User Manual
Contents
1. WiFi CA FullHD 1080P Manual MEDIACOM Thank you for buying the SportCam Xpro 12 HD WiFi Before start using this product please read this manual carefully to maximize its performance and extend the life of the product Appearance and Buttons 1 Shutter button 8 Micro USB port 2 Microphone 9 Mini HDMI port 3 LCD display 10 Micro SD card slot 4 Lens 11 External microphone 5 Wi Fi switch and status indicator red 12 Battery cover push switch 6 Power Mode button 13 LED light 7 Infrared signal reception light LCD Display Illustration Turn on the SportCam WiFi the LCD will display the following status and settings 0O 0O O0 1 Camera mode 2 Video recording mode default 3 Wi Fi icon display when enabled 4 Micro SD card icon display when loaded 5 Resolution icon In camera mode HI stands for 8 Mega Pixels 3264x2448 and in video recording mode it stands for FHD 1920x1080 30fps In camera mode LO stands for 5 Mega Pixels 2592x1920 and in video recording mode it stands for 720P 1280x720 30fps HILO only displays in video recording mode standing for 720P 1280x720 60fps Mute mode displays when enabled and disabled by default Counter displays up to 999 8 Timer displays hours and minutes 9 Battery icon current battery level of the camera Note The above icons may vary according to the status of the SportCam WiFi Working Mode Flow Chart After t2. the screen press nO repeatedly until it appears Dion o Start recording Press and release the button the icon and displayed on the LCD will flash At the same time the red indicator flashes indicating the recording is in process ma Stop recording Press and release Don the icon hna displayed on the LCD will stop flashing At the same time the red indicator will stop flashing either indicating the recording is stopped When the Micro SD card is full or the battery is drained the recording will stop automatically and the recorded video will be saved before the SportCam WiFi turns off 11 2 o Photo To take a photo please check whether the SportCam WiFi is set to the Camera mode If the icon o is not displayed on the screen press button repeatedly until it appears Press and release the button the camera will beep and the red indicator will flash when a photo was taken Please note The LCD screen can only display up to 999 3 Enable disable WiFi The WiFi is disabled by default Press the WiFi button on the side of the SportCam WiFi to enable it When starting connecting to WiFi network the indicator will flash and when a WiFi network is connected the indicator will remain on The WiFi icon will be displayed on the LCD screen In order to save power WiFi will be automatically disabled if no terminal is connected after 30 seconds 4 Enable disable Mute mode The buzzer is enabled by default I
3. Camera preview Bes ih ih 1 Video resolution 2 White balance 3 Setup enter setup menu 4 Enter Playback mode 5 Shutter button 23 6 Photo mode 7 Video mode 8 WiFi signal icon 9 SportCam WiFi battery icon 3 iOS APP 3 1 Install SYMAGIX APP available at the App store on your iOS phone or tablet When the installation is e completed the LCD will displaythe following icon SYMAGIX 3 2 Insert the Micro SD card and turn on the SportCam WiFi then press the WiFi button to enable it Now you can see the WiFi icon on the LCD 3 3 Enable Wi Fi on your iOS phone or tablet and search for wireless AP signal SportCam_WIFI then connect it with the SportCam WiFi When connected the screen states Connected successfully Note The first time connecting to SportCam WiFi you need to enter password 1234567890 K ooo 3 4 Click the icon SYMAGIX in the App list of the iOS phone or tablet to open it Now you can preview the image 24 sent by the S 40 WiFi to the phone or tablet The operation interface on terminal is shown in the following figure 1 SportCam WiFi battery icon 2 Video resolution 3 White balance 4 Setup enter setup menu 5 Enter Playback mode 6 Shutter button 7 Photo mode 8 Video mode Note 1 A Micro SD card must be inserted if you want to take a photo record a video or download files to the terminal 2 The WiFi indicator will remai
4. he camera was turned on you can press the Power Mode button to switch the following modes in turn Video preview mode 1080P default Video mode 720P 30fps Video mode 720P 60fps Camera mode SMP Camera mode 5MP In video mode press the Shutter button to start recording LED flash and press it again to stop In camera mode press the Shutter button to take photo 4 Use your SportCam WiFi When you use the Action Camera for the first time please 1 Insert a micro SD or micro SDHC card as shown in the following picture A Class 4 High speed card is recommended When using the time delay function or recording video in professional mode a Class 10 Memory Card is required Turn off the camera before inserting or removing the card 2 Use the battery 2 1 Install the battery Please install the lithium battery correctly as shown in the following graphic As shown in figure 2 and figure 3 6 Step 3 Install the battery cover back in place and lock the switch to the lock position to fix the battery as shown in figure 4 2 2 Charging the battery The SportCam WiFi uses removable rechargeable lithium battery When the SportCam WiFi is off connect it to the PC via USB cable to charge the battery During charging the status indicator blue will light and goes off when the battery is fully charged Note The battery will not charge while the camera is on and connected to the PC Tu
5. ion You can use the remote controller to record videos take photos and shut down the SportCam WiFi When using 19 the remote controll aim the signal emission port to the infrared signal reception light of the SportCam WiFi and press the video button photo button or power off button Infrared signal reception light 20 APP support Android and iOS 1 How to install the APP printed on the gift box to find the APP and install it according to the instruction 1 2 Search for gt SYMAGIX in APP Store for iOS or scan the QR code 2 Android APP 2 1 Install SYMAGIX APP provided by at the App Store on your smart phone or tablet When the installation is K S completed the LCD will display the following icon symac x 2 2 Insert the Micro SD card and turn on the SportCam WiFi then press the WiFi button to enable it Now you 21 can see the WiFi icon on the LCD 2 3 Enable WiFi on smart phone or tablet and search for wireless AP signal SportCam_WIFI then connect it with the SportCam WiFi When connected the screen states Connected successfully Note The first time connecting to SportCam WiFi you need to enter password 1234567890 K 2 4 Click the icon SYMAGIX in the App list of the Android phone or tablet to open it Now you can preview the image sent by the SportCam WiFi to the phone or tablet The operation interface on terminal is shown in the following figure 22
6. n on when the terminal is connected to the SportCam WiFi Waterproof Case Before sealing the waterproof case keep the camera housing s rubber seal clean a single hair or grain of sand can cause a leak You can test by closing the case without inserting the camera Submerse the case completely in water for about one minute Remove the case from the water dry off its exterior with a towel and then open the case If the interior is dry the case is safe for use under water After use in salt water you will need to rinse the outside of the housing with fresh water and dry it This will prevent corrosion of the hinge pin and salt buildup in the seal which can cause failure To clean the seal rinse in fresh water and shake dry drying with a cloth may cause lint to compromise the seal Re install the seal into the grooves in the backdoor of the housing 26
7. n the Video or Photo mode press and hold the Shutter button to disable the L 1 buzzer and indicator to enter Mute mode In Mute mode the icon will be displayed on the screen press and hold the Shutter button again to exit Mute mode Buzzer is enabled by default When Mute mode is enabled 13 the Mute icon will be displayed on the LCD 5 Connecting to HDTV 5 1 Connect the SportCam WiFi to a HDTV via HDMI cable optional If you want to playback picturs videos or audio records to a HDTV connect the Com end of the HDMI cable to the SportCam WiFi and the other end output to the HD input of the HDTV as shown in the following figure fh a0 HDMI cable 3 HDMI cable 14 Note Before connecting or removing the HDMI cable please stop video recording playback and disconnect WiFi first 5 2 When the camera is connected to a HDTV the LCD screen will show following 1 _ 2 3 Playback mode Camera is in Playback mode currently 2 File number There are 31 files and you view Picture number 19 15 In Playback mode press the Power uno O to switch between photos and videos When there are several S j J N photos or videos press the WiFi button to select the desired photo or video When a video file is selected press the Shutter D to start the playback and press the Shutter button again to stop playing In Playback mode press and hold the Shutter a a prompt of deleting the file o
8. r formatting will appear Press the WiFi button to switch between deleting or formatting then Press the Power button to select Yes or No and press the Shutter D to confirm and exit 16 Foramt Select Enter DY 10 wel 11 161 6 Connecting to PC 6 1 Turn on the SportCa WiFi and connect it to the USB port of the PC via the attached USB cable The SportCam WiFi will enter U disk mode and the LCD will indicates following PLU Now you can view the photos or videos taken by SportCam WiFi on PC 17 Note After the SportCam WiFi is connected to a PC to enter U disk mode you will see two removable disks displayed at My computer of Windows one is the Micro SD card storing all the photos taken and video recorded by users the other one stores the system file information including a file named SSID_PW CFG containing the AP ID of the and the password for AP login Users can view this information but cannot modify delete or format it 6 2 In U disk mode PCU mode press the Shutter va to switch to web cam mode PCC mode The LCD will indicated following PLL Now you can start the web cam through application To return to U disk mode PCU mode press 18 oO button again Note Driver is not required for web cam mode PCC mode on Windows XP SP3 version or above Remote Controller Application Power off button Buttons Video button Signal emission port _ Photo button Instruct
9. rn on off 1 Turn on press and hold for about 3 seconds LCD displays ON and the camera beeps z on A 2 Turn off press and hold for about 3 seconds LCD displays OFF and the camera beeps w OFF 4 Note The SportCam WiFi will turn off automatically if it is idle for 5 minutes 8 Start to Use Default setting The camera will starts with following default settings EDO snes snom Ts sana ann Stk Battery level Battery is full The SportCam WiFi is in Mute mode no Beep will be heard Mute icon when pressing the buttons It displays only when Mute mode is activated Record modes The SportCam WiFi provides different record modes Press the button several times to switch to the different modes The following first two modes will be show on the SportCam WiFi screen and other modes available on the APP operation HI stands for FHD 1920x1080 30 fps video Video Lo stands for 720P 1280x720 30 fps video HILO stands for 720P 1280x720 60 fps video o pact HI stands for 8M 3264 x 2448 resolution oto Lo stands for 5M 2592 x 1920 resolution 10 The SportCam WiFi supports taking 3 photos continuous C1 Continuous shot ps PP BoP y only via App gu In self timer mode you can set Os 2s or 10s only via App 1 l Video EE lt i To record a video please check whether the SportCam WiFi is set to the Video mode If the icon is not displayed on
Download Pdf Manuals
Related Search