1. 4040 User Manual Optiseatset V1 0 12 3 2013 There is a LED on the control box that indicates whether the cushion is on or off green or red and a push button to turn the cushion on off Check whether the system is on or off e Press the push button briefly The lamp indicates whether the system is on or off Red is off green is on Switching on and off e Hold the push button for 3 seconds The LED changes colour and the system is now on or off This is also indicated by an acoustic signal 2 short beeps for on 1 beep for off When someone sits down on the cushion the LED on the control box will show the status of the system Reminder function e When the system is switched off and a client is helped out of the chair the next time the chair is used the cushion is automatically switched on after 10 seconds By default the Optiseat works as follows e Switch the system on When the client gets out of the chair a beep sounds for 4 seconds adjustable to activate the client s self correcting ability If the client does not sit down again within 4 seconds a call signal will be sent to the receiver or the pager If the client does sit down within 4 seconds the beep signal stops and nothing else happens Batteries In the Optiseat only two AA 1 5V penlight batteries may be used Battery empty notification When the batteries are almost empty the LED will flash red green eve2. the buzzer is audible until the end of the alarm delay time set with S1 and S2 lf S3 is down OFF the buzzer will only sound for one second regardless of the alarm delay time S1 S2 S3 S4 S4 eerie With the fourth switch S4 the buzzer can be switched on or off When it is switched on the buzzer is audible as set by S3 When it is switched off the buzzer is completely switched off during alarm Battery empty notification When the LED flashes red green every 5 seconds the batteries are almost empty need to be replaced If the system is on a short beep will also be sounded once every minute If you wait too long before replacing the batteries a discharged battery notification will appear on the receiver or pager When multiple Optiseat cushions are used with a single receiver the receiver does not indicate which cushion is producing the battery low signal In this case you must check all the Optiseat cushions When closing the unit make sure the LED is positioned in the corresponding opening Attention After changing the settings the Optiseat have to be switched off and on again to activate the new settings
3. ry 5 seconds If the system is switched on a beep will also be produced once every minute Changes to the default settings The technical customer service representative can change the default time settings and the length of the delay before transmission See the technical manual 4040 User Manual Optiseatset V1 0 12 3 2013 Installation Connect the receiver according to this diagram one Power adaptor Connecting cable Receiver A few seconds after the power adaptor is plugged into the wall socket the receiver switches itself on indicated by the green LED The orange button has no function in this set 4040 Technical manual Optiseatset te Opening the unit To open the unit you must remove four screws The two lower screws are located in the battery compartment Internal settings S1 S2 3 S The Optiseat has an alarm delay This is the time that the person has to sit again before the alarm will sound Four time settings are available These times can be changed upon request The standard delay times you can choose from are 1 4 10 and 255 seconds other lengths of time are optional The selection from among these 4 lengths of time is made using the first 2 switches S1 and S2 N Time 1 sec Time4sec Time 10 sec Time 255 sec S1 S2 S1 S2 es ne 255 i ull S3 ee Es With the third switch S3 the buzzer can be set If this is up ON
Download Pdf Manuals
Related Search