User's Guide - Pico Technology
Contents
1. 116 3D Probe Positioner with Universal Clamp 2 Setup While holding the probe holder loosen the central tensioning knob D until the 3D Probe Positioner can be moved Bring the 3D Probe Positioner into the desired position and lock it in place turning the central tensioning knob D With the spring tip of Pico Technology probes you can precisely set the contact to the measuring point A Do not release the central tensioning knob D completely Doing so collapses the 3D Probe Positioner and could damage your measuring setup Maintenance and Cleaning The 3D Probe Positioner requires very little maintanance However if the device is exposed to pollution regular cleaning and lubrication is required Maintanance Apply a small amount of lubricant to the screws and joints Cleaning Remove dust and dirt from the joints Use standard cleaning agents that are commercially available IN DO NOT use any type of alkali or acid to clean the 3D Probe Positioner DO175 1 3 TA116 3D Probe Positioner with Universal Clamp Pico Technology 3 Related Products and Accessories Part No Description TA115 Pico Technology 3D Probe Positioner Includes steel base span width 200mm Accessories and Spares for 3D Probe Positioners For accessories and spares visit our Support page on www picotech com and choose Sales Enquiries Contact our help desk and we will send you the required item as soon as possible Manufacturer2. P1icO Technology TA116 3D Probe Positioner with Universal Clamp User s Guide DO175 1 TA116 3D Probe Positioner with Universal Clamp Pico Technology 1 Assembly The 3D Probe Positioner is delivered in three components Base A positioner B and probe holder C components B and C are pre assembled in the TA116 scope of delivery Screw the positioner thread B1 into the base A and tighten with the enclosed wrench width across the flats is 7mm If it becomes necessary to replace the probe holder C 1 Use the enclosed wrench to release the probe holder from the positioner 2 Rotate the probe holder C anti clockwise and remove from the positioner 3 Place replacement probe holder onto the positioner thread B2 and rotate in a clockwise direction until tight 4 Tighten with the enclosed wrench to secure the probe holder to the positioner C1 pe Clamping the Probe Loosen the adjustable screw located on the probe holder C1 Place the probe into the probe holder C and tighten the adjustable screw C1 until the probe is secure If neccessary you can trim the probe holder by the means of the spring mounted set screw C2 increasing the pressure on the spring loaded probe tip This ensures a more accurate contact of the device under test and upgrades the functionality of probes with solid tips 2 DO175 1 Pico Technology TA
3. Sales amp Support PMK GmbH Pico Technology Mess und Kommunikationstechnik James House Industriestr 17 Colmworth Business Park 63150 Heusenstamm St Neots Germany PE19 8YP United Kingdom www picotech com support html Warranty Pico Technology warrants this oscilloscope accessory for normal use and operation within specifications for a period of two 2 years from date of shipment and will repair or replace any defective product which was not damaged by negligence misuse improper installation accident or unauthorized repair or modification by the buyer This warranty is applicable only to defects due to material or workmanship Pico Technology disclaim any other implied warranties of merchantability or fitness for a particular purpose Pico Technology will not be liable for any indirect special incidental or consequential damages including damages for loss of profits loss of business loss of use or data interruption of business and the like even if Pico Technology has been advised of the possibility of such damages arising from any defect or error in this manual or product Copyright 2010 Pico Technology All rights reserved Information in this publication supersedes that in all previously published material Specifications are subject to change without notice Revision History 4 DO175 1
Download Pdf Manuals
Related Search